Search

Context As a well-known traditional Chinese medicine for protecting the liver, the mechanism of Radix Gentianae (RG) remains unclear. Objective The hepatoprotective effect and metabonomics of RG were studied to explore the molecular and metabolic mechanisms of RG protecting the liver. Materials and methods Sprague-Dawley rats were divided into control and model group (n = 10, orally given distilled water), intervention group (4 subgroups, n = 10, prophylactically and orally given 0.63, 2.5 and 5.6 g/kg RG and 0.2 g/kg bifendatatum for 7 d). On day 7 of the intervention, all rats except the control were injected intraperitoneally with 2.5% carbon tetrachloride vegetable oil solution (1.5 mL/kg) to induce liver injury. After 24 h of carbon tetrachloride injection, rat serum and liver tissue were collected for determining AST, ALT, TNF-α, MCP-1, IL-6, SOD, MDA, GSH, and GSH-PX. Rat serum was used for analysing endogenous metabolism by UPLC-Q-TOF-MS. Results Different doses of RG can significantly decrease the levels of AST, ALT, TNF-α, MCP-1, IL-6 and MDA, and increase the levels of SOD, GSH, and GSH-PX in rats with liver injury (p

Process assessment experiment was conducted to investigate the applicability of integration technology (CCI, concentration, cooling and ion exchange) to manufacture sodium-free lithium chloride from salt lake brine. The preliminary separation process of sodium from brine, using evaporating concentration by adding surfactant, showed the amount of sodium in brine decreases to below 0.187%. Then, brine was further cooling separation process which was characterized in that the ammonia is added in order to decrease the solubility of NaCl. The purification of lithium chloride from cooling brine was then conducted with a novel separation process which was designed by a novel ion exchange method using inorganic ion-exchanger Li 1.4 Cr 0.4 Ti 1.6 (PO 4 ) 3 . The total yield of LiCl with the present purification process was 86.16%, and the sodium concentration in the supernatant is 0.0005 wt.%.

Prussian Blue type Na2MnFe(CN)6 was prepared by direct precipitation method and a subsequent drying procedure as a cath-ode material for aqueous rechargeable sodium-ion batteries. XRD patterns showed that Na2MnFe(CN)6 has a typical Prussian Blue struc-ture with space group Fm3m. Na2MnFe(CN)6 presents good electrochemical behaviors at 10 mAg-1 discharge current density with specific capacity 73.1 mAhg-1 after 30 cycles. The results show that Na2MnFe(CN)6 could be a potential cathode material for aqueous Sodium-ion battery.

A simple method that consumes low organic solvent is proposed for the analysis of phthalic acid esters in Chinese white spirit using dispersive liquid-liquid microextraction coupled with sweeping-micellar electrokinetic chromatography. Tetrachloromethane and white-spirit-containing ethanol were used as the extraction and dispersing solvents, respectively. The electrophoresis separation buffer was composed of 5 mM β-cyclodextrin, 50 mM sodium dodecyl sulfate and 25 mM borate buffer (pH 9.2) with 9% acetonitrile, enabling the baseline resolution of the analytes within 13 min. Under the optimum conditions, satisfactory linearities (5-1000 ng/mL, r ≥ 0.9909), good reproducibility (RSD ≤ 6.7% for peak area, and RSD ≤ 2.8% for migration time), low detection limits (0.4-0.8 ng/mL) and acceptable recovery rates (89.6-105.7%) were obtained. The proposed method was successfully applied to 22 Chinese white spirits, and the content of dibutyl phthalate in 55% of the samples exceeded the Specific Migration Limit of 0.3 mg/kg established by the domestic and international regulations.

A selective and low organic-solvent-consuming method of sample preparation combined with high-performance liquid chromatography with diode-array detection is introduced for analysis of phthalic acid esters in edible oils. Sample treatment involves initial liquid–liquid partitioning with acetonitrile, then QuEChERS cleanup by dispersive solid-phase extraction with primary secondary amine as sorbent. Preconcentration of the analytes is performed by ionic-liquid-based dispersive liquid–liquid microextraction, with the cleaned-up extract as disperser solvent and 1-hexyl-3-methylimidazolium hexafluorophosphate as extraction solvent. Under the optimized conditions, correlation coefficients (r) were 0.998–0.999 and standard errors (S y/x ) were 2.67–3.37 × 103 for calibration curves in the range 50–1000 ng g−1. Detection limits, at a signal-to-noise ratio of 3, ranged from 6 to 9 ng g−1. Intra-day and inter-day repeatability, expressed as relative standard deviation, were in the ranges 1.0–6.9 % and 2.4–9.4 %, respectively. Recovery varied between 84 % and 106 %. The developed method was successfully used for analysis of the analytes in 28 edible oils. The dibutyl phthalate content of four of the 28 samples (14 %) exceeded the specific migration limit established by domestic and international regulations.

