Search

Superconducting nanowire single-photon detectors (SNSPDs) show near unity efficiency, low dark count rate, and short recovery time. Combining these characteristics with temporal control of SNSPDs broadens their applications as in active de-latching for higher dynamic range counting or temporal filtering for pump-probe spectroscopy or LiDAR. To that end, we demonstrate active gating of an SNSPD with a minimum off-to-on rise time of 2.4 ns and a total gate length of 5.0 ns. We show how the rise time depends on the inductance of the detector in combination with the control electronics. The gate window is demonstrated to be fully and freely, electrically tunable up to 500 ns at a repetition rate of 1.0 MHz, as well as ungated, free-running operation. Control electronics to generate the gating are mounted on the 2.3 K stage of a closed-cycle sorption cryostat, while the detector is operated on the cold stage at 0.8 K. We show that the efficiency and timing jitter of the detector is not altered during the on-time of the gating window. We exploit gated operation to demonstrate a method to increase in the photon counting dynamic range by a factor 11.2, as well as temporal filtering of a strong pump in an emulated pump-probe experiment.

In our work, we have engineered low capacitance single quantum dot photodiodes as sensor devices for the optoelectronic sampling of ultrafast electric signals. By the Stark effect, a time-dependent electric signal is converted into a time-dependent shift of the transition energy. This shift is measured accurately by resonant ps laser spectroscopy with photocurrent detection. In our experiments, we sample the laser synchronous output pulse of an ultrafast CMOS circuit with high resolution. With our quantum dot sensor device, we were able to sample transients below 20 ps with a voltage resolution in the mV-range.

Semiconductor quantum dots embedded in optical cavities are promising on-demand sources of single photons. Here, we theoretically study single photon emission from an optically driven two-photon Raman transition between the biexciton and the ground state of a quantum dot. The advantage of this process is that it allows all-optical control of the properties of the emitted single photon with a laser pulse. However, with the presence of other decay channels and excitation-induced quantum interference, on-demand emission of the single Raman photon is generally difficult to achieve. Here we show that laser pulses with non-trivial shapes can be used to maintain excitation conditions for which with increasing pulse intensities the on-demand regime is reached. To provide a realistic picture of the achievable system performance, we include phonon-mediated processes in the theoretical caluclations. While preserving both high photon purity and indistinguishability, we find that although based on a higher-order emission process, for realistic system parameters on-demand Raman photon emission is indeed achievable with suitably tailored laser pulses.

Integrated $\chi^{(2)}$ devices are a widespread tool for the generation and manipulation of light fields, since they exhibit high efficiency, small footprint and the ability to interface them with fibre networks. Surprisingly many things are not fully understood until now, in particular the fabrication of structures in potassium titanyl phosphate (KTP). A thorough understanding of the fabrication process and analysis of spatial properties is crucial for the realization and the engineering of high efficiency devices for quantum applications. In this paper we present our studies on rubidium-exchanged waveguides fabricated in KTP. Employing energy dispersive X-ray spectroscopy (EDX), we analysed a set of waveguides fabricated with different production parameters in terms of time and temperature. We find that the waveguide depth is dependent on their widths by reconstructing the waveguide depth profiles. Narrower waveguides are deeper, contrary to the theoretical model usually employed. Moreover, we found that the variation of the penetration depth with the waveguide width is stronger at higher temperatures and times. We attribute this behaviour to stress-induced variation in the diffusion process., Comment: 8 pages, 4 figures

Semiconductor quantum dots are promising sources for polarization-entangled photons. As an alternative to the usual cascaded biexciton-exciton emission, direct two-photon emission from the biexciton can be used. With a high-quality optical resonator tuned to half the biexciton energy, a large proportion of the photons can be steered into the two-photon emission channel. In this case the degree of polarization entanglement is inherently insensitive to the exciton fine-structure splitting. In the present work we analyze the biexciton emission with particular emphasis on the influence of coupling of the quantum-dot cavity system to its environment. Especially for a high-quality cavity, the coupling to the surrounding semiconductor material can open up additional phonon-assisted decay channels. Our analysis demonstrates that with the cavity tuned to half the biexciton energy, the potentially detrimental influence of the phonons on the polarization entanglement is strongly suppressed -- high degrees of entanglement can still be achieved. We further discuss spectral properties and statistics of the emitted twin photons.

Semiconductor quantum-dot cavity systems are promising sources for solid-state based on-demand generation of single photons for quantum communication. Commonly, the spectral characteristics of the emitted single photon are fixed by system properties such as electronic transition energies and spectral properties of the cavity. In the present work we study single-photon generation from the quantum-dot biexciton through a partly stimulated non-degenerate two-photon emission. We show that frequency and linewidth of the single photon can be fully controlled by the stimulating laser pulse, ultimately allowing for efficient all-optical spectral shaping of the single photon.

Sources of single photons are key elements in the study of basic quantum optical concepts and applications in quantum information science. Among the different sources available, semiconductor quantum dots excel with their straight forward integrability in semiconductor based on-chip solutions and the potential that photon emission can be triggered on demand. Usually, the photon emission event is part of a cascaded biexciton-exciton emission scheme. Important properties of the emitted photon such as polarization and time of emission are either probabilistic in nature or pre-determined by electronic properties of the system. In this work, we study the direct two-photon emission from the biexciton. We show that emission through this higher-order transition provides a much more versatile approach to generate a single photon. In the scheme we propose, the two-photon emission from the biexciton is enabled by a laser field (or laser pulse) driving the system into a virtual state inside the band gap. From this intermediate virtual state, the single photon of interest is then spontaneously emitted. Its properties are determined by the driving laser pulse, enabling all-optical on-the-fly control of polarization state, frequency, and time of emission of the photon.

One of the biggest challenges of nanotechnology is the fabrication of nano-objects with perfectly controlled properties. Here we employ a focused laser beam both to characterize and to {\it in-situ} modify single semiconductor structures by heating them from cryogenic to high temperatures. The heat treatment allows us to blue-shift, in a broad range and with resolution-limited accuracy, the quantized energy levels of light and charge carriers confined in optical microcavities and self-assembled quantum dots (QDs). We demonstrate the approach by tuning an optical mode into resonance with the emission of a single QD and by bringing different QDs in mutual resonance. This processing method may open the way to a full control of nanostructures at the quantum level., Comment: 3 figures