Search

In this Letter, an enhancement mode (E-mode) β-Ga2O3 metal-oxide-semiconductor field-effect transistor (MOSFET) with quasi-two-dimensional channel was reported, and the channel mobility of 147.5 cm2/(V·s) is achieved. Low damage etching technology and low Ohmic contact resistance technology are introduced. As a result, the E-mode transistor demonstrates a maximum drain to source current (ID) of 230.5 mA/mm, a peak transconductance (Gm) of 54.2 mS/mm, a current gain cut-off frequency (fT) of 18 GHz, and a power gain cut-off frequency (fMAX) of 42 GHz. Additionally, a positive threshold voltage (VT) of 1.65 V, a breakdown voltage (VBK) of 420 V, and a specific on-resistance (RON,SP) of 1.24 mΩ·cm2 are achieved. Moreover, a fMAX × VBK of 17.64 THz·V and a fT × VBK of 7.56 THz·V are found to be a close value so far to the theoretical limit of β-Ga2O3. This device leads to excellent radio frequency (RF) characteristics, which paved the way for future millimeter-wave RF power electronics applications with β-Ga2O3 MOSFET. [ABSTRACT FROM AUTHOR]

This Letter reports two kinds of oxygen-containing plasma treated β-Ga2O3 Schottky barrier diodes (SBDs), including N2O plasma treatment and O2 plasma treatment, and the SBD without plasma is prepared for comparison. I–V characteristics, breakdown characteristics, and trap state characteristics of three devices have been studied. It is found that the turn-on voltage of SBDs with N2O plasma can reduce to 0.6 V, and the better current density of 750 A/cm2 and an on-resistance of 3.5 mΩ cm2 are obtained after the N2O plasma treatment. Moreover, the breakdown voltage of SBDs with N2O plasma is 50.2% higher than the conventional one, whose value reaches 323 V. In addition, the trap states' characteristics of the devices are studied, which show that the oxygen-containing plasma can reduce the deep level trap states density partly in the anode region, which can improve the surface quality effectively. [ABSTRACT FROM AUTHOR]

A β-Ga2O3 Schottky barrier diode (SBD) with a p-type NiOx guard ring was fabricated, and the reverse leakage and subthreshold leakage current reduction was found at high temperatures from temperature-dependent I–V characteristics. The functional mechanisms of NiOx as edge termination on leakage reduction were studied. NiOx can increase the barrier height and passivate the defects at the interface, resulting in the suppression of subthreshold leakage and elimination of current crowding effect confirmed by a thermal emission microscope. From the temperature-dependent x-ray photoelectron spectroscopy characteristics, more holes generated to deplete Ga2O3 at higher temperatures were found. It leads to reduce the reverse leakage current. The small-polaron transportation in NiOx is proposed to argue the implausibility of the leakage conduction in NiOx. This work will offer critical physical insight and a valuable route for developing low-leakage Ga2O3 SBDs. [ABSTRACT FROM AUTHOR]

In the bridge maintenance management decision, the health evaluation on bridge structure is far more than determination of abnormal index exceed fixed threshold, or evaluation on damage status and carrying capacity, the on-site human inspection should also be paid attention. In order to achieve more accurate and reliable health status evaluation result, it needs to take full advantage of various information and parameter. The D-S evidence information fusion was used in the paper to present comprehensive bridge health evaluation method. It fuses bridge operation status using abnormal status identification, bridge durability with residual life estimation, as well as human inspection rating, to arrive at health evaluation. The actual application examples to verify the method is also provided.

The bridge structure abnormality recognition is one of the key steps of its health assessment. Using novelty detection technique based on BP neural network, the method to identify and locate abnormal bridge status was presented. It uses non-training-data in the original sample data to generate novelty indicator and determines threshold. If the difference between detection status indicator and normal value is larger than the threshold, the structure status is determined changed. The method adapts stepwise partition identification method. The method firstly determines damage position within a small range and then analyzes sensor data in detail, so as to locate specific position. The measured data on T beam model verifies the method can accurately carry out status identification and locate cracking position under cracking load conditions.

A low temperature controlled annealing technique was utilized to improve the performance of vertical β-gallium oxide (β-Ga2O3) Schottky barrier diodes (SBDs) in this work. The nickel is diffused into Ga2O3, and NiO was formed at the interface between the anode and semiconductor generating p–n junction after low temperature annealing. Simultaneously, the trap state density of interface Ni/Ga2O3 as well as the carbon bonded with oxygen on the surface was reduced, which was proved by the capacitance and conductance measurements and x-ray photoelectron spectroscopic analysis, respectively. Combined the decreased saturation current density by three orders of magnitude from 1.21 × 10−6 to 9.27 × 10−8 and 5.12 × 10−9 A/cm2 and larger breakdown voltage from 220 to 270 V owing to the optimized interface and the formation of NiO, a low temperature annealing technique makes certain effective improvement for vertical β-Ga2O3 SBDs via interface engineering. [ABSTRACT FROM AUTHOR]

PbZr0.2Ti0.8O3 (PZT) gate insulator with the thickness of 30 nm is grown by pulsed laser deposition (PLD) in AlGaN/GaN metal–insulator–semiconductor high electron mobility transistors (MIS-HEMTs). The ferroelectric effect of PZT AlGaN/GaN MIS-HEMT is demonstrated. The polarization charge in PZT varies with different gate voltages. The equivalent polarization charge model (EPCM) is proposed for calculating the polarization charge and the concentration of two-dimensional electron gas (2DEG). The threshold voltage (Vth) and output current density (IDS) can also be obtained by the EPCM. The theoretical values are in good agreement with the experimental results and the model can provide a guide for the design of the PZT MIS-HEMT. The polarization charges of PZT can be modulated by different gate-voltage stresses and the Vth has a regulation range of 4.0 V. The polarization charge changes after the stress of gate voltage for several seconds. When the gate voltage is stable or changes at high frequency, the output characteristics and the current collapse of the device remain stable. [ABSTRACT FROM AUTHOR]

The construction of highway ecological landscape is an important part of highway entity and an iconic feature of scenic countryside and ecological garden city, which plays an important role in the process of achieving social and economic sustainable development. The efficient index system and method is a basic measurement for the assessment of the interior quality and its associated outer environment. By taking five arterial highways (G15, G228, G204, S334 and S335) in the territory of Nantong City, Jiangsu Province as the case, an evaluation system containing quantitative and qualitative indices was developed to deal with the ecological landscape quality. The system composed of 12 evaluation indices which were divided into three categories including ornamental value, ecological efficiency, and safety design. Based on the survey and calculation of the raw data, the variable matrix was established and analyzed with principal component (PC) analysis. The results showed that the equation of highway greening ecological evaluation score was H = 0.694xPCl +0.191 XPC2+0.115XPC3, and scores of 5 highways ranked in the ordination of G204 > G15 > S334 > G228 > S335. The results would provide methods and references for efficient evaluation of highway landscape. [ABSTRACT FROM AUTHOR]