Search

This paper proposes the planning method for capacitor installation in a distribution system to reduce the installation costs and minimize the loss of electrical energy. The expected life-time of devices with moving parts depends on the total number of operations, which affects the replacement period and replacement decisions for aging equipment under a limited budget. In this paper, the expected device lifetimes are included in the formulation, and the optimal operation status of the devices is determined using a genetic algorithm. The optimal numbers and locations for capacitor installation are determined based on the optimal operation status. Simulation results in a 69-bus distribution system show that the proposed technique performs better than conventional methods. [ABSTRACT FROM AUTHOR]

This paper presents a multiobjective performance index-based size and location determination of distributed generation in distribution systems with different load models. Normally, a constant power (real and reactive) load model is assumed in most of the studies made in the literature. It is shown that load models can significantly affect the optimal location and sizing of distributed generation (DG) resources in distribution systems. The simulation technique based on genetic algorithms is studied. The studies have been carried out on 16-bus and 37-bus distribution systems. [ABSTRACT FROM AUTHOR]

Deregulation of the electric power industry has introduced new uncertainties for market participants and made planning of transmission expansion more difficult. More flexible transmission expansion plans are needed, to cope with the increased risks. In this paper, a novel planning approach is proposed to meet the above challenge. In our approach, the planning process is modeled as a mixed integer nonlinear programming (MINLP) problem, so that conflicting objectives can be optimized simultaneously. To minimize planning risks, our method identifies several scenarios based on statistics and expert knowledge; the most flexible expansion plan is selected as the plan that has least adaptation cost. The proposed method is tested with the IEEE 14-bus system. Promising results are obtained to demonstrate the effectiveness of our method. [ABSTRACT FROM AUTHOR]

The objective of this paper is to present a new fuzzy logic method for midterm energy forecasting. The proposed method properly transforms the input variables to differences or relative differences, in order to predict energy values not included in the training set and to use a minimal number of patterns. The input variables, the number of the triangular membership functions and their base widths are simultaneously selected by an optimization process. The standard deviation is calculated analytically by mathematical expressions based on the membership functions. Results from an extensive application of the method to the Greek power system and for different categories of customers are compared to those obtained from the application of standard regression methods and artificial neural networks (ANN). [ABSTRACT FROM AUTHOR]

In this paper, dead band control algorithms using a performance index of the load tap changing (LTC) tap position are proposed to reduce the tap changing operation times. The performance index is defined as the customer voltage quality with the tap position of LTC transformer. In addition, dead band control algorithms using the load diversity values of the feeders are proposed. The mathematical formulations of the proposed dead band control algorithms are introduced. A sample case study is shown to verify the effectiveness of the proposed dead band control algorithms. [ABSTRACT FROM AUTHOR]

A generic operations framework for a distribution company (disco) operating in a competitive electricity market environment is presented in this paper. The operations framework is a two-stage hierarchical model in which the first deals with disco's activities in the day-ahead stage, the Day Ahead Operations Model (DAOM). The second deals with disco's activities in real-time and is termed Real-Time Operations Model (RTOM). The DAOM determines the disco's operational decisions on grid purchase, scheduling of distributed generation (DG) units owned by it, and contracting for interruptible load. These decisions are imposed as boundary constraints in the RTOM and the disco seeks to minimize its short-term costs keeping in mind its day-ahead decisions. A case-study is presented considering the well-known 33-bus distribution system and three different scenarios are constructed to analyze the disco's actions and decision-making in this context. [ABSTRACT FROM AUTHOR]

The task of controlling a power system is generally accomplished by several entities, each responsible for a distinct part of the system. For the enhancement of the system security, controllable devices such as FACTS devices are installed and operated by these entities. But in order to avoid conflicting behavior coordination is needed, leading to the concept of multiarea control. In this paper, it is assumed that the areas are determined independently from each other according to the influence of the control devices. As a consequence, overlapping areas may result necessitating an extension of the applied multiarea control method based on approximate Newton directions. In addition, it is taken into account that part of the grid might not be included in any of the areas. [ABSTRACT FROM AUTHOR]