A very simple, sensitive, and reliable method for the routine determination of riboflavin in cereal grains by capillary electrophoresis with laser-induced fluorescence detection (CE-LIF) was established. Two on-line concentration techniques, namely, stacking in reverse migrating micelles (SRMM) and sweeping, were examined to enhance the detection signal. The optimum separation buffer consisted of 20 mM phosphoric acid and 140 mM sodium dodecyl sulfate (SDS), and a hydrodynamic injection of 30 s at 0.5 psi was confirmed for the introduction of a sample. In addition, it was found that salt in sample matrix influenced the performance of SRMM, showing the standard addition method was required for the quantitative analysis. The linearity of the method was good with a range of 0.5–500 ng/mL (r = 0.9990). The limit of detection (LOD) was 0.29 ng/mL at a signal-to-noise ratio of 3. This procedure presented was successfully applied to determine riboflavin in 18 samples of 9 types of cereal grains. The recovery rat...

This paper describes a simple, sensitive and environmentally benign method for the direct determination of aniline and its derivatives in environmental water samples by capillary zone electrophoresis (CZE) with field-enhanced sample injection. The parameters that influenced the enhancement and separation efficiencies were investigated. Surprisingly, under the optimized conditions, two linear ranges for the calibration plot, 1–50 ng/mL and 50–1000 ng/mL (R > 0.998), were obtained. The detection limit was in the range of 0.29–0.43 ng/mL. To eliminate the effect of the real sample matrix on the stacking efficiency, the standard addition method was applied to the analysis of water samples from local rivers.

Orthosilicate MgMnSiO4 was prepared by sol-gel route and a subsequent heating procedure as a cathode material for rechargeable magnesium batteries. XRD patterns showed that MgMnSiO4 has a orthorhombic system with space group Pbnm(62). MgMnSiO4 presents good electrochemical behaviors at 10 mAg-1 discharge current density with specific capacity 130.1 mAhg-1 after 20 cycles. The results show that MgMnSiO4 could be a potential cathode material for high-energy magnesium secondary battery.

In this study, two novel sample extraction methods for the analysis of bisphenol A (BPA) in edible oils were developed by using liquid–liquid extraction followed by a dispersive liquid–liquid microextraction (LLE-DLLME) and reversed-phase dispersive liquid–liquid microextraction (RP-DLLME). RP-DLLME showed a superior characteristic over LLE-DLLME and other previously reported procedures because of its easy operation, short extraction time, high sensitivity, low organic solvent consumption and waste generation. The optimized extraction conditions of RP-DLLME for 1.0 g of edible oil diluted in 4 mL of n-hexane were: extractant, 100 μL 0.2 M sodium hydroxide solution (80% methanol, v/v); extraction time, 1 min; centrifugation, 3 min. The determination of BPA was carried out by high performance liquid chromatography coupled with a DAD detector. The method offered excellent linearity over a range of 0.010–0.5 μg g −1 with a correlation coefficient of r > 0.997. Intra-day and inter-day repeatability values expressed as relative standard deviation were 1.9% and 5.9%, respectively. The quantitation limit and detection limit were 6.3 and 2.5 ng g −1 . The target analyte was detected in 5 out of 16 edible oil samples. The recovery rates in real samples ranged from 89.5 to 99.7%.

A series of Ag–Pd/C catalysts with different Ag/Pd molar ratios were prepared by impregnation and characterized by N2 adsorption and XPS. The catalytic performance was investigated in the hydrodechlorination of carbon tetrachloride into chloroform. High selectivity toward chloroform, near 100%, was obtained over Ag–Pd/C bi-metal catalysts. A very pronounced surface enrichment with Ag in Ag–Pd/C catalysts determined by XPS may be responsible for the high selectivity of chloroform. It is suggested that hydrodechlorination of carbon tetrachloride into chloroform occurs on the surface of Ag in the Ag–Pd alloy and the role of Pd is to supply H atoms necessary.