Search

The main objective of this study is the evaluation of RPPW anaerobic digestion feasibility at laboratory scale under Mesophilic condition. The experiment is conducted using a two-stage biofilm digester of 5 L capacity with mobile support material. Anaerobic treatment of wastewater from recycled pulp and paper industry in Morocco was tested using a laboratory-scale anaerobic biofilm digester that operated under mesophilic conditions over a 70-day. Chemical oxygen demand (COD) efficiency, volatile and total solid (VS, TS) elimination of the substrate during the process were: 78%, 52% and 48% respectively. The system was stable throughout its operating cycle with an optimum pH (7.24), alkalinity (1750 mg CaCO3/L) and a volatile fatty acid value (760 mg/L). The experimental daily biogas production measured reaches a value of 5 L/day with a composition of 71% methane, 27.6% carbon dioxide, 0.2 oxygen and 7713 ppm of the H2S. The study results show that the anaerobic biofilm reactor is a suitable technique for recycled pulp and paper wastewater (RPPW) treatment. The reactor shows high performances in terms of process stability, removal efficiency (> 70%) and biogas production. Anaerobic digestion is an efficient waste treatment technology that uses natural anaerobic decomposition to reduce the volume of waste while producing biogas. However, research is needed to strengthen microbial metabolism, biochemistry and the functioning of the rector to improve biogas production. The RPPW AD experiment with biofilm digester technology was stable throughout the operation period. The digester knows an overloaded in the last phase of the experiment which leads to an inhibition of biogas production.

Nowadays, thanks to nanotechnological progress, which itself guides us more and more closely toward not only the efficient design of innovative nanomaterials or nanostructures, but to the improvement of their functionality, we benefit from an important asset in the battle against pathogenic illnesses. Herein, we report a versatile biocompatible plasmonic nanoplatform based on a Whatman paper incorporating positively-charged gold nanospherical particles via the immersion approach. The morphological characterization of the as-engineered-plasmonic paper was examined by SEM (scanning electron microscopy) and HRTEM (high-resolution transmission electron microscopy) investigations, while its surface chemical modification with a synthetic polypeptide, specifically RRWHRWWRR-NH2 (P2), was proved by monitoring the plasmonic response of loaded gold nanospheres and the emission signal of P2 via fluorescence spectroscopy. The as-functionalized plasmonic paper is non-cytotoxic towards BJ fibroblast human cells at bactericidal concentrations. Finally, the antimicrobial activity of the P2-functionalized plasmonic paper on both planktonic bacteria and biofilms was tested against two reference strains: Gram-positive Bacteria, i.e., Staphylococcus aureus and the Gram-negative Bacteria, i.e., Escherichia coli, determining microbial inhibition of up to 100% for planktonic bacteria. In line with the above presented nanoplatform&rsquo, s proper design, followed by their functionalization with active antimicrobial peptides, new roads can be open for determining antibiotic-free treatments against different relevant pathogens.

Secondary effluent from paper mill was characterized by poor biodegradability and containing recalcitrant compounds. In this study, four bioreactors, including a sequencing batch biofilm reactor (SBBR), a stirred-tank reactor (STR) and two submerged aeration reactors (SAR) were used to treat secondary effluent from a recycled paper mill respectively. The results indicated that chemical oxygen demand (COD) was increased by SAR2 treatment and COD removal efficiency for SBBR, SAR1 and STR was 39.7%, 15.7% and 30.9% respectively. It is suggested that recalcitrant compounds were removed by SBBR, SAR1 and STR respectively. Total nitrogen (TN) and total phosphorus (TP) of wastewater were increased by treatments of each bioreactor, which suggested that endogenous respiration of biomass occurred during the treatment. Microbial analysis of sludge from different bioreactors suggested that the removal of recalcitrant compounds in SBBR and STR might be related to the presence of unique microorganisms in each reactor.

