Search

The characteristics of one-port aluminum nitride (AlN) Lamb wave resonators utilizing the lowest-order symmetric mode with electrically open, grounded, and floating bottom electrode configurations are theoretically and experimentally investigated in this paper. Finite element analysis is performed to take an insight into the static capacitance characteristics of the AlN Lamb wave resonators with various bottom surface conditions. Without sacrificing the transduction efficiency, the floating bottom electrode is capable of reducing the static capacitance in the AlN thin plate and then promotes an efficient improvement in the effective coupling coefficient (k2eff). In addition, in comparison with the grounded bottom electrode, the employment of the floating bottom electrode offers simple fabrication processes for the micromachined Lamb wave resonators. Experimentally, the AlN Lamb wave resonators without the bottom electrode exhibit an average loaded quality factor (Q) as high as 2676 at the series resonance frequency, but a low average k2eff of 0.19%. On the contrary, the Lamb wave resonators with the electrically floating bottom electrode show the largest average k2eff up to 1.13% among the three topologies but a low average loaded Q of 800 at the series resonance frequency. In contrast to the floating bottom electrode, the Lamb wave resonators with the electrically grounded bottom electrode show a smaller average k2eff of 0.78% and a similar average loaded Q of 758 at the series resonance frequency. [ABSTRACT FROM AUTHOR]

This study lays a foundation for the design of the SH 0 plate acoustic wave (PAW) resonators based on LiNbO 3 plate, and are applicable to the ultra-wideband filters and next-generation tunable filters. The coupling coefficient ( k 2 ) of SH 0 mode is optimized to as high as 55% and wideband spurious are well controlled by analyzing the propagation characteristics of plate modes in LiNbO 3 . The SH 0 mode is demonstrated to be slowly dispersive and features the superiority of interdigital transducer (IDT)-defining frequency over most other plate modes. On the device level, the transducer types and electrode materials are investigated and compared. In addition, for edge-reflected SH 0 resonators, stopband dispersion analysis is provided and the longitudinal ripples are suppressed. For edge-reflected SH 0 resonators, a novel perfect edge reflector is proposed with elimination of longitudinal spurious ripples.

Improved performance thin-film plate acoustic wave resonators (FPAR) using the lowest order symmetric Lamb wave (S0) propagating in highly textured AlN membranes have been previously demonstrated for the first time. In this work, an experimental study of the resonators' performance vs. a variety of design parameters is performed. Devices operating in the vicinity of the stopband center exhibiting a Q-value of up to 3000 at a frequency of around 875 MHz are demonstrated. Further, low-loss high-Q micromachined 2-port longitudinally coupled thin-film resonators using the S0 mode are demonstrated for the first time. For the analysis of the proposed structures, the coupling-of-modes (COM) approach is successfully employed. Initially, the COM model is used for the extraction of physical parameters from one-port FPAR measurements. Subsequently, using the COM model, a satisfactory agreement with the proposed experimental frequency characteristics of S0 2-port FPARs has been achieved, and possibilities for further improvements in the performance discussed. Finally, the frequency spectrum of the one-port devices has been studied and the excited plate modes at different frequencies identified and presented with their Q-factors and temperature coefficients of frequency (TCF).