Search

The main study objective was to evaluate the influence of the perspective "Internal" (coolant is supplied to the channel inside the indexable insert body) and "Combined" (coolant is supplied to the rake and flank faces through the channel inside the indexable insert body) Cooling Schemes on the temperature of the contact point between the tool and the workpiece, on the heat distribution inside the indexable insert body, and (additionally) on the cutting forces. The contact point temperature and cutting forces were investigated during the non-orthogonal turning of SUS304 Stainless Steel at speeds of 180, 140, and 100 m/min with constant feed and depth of cut. The heat distribution was examined through 2D simulations using DEFORM 2D3D software. The evaluation of the perspective cooling schemes' influence on the selected parameters was performed by comparing the obtained data with the test results of the "traditional" external cooling and dry cutting under similar cutting modes. According to the comparison results, the perspective cooling schemes demonstrated a slight decrease (~3-7%) in the temperature of the contact point between the tool and the workpiece, a significant decrease in the heat distribution (~38-55%) inside the indexable insert body and, in some cases, a decrease of the cutting forces. Based on the study results, the authors confirmed the influence of perspective cooling schemes on the selected parameters and suggested a further positive effect of these schemes' utilization on the cutting tool life.

This paper describes the process of the design and verification of a milling tool and tooling that may contribute to the renouncement of the flood cooling method when mineral oils and oil-in-water emulsions are used as coolants. The proposed solutions are based on the idea of coolant supply in internal channels created inside of a cutting tool. As an alternative to the aforementioned mineral oil-based coolants, liquids with higher cooling efficiency and environmental friendliness (green coolants) were considered. Given coolants’ possible lack of lubricating properties and negative (corrosive, etc.) influence on a machine tool’s units, tooling delivers these coolants to the cutting tool and bypasses the standard machine tool’s supply system. The geometry of the milling tool (a cutting insert with an internal channel) was tested in the framework of a stress simulation. To perform it, cutting force components Fz, Fy, and Fx were determined empirically and then applied to the simulated area of contact between the tool and the workpiece. Based on the obtained principal stress values P1, P2, and P3, the factor of safety was calculated with the Mohr–Coulomb, P1 max, and P3 min failure criteria. The proposed milling tool, equipped with a novel type of labyrinth seal with no friction between its components, was experimentally tested to confirm its ability to maintain leak-tightness at different values of spindle speed (200~2000 rpm) and coolant supply volume (1.0~10.0 L/min). Based on the results of the stress simulation and the leak-tightness experiment, conclusions were drawn about further modernization and utilization prospects of the proposed milling tool and tooling design.