The goal of this work is to pursue analytical approaches that elucidate electron and proton diffusion inside the Shewanella oneidensis biofilm and bulk liquid, which will inevitably promote the translation of Microbial Fuel Cell (MFC) technology for renewable, "green energy" solutions that are in demand to sustain the world's ever-increasing energy demands and to mitigate the depletion of current resources. This study provides a novel strategy for monitoring electron/proton fluxes in 3-D multi-laminate structures of paper as a scaffold to support S. oneidensis biofilms and bulk media liquid. Multiple layers of paper containing bacterial cells and/or media are stacked to form a layered 3-D model of the overall biofilm/bulk liquid construct. Mass transport of electrons and protons into this 3-D system can be quantified along with the exploration of microbial energy production. Assembly of a 3D paper stack can be modular and allows us to control the thickness of the overall biofilm/bulk liquid construct with the different diffusion distances of the electrons/protons through the stack. By measuring the current generated from the 3-D stack, the electron and proton diffusivity through biofilms were quantitatively investigated. We found that (i) the diffusion length of the electrons/protons in the S. oneidensis biofilm/bulk liquid is a determinant factor for the MFC performance, (ii) the electron transfer through the endogenous mediators of S. oneidensis can be a more critical factor to limit the current/power generation of the MFCs than the proton transfer in the MFC system and (iii) the thicker biofilm allows higher and longer current generation but requires more time to reach a peak current value and increases the total energy loss of the MFC system.

Biofilm formation is a major cause of reduced paper quality and increased down time during paper manufacturing. This study uses Illumina next‐generation sequencing to identify the microbial populations causing quality issues due to their presence in biofilms and slimes. The paper defects investigated contained traces of the films and/or slime of mainly two genera, Tepidimonas and Chryseobacterium. The Tepidimonas spp. found contributed on average 68% to the total bacterial population. Both genera have been described previously to be associated with biofilms in paper mills. There was indication that Tepidimonas spp. were present as compact biofilm in the head box of one paper machine and was filtered out by the paper web during production. On the other hand Tepidimonas spp. were also present to a large extent in the press and white waters of two nonproblematic paper machines. Therefore, the mere presence of a known biofilm producer alone is not sufficient to cause slimes and therefore paper defects and other critical factors are additionally at play. For instance, we identified Acidovorax sp., which is an early colonizer of paper machines, exhibiting the ability to form extracellular DNA matrices for attachment and biofilm formation.

Sugar-rich diets and poor dental hygiene promote the formation of a biofilm (plaque) that strongly adheres to the dental enamel surface and fosters the evolution of aciduric bacteria. The acid contributes to demineralization of the exterior tooth enamel, which accelerates after the pH drops below a critical value (∼5.5) for extended time periods resulting in the need for restorative procedures. Preventative techniques to alert the dentist and caries-susceptible patients regarding vulnerability to dental decay require a clinical measure of plaque activity. Therefore, there is a need to evaluate the acid production capability of plaque deposits in the pits and fissures of occlusal and interproximal regions. A ratiometric fluorescence pH-sensing device has been developed using an FDA-approved dye and LED excitation. Fluorescein spectral profiles were collected using a spectrometer and analyzed with a spectral unmixing algorithm for calibration over the pH range of 4.5 to 7. An in vivo pilot study on human subjects was performed using a sucrose rinse to accelerate bacterial metabolism and to measure the time-dependent drop in pH. The optical system is relatively immune to confounding factors such as photobleaching, dye concentration, and variation in excitation intensity associated with earlier dye-based pH measurement techniques.

Fungi produce pigments and acids, generating particular local conditions which modify the physicochemical properties of materials. The aims of this work are (i) to investigate bioadhesion, foxing production and biofilm formation by Scopulariopsis sp. and Fusarium sp. isolated from document collections under laboratory conditions; (ii) to verify attack on cellulose fibres and (iii) to study the possibility of reducing fungal growth using natural products. Biofilm formation and extracellular polymeric substance (EPS) production by fungi were demonstrated in laboratory assays and by scanning electron microscopy (SEM) observations. The biocidal activity of two essential oils of Origanum vulgare L. and Thymus vulgaris L. was evaluated using the microatmosphere method. SEM observations showed that these strains were able to attach to paper and form biofilms, causing damage on them, which demonstrates the biodeterioration ability of these microorganisms. Scopulariopsis sp. and Fusarium sp. isolated from paper books showed the formation of fox-like reddish-brown colour spots, attack to the paper structure and pigment production on aged paper samples. The strains tested produced a decrease in the pH of one unit. This would substantiate the effect of the strains in paper biodeterioration. The microatmosphere method showed that volatile compounds of the essential oils have antifungal activity., Instituto de Investigaciones Fisicoquímicas Teóricas y Aplicadas, Facultad de Ciencias Veterinarias, Facultad de Ciencias Naturales y Museo

