Search

Reports on the development of a tunneling model to understand the gate current as a function of voltage and temperature, based on the energy-dispersion relation in each region of the gate-dielectric-silicon system. Calculation of the gate capacitance from Schrodinger and Poisson equations subject to Fermi-Dirac statistics.

Investigates the modeling of direct tunneling current through gate dielectric stacks. Gate lengths of complementary metal oxide semiconductors; Assumptions and approximations made in the investigation; Discussion of tunneling currents.

Dielectric barrier discharge excitated by pulsed power is a promising approach for producing nonthermal plasma at atmospheric pressure, but pulsed power generators vary widely in performance and should be chosen according to application requirements. In this paper, a repetitive unipolar nanosecond-pulse generator is constructed using resonant charging and one-stage magnetic compression circuits, where IGBT and magnetic switches are the key units, respectively. The generator is capable of providing repetitive pulses with a voltage of up to 30 kV and duration of 70 ns at a 300 Ω resistive load. Output pulse voltage can be adjusted by varying ac input voltage or trigger pulse-width. This compact and convenient generator has been used successfully to produce stable dielectric barrier discharge. [ABSTRACT FROM AUTHOR]

Dielectric barrier discharge (DBD) is proved to be an effective method for surface treatment of polymers over the past 20 years and is now widely used in the fields of surface modification. In this paper, surface treatment of polyethylene terephthalate (PET) films for improving the hydrophilicity using DBD excited by unipolar nanosecond pulses is presented. Two typical discharges exhibiting homogeneous and filamentary modes are obtained under certain experimental conditions, and then, they are used to modify the surface of PET films. The microstructure and properties of the film surface before and after treatment are characterized with water contact angle measurement, scanning electron microscope, atomic force microscope, and X-ray photoelectron spectroscope. The results show that, with the treatment power density of 192 and 158 mW/cm2 in filamentary and homogeneous modes, respectively, surface morphology and property after treatment are significantly changed, and the physical etching and introduction of oxygen-containing polar functional groups account for the decease of surface contact angle and the increase of surface roughness. Compared with the filamentary DBD treatment, the homogeneous DBD (HDBD) is more effective in surface treatment, such as lower contact angle, higher roughness, and more oxygencontaining function groups after treatment. It is attributed to the fact that the HDBD can achieve a uniform treatment and canmake the physical and chemical interaction much sufficient. [ABSTRACT FROM AUTHOR]