Search

Copyright of Galicia Clínica is the property of Sociedad Gallega de Medicina Interna and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

We detail results of an experiment performed at the Ligne d'Intégration Laser facility aimed at studying supersonic and diffusive radiation front propagation in low-density SiO2 aerogel (20 and 40 mg/cm3) enclosed in a gold tube, driven by thermal emission from a laser-heated spherical gold cavity. The evolution of the front is studied continuously by measuring its self-emission with a 1D (one-dimensional) time-resolved soft x-ray imager. Measurement is performed along (through a 200-μm-wide observation slit) and at the exit of the tube giving access to the dynamics and the curvature of the front. Experimental results are then compared successfully to results from the 3D (three-dimensional) radiation hydrodynamics code TROLL, which shows that if continuous tracking of the front position is accessible with this experimental scheme, measurement of its maximum radiation temperature is on the contrary affected by radiation closure of the observation slit. 3D simulations also indicate that this effect can even be worsened if one includes pointing errors of the x-ray imager. Radiation temperature along the tube was then inferred by combining results from the imager to a wall shock breakout time measurement using a velocity interferometer system for any reflector and results from a broadband x-ray spectrometer used to determine the temperature at the exit of the tube. A decrease in the radiation temperature along the tube is observed, the decrease being more important for the higher SiO2 aerogel density. [ABSTRACT FROM AUTHOR]

Electro-optical equivalent calibration with high calibration power and high equivalence is particularly well-suited to the calibration of high-energy laser energy meters. A large amount of energy is reserved during this process, however, which continues to radiate after power-off. This study measured the radiation efficiency of a halogen tungsten lamp during power-on and after power-off in order to calculate the total energy irradiated by a lamp until the high-energy laser energy meter reaches thermal equilibrium. A calibration system was designed based on the measurement results, and the calibration equivalence of the system was analyzed in detail. Results show that measurement precision is significantly affected by the absorption factor of the absorption chamber and by heat loss in the energy meter. Calibration precision is successfully improved by enhancing the equivalent power and reducing power-on time. The electro-optical equivalent calibration system, measurement uncertainty of which was evaluated as 2.4% (k = 2), was used to calibrate a graphite-cone-absorption-cavity absolute energy meter, yielding a calibration coefficient of 1.009 and measurement uncertainty of 3.5% (k = 2). A water-absorption-type high-energy laser energy meter with measurement uncertainty of 4.8% (k = 2) was considered the reference standard, and compared to the energy meter calibrated in this study, yielded a correction factor of 0.995 (standard deviation of 1.4%). [ABSTRACT FROM AUTHOR]