Qi Wang,1 Philip Larese-Casanova,2 Thomas J Webster3,41Department of Bioengineering, College of Engineering, Northeastern University, Boston, MA, USA; 2Department of Civil and Environmental Engineering, College of Engineering, Northeastern University, Boston, MA, USA; 3Department of Chemical Engineering, College of Engineering, Northeastern University, Boston, MA, USA; 4Center of Excellence for Advanced Materials Research, King Abdulaziz University, Jeddah, Saudi ArabiaAbstract: There are wide spread bacterial contamination issues on various paper products, such as paper towels hanging in sink splash zones or those used to clean surfaces, filter papers used in water and air purifying systems, and wrappings used in the food industry; such contamination may lead to the potential spread of bacteria and consequent severe health concerns. In this study, selenium nanoparticles were coated on normal paper towel surfaces through a quick precipitation method, introducing antibacterial properties to the paper towels in a healthy way. Their effectiveness at preventing biofilm formation was tested in bacterial assays involving Staphylococcus aureus, Pseudomonas aeruginosa, Escherichia coli, and Staphylococcus epidermidis. The results showed significant and continuous bacteria inhibition with about a 90% reduction from 24 to 72 hours for gram-positive bacteria including S. aureus and S. epidermidis. The selenium coated paper towels also showed significant inhibition of gram-negative bacteria like P. aeruginosa and E. coli growth at about 57% and 84%, respectively, after 72 hours of treatment. Therefore, this study established a promising selenium-based antibacterial strategy to prevent bacterial growth on paper products, which may lead to the avoidance of bacteria spreading and consequent severe health concerns.Keywords: selenium nanoparticles, paper towels, antibacterial

A stainless steel paper-embedded biofilm reactor (PEBR) was developed for Candida spp. growth, permitting confluent distribution of nutrients by capillary diffusion through ordinary laboratory filter paper. Antibiogram disks were distributed along the filter paper rim, and the PEBR received 0.1 or 0.01 % crystal violet (CV) at 200 μL min(-1) and at 37 °C, for 48 h. CV was recovered from the disks and measured at 540 nm. Candida albicans SC5314 cells were applied onto antibiogram disks. The bioreactor was assembled, and YEPD broth was admitted (200 μL min(-1)) at 37 °C, for 72 h. Biofilm growth was estimated via the MTT reduction test. Controls were disks that received the same treatments, except for the fungus. The PEBR was considered high-throughput table, low-cost, and feasible to grow C. albicans biofilms.

This work was partially supported by the Portuguese Science Foundation (FCT-MEC) through the projects EXCL/CTM-NAN/0201/2012, Pest-C/CTM/LA0025/2013-14, Pest-C/EQB/LA0006/2013-14, PTDC/BBB-BEP/0753/2012 and the ERC Advanced Grant (INVISIBLE, contract number 228144). Geobacter sulfurreducens cells were kindly provided by Prof. Derek Lovley from University of Massachusetts (USA). We would like to thank to Dr. Daniela Nunes for the SEM images. Electrochemically active bacteria (EAB) have the capability to transfer electrons to cell exterior, a feature that is currently explored for important applications in bioremediation and biotechnology fields. However, the number of isolated and characterized EAB species is still very limited regarding their abundance in nature. Colorimetric detection has emerged recently as an attractive mean for fast identification and characterization of analytes based on the use of electrochromic materials. In this work, WO 3 nanoparticles were synthesized by microwave assisted hydrothermal synthesis and used to impregnate non-treated regular office paper substrates. This allowed the production of a paper-based colorimetric sensor able to detect EAB in a simple, rapid, reliable, inexpensive and eco-friendly method. The developed platform was then tested with Geobacter sulfurreducens, as a proof of concept. G. sulfurreducens cells were detected at latent phase with an RGB ratio of 1.10 ± 0.04, and a response time of two hours. publishersversion published