Jinsha River has very abundant hydro power reservation, ranking first in all the hydro power bases of China. To deliver the 38-GW hydro power from Jinsha power stations by HVDC transmission lines to load centers 1000-2000 km away, it is necessary to determine the right voltage level and the capacity of each bipole. This paper proposes three preliminary power delivery scheme and presents an optimization method for transmission capacity, dc voltage and conductor size. Based on a comprehensive comparison of cost-effectiveness, technical feasibility and network security and stability, it was recommended that the 3 bipolar ±800-kV ultra HVDC (UHVDC) links with rated capacity of 6.4 GW for each link be adopted as transmission scheme of Phase I Hydro Power station on Jinsha River. [ABSTRACT FROM AUTHOR]

This paper analyzes the impact of system frequency variations on the steady-state operation point of fixed speed induction generators used in wind turbine generation systems (WTGS). An analytic method to predict the values of angular speed, torque and current during and after a frequency disturbance is presented. The proposed method as well permits to establish the operation limits in order to keep the WTGS connected during frequency variations and therefore to adjust protection relay settings. [ABSTRACT FROM AUTHOR]

This paper generalizes Benders decomposition to maximize a nonconcave objective function and uses that decomposition to solve an "electric power grid interdiction problem." Under one empirically verified assumption, the solution to this bilevel optimization problem identifies a set of components, limited by cardinality or "interdiction resource," whose destruction maximizes economic losses to customers (and can thereby guide defensive measures). The decomposition subproblem typically incorporates a set of dc optimal power-flow models that cover various states of repair after an attack, along with a load-duration curve. Test problems describe a regional power grid in the United States with approximately 5000 buses, 6000 lines, and 500 generators. Solution time on a 2-GHz personal computer is approximately one hour. [ABSTRACT FROM AUTHOR]

Spinning reserve (SR) allows system operators to compensate for unpredictable imbalances between load and generation caused by sudden outages of generating units, errors in load forecasting or unexpected deviations by generating units from their production schedules. As the proportion of power produced by wind farms increases, it becomes more difficult to predict accurately the total amount of power injected by all generators into the power system. This added uncertainty must be taken into account when setting the requirement for SR. This paper proposes a technique to calculate the optimal amount of SR that the system operator should provide to be able to respond not only to generation outages but also to errors in the forecasts for load and wind power production. Using a Monte Carlo simulation, the proposed technique for setting the SR requirements is then compared with the traditional deterministic criterion (i.e., the capacity of the largest online infeed), an approach to cope with wind imbalances and an approach that combines the traditional criterion with the approach to cope with wind imbalances. The results show that, contrary to what is commonly believed, an increased wind power penetration does not necessarily require larger amounts of SR. [ABSTRACT FROM AUTHOR]

During 2005 and 2006, the Western Electricity Coordinating Council (WECC) performed three major tests of western system dynamics. These tests used a Wide-Area Measurement System (WAMS) based primarily on phasor measurement units (PMUs) to determine response to events including the insertion of the 1400-MW Chief Joseph braking resistor, probing signals, and ambient events. Test security was reinforced through real-time analysis of wide-area effects, and high-quality data provided dynamic profiles for interarea modes across the entire western interconnection. The tests established that low-level optimized pseudo-random ±20-MW probing with the Pacific DC Intertie (PDCI) roughly doubles the apparent noise that is natural to the power system, providing sharp dynamic information with negligible interference to system operations. Such probing is an effective alternative to use of the 1400-MW Chief Joseph dynamic brake, and it is under consideration as a standard means for assessing dynamic security. [ABSTRACT FROM AUTHOR]

This letter presents a control method for grid-connected PWM voltage source inverters (VSIs) featuring fast load voltage regulation and effective mitigation of fast voltage disturbances. The control scheme is based on a hybrid linear with variable-structure control (VSC) voltage controller and a deadbeat current regulator. The proposed scheme is applied to a VSI-based distributed generation (DG) interface to regulate the voltage at the point of common coupling (PCC). [ABSTRACT FROM AUTHOR]

This letter describes an approach using Benders decomposition to decompose security-constrained optimal power flow (DSCOPF). It provides a complexity analysis to give insight into the improved computing speeds obtained using the approach. The method is illustrated on two six-bus test systems and on the IEEE reliability test system. [ABSTRACT FROM AUTHOR]