Search

According to the first project using SVC to mitigate SSO in China, this paper builds the system model based on real time digtal simulator,and gives an introduction to the sysem model. Under typical operation mode and fault conditions,the performance of SVC is fully validated,it also analysis and comparise the performance of SVC under different operation modes. Simulation results show that the SVC can mitigate the SSO phenomenon.

Regular line and circle arry micro-apparatus on 65Mn plate formed by femtosecond direct writting with wavelength of 800 nm, repetition rate of 1 kHz and the pulse length of 130fs in air. Investigate the effect of pulse energy and scan speed. Found, that the increased scan speed was similar to the decreased pulse energy. Due to the circle pattern was different to the line process, the contrary phenomenon appeared, which with increased ablation energy, the width of groove was less and the depth was increased.

Regular micro-apparatus which covered with periodic nano-hole, nano-ridge and ripple structures on silicon bulk were formed by laser micro-machining with tightly focused beam of the femtosecond laser with wavelength of 800 nm, repetition rate of 1 kHz and the pulse length of 130 fs in air. The periodic nano-hole structures which focus with a 20× focusing objective lens (NA = 0.4) is reported. Investigating the relationship between the width of structures and the speed of processing.

An aqueduct of larger-span prestressed concrete arch structure for river diversion project is located in coastal areas, and raises difficult questions on deformation and stability control of the construction process due to greater wind load and poor soil. Due to the limited width of bracket erection, this paper put forward five possible construction schemes, and does the comparative analysis using three-dimensional finite element program, and gets the economic and reasonable one. Finally conduct a pressure test after the bracket erection, and verify the analysis results using measured stress and deformation data.

With femtosecond laser pulse (130 fs, 800 nm, 1 kHz pulse repetition frequency) irradiation on Au/Cr film stack, several nanostructures were obtained. The influence of laser parameters such as fluence(0.5J/cm2,2J/cm2) and the number of pulse were investigate. With single pulse irradiation, the nanoline and periodic ripple structures were obtained for the pulse fluence of 0.5J/cm2 and 2J/cm2, respectively. The formation mechanism of those nanostructures were discussed.

The plasma was generated by focusing a pulsed Nd:YAG laser at 1064nm and 10ns on the surface of ITO. We investigated the relationship between the signal intensity of LIBS and the pulse energy of laser, and found the signal of the analyze lines of In and Sn increased with the laser energy enhanced proportional. A series of measurements were made to found the optimum time delay between the laser pulse and the beginning of the LIBS spectra acquisition. Through calibration-free method we obtain the temperature of plasma,at the same time we measured the content of In and Sn by the program which writed with matlab.

The periodic microstructures on 65Mn plate were induced by the irradiation of the femtosecond laser with the laser wavelength of 800 nm and the pulse length of 130 fs. The parallel periodic ripples structures were observed at the laser fluence of 1 J/cm2 with different pulses number( N=5,50,400,800) which lied parallel to the laser electric polarization field vector. For 400 pulses, the nano-holes arrays were generated to interrupt the consistent ripples structures.For 800 pulses, initial nano-holes evolution to the grooves, which the direction were uncertainly. Further experiments have been made to induce large area consitent ripple structures by scanning, at the laser fluence of 1 J/cm2 with speed v=500μm/s. 2D arrays were induced by accurate processing control

We calculate the temperature of excited plasma, found that will be enhanced with pulse energy increased. The delay time and the pulse energy were very important to the LIBS signal and define the -0.5μs was very suitable to this experiment, determined the intensity of emission spectra was linear to the pulse energy when the delay time was fixed. By change the delay time, got the emission of bivalence ionization of Zn was just less than 500ns.At last, we had researched the effect of element concentration and the thickness of film on signal intensity. When the concentration of Al being increased from 2.5% to 5%, the intensity of signal enhanced double. At the same time the content of Zn being decreased from 78% to 76%, the intensity of signal had just no change.

e15106 Background: Despite the availability of multiple treatment strategies, patients with gastric carcinoma (GC) have a dismal prognosis. Cellular immunotherapy (CIT) with multiple autologous non...

AIM: To apply a new, integrated technique for visualizing bacterial genomes to identify novel pathogenicity islands in Helicobacter pylori (H. pylori). METHODS: A genomic barcode imaging method (converting frequency matrices to grey-scale levels) was designed to visually distinguish origin-specific genomic regions in H. pylori. The complete genome sequences of the six H. pylori strains published in the National Center for Biotechnological Information prokaryotic genome database were scanned, and compared to the genome barcodes of Escherichia coli (E. coli) O157:H7 strain EDL933 and a random nucleotide sequence. The following criteria were applied to identify potential pathogenicity islands (PAIs): (1) barcode distance distinct from that of the general background; (2) length greater than 10000 continuous base pairs; and (3) containing genes with known virulence-related functions (as determined by PfamScan and Blast2GO). RESULTS: Comparison of the barcode images generated for the 26695, HPAG1, J99, Shi470, G27 and P12 H. pylori genomes with those for the E. coli and random sequence controls revealed that H. pylori genomes contained fewer anomalous regions. Among the H. pylori-specific continuous anomalous regions (longer than 20 kbp in each strain’s genome), two fit the criteria for identifying candidate PAIs. The bioinformatic-based functional analyses revealed that one of the two anomalous regions was the known pathogenicity island cag-PAI, this finding also served as proof-of-principle for the utility of the genomic barcoding approach for identifying PAIs, and characterized the other as a novel PAI, which was designated as tfs3-PAI. Furthermore, the cag-PAI and tfs3-PAI harbored genes encoding type IV secretion system proteins and were predicted to have potential for functional synergy. CONCLUSION: Genomic barcode imaging represents an effective bioinformatic-based approach for scanning bacterial genomes, such as H. pylori, to identify candidate PAIs.