Search

The multilayer structure is a well-studied architecture for electronic and optoelectronic applications and more recently in spintronic devices. In this work, we present the structural, morphological, topographical, and magnetic properties of GaSb/Mn multilayers deposited via DC magnetron sputtering at room temperature and 423 K. Raman measurements evidence the formation of p-type GaSb layers with a contribution of electrons in the multilayer due to the neighboring Mn layer and the formation of effective interlayers. HR-SEM measurements show the multilayer architecture with columnar microstructure in the layer’s formation, while AFM micrographs allowed observing the changes in grain sizes (between 129 and 187 nm) and roughness (between 1.47 nm and 6.28 nm) with increasing number of layers. The formation of the interlayers between the GaSb and Mn layer was assayed in-depth spectroscopically via Rutherford backscattering studies. These interlayers were associated with diffusion processes during deposition and contributed to the magnetic behavior of multilayers. A ferromagnetic-like behavior was observed in the multilayers

Ratchet devices allow turning an ac input signal into a dc output signal. A ratchet device is set by moving particles driven by zero averages forces on asymmetric potentials. Hybrid nanostructures combining artificially fabricated spin ice nanomagnet arrays with superconducting films have been identified as a good choice to develop ratchet nanodevices. In the current device, the asymmetric potentials are provided by charged Néel walls located in the vertices of spin ice magnetic honeycomb array, whereas the role of moving particles is played by superconducting vortices. We have experimentally obtained ratchet effect for different spin ice I configurations and for vortex lattice moving parallel or perpendicular to magnetic easy axes. Remarkably, the ratchet magnitudes are similar in all the experimental runs; i. e. different spin ice I configurations and in both relevant directions of the vortex lattice motion. We have simulated the interplay between vortex motion directions and a single asymmetric potential. It turns out vortices interact with uneven asymmetric potentials, since they move with trajectories crossing charged Néel walls with different orientations. Moreover, we have found out the asymmetric pair potentials which generate the local ratchet effect. In this rocking ratchet the particles (vortices) on the move are interacting each other (vortex lattice); therefore, the ratchet local effect turns into a global macroscopic effect. In summary, this ratchet device benefits from interacting particles moving in robust and topological protected type I spin ice landscapes., This work was supported by Spanish MICINN grants FIS2016-76058 (AEI/FEDER, UE), EU COST- CA16218. IMDEA Nanociencia acknowledges support from the ‘Severo Ochoa’ Programme for Centres of Excellence in R&D (MICINN, Grant SEV-2016-0686). MCO and AG acknowledges financial support from Spanish MICINN Grant ESP2017-86582-C4-1-R and IJCI-2017-33991; AMN acknowledges financial support from Spanish CAM Grant 2018-T1/IND-10360. MV acknowledges financial support from Spanish MICINN Grant PID2019-104604RB/AEI/10.13039/50110001103.

Nanoparticle-mediated thermal treatments have demonstrated high efficacy and versatility as a local anticancer strategy beyond traditional global hyperthermia. Nanoparticles act as heating generators that can trigger therapeutic responses at both the cell and tissue level. In some cases, treatment happens in the absence of a global temperature rise, damaging the tumor cells even more selectively than other nanotherapeutic strategies. The precise determination of the local temperature in the vicinity of such nanoheaters then stands at the heart of thermal approaches to better adjust the therapeutic thermal onset and reduce potential toxicity-related aspects. Herein, we describe an experimental procedure by X-ray absorption spectroscopy, which directly and accurately infers the local temperature of gold-based nanoparticles, single and hybrid nanocrystals, upon laser photoexcitation, revealing significant nanothermal gradients. Such nanothermometric methodology based on the temperature-dependency of atomic parameters of nanoparticles can be extended to any nanosystem upon remote hyperthermal conditions.

[EN] Epsilon iron oxide (ε-FeO) coatings on Si(100) substrates are obtained by an easy one-pot sol-gel recipe assisted by glycerol in an acid medium. Glycerol, given its small dimensions, enables the formation of ε-FeO nanoparticles with a size of a few nanometers and the highest purity is reached in coatings after a densification treatment at 960 °C. The structural and compositional evolution up to 1200 °C is studied by confocal Raman microscopy and X-ray absorption spectroscopy techniques, correlating the existing magnetic properties. We report a novel characterization method, which allows monitoring the evolution of the precursor micelles as well as the intermediate and final phases formed. Furthermore, the inherent industrial technology transfer of the sol-gel process is also demonstrated with the ε-FeO polymorph, impelling its application in the coatings form., This work has been supported by the Ministerio de Ciencia e Innovación (MCINN, Spain) through the projects PIE: 2021-60-E-030, PIE: 2010-6-OE-013, PID2019-104717RB-I00 (2020–2022), MAT2017-86540-C4-1-R, RTI2018-095856-B-C21 (2019–2021), RTI2018-097895-B-C43 and RTI2018-095303-A-C52. The authors are grateful to The ESRF (France), MCINN and Consejo Superior de Investigaciones Científicas (CSIC, Spain) for the provision of synchrotron radiation facilities and to the BM25-SpLine Staff for their valuable help. A.S.and A.M.-N acknowledge financial support from Comunidad de Madrid (Spain) for an “Atracción de Talento Investigador” Contract 2017-t2/IND5395 and 2018-T1/IND-10360, respectively

Silicon carbide (SiC) attracts a lot of attention for several useful applications such as semiconductor devices and structural materials under severe conditions because of outstanding electronic pr...

The aim of this work is to clarify how in-plane magnetic anisotropy and magnetoelasticity depend on the thickness of Ga-rich FeGa layers. Samples with an Fe72Ga28 composition were grown by sputtering in the ballistic regime in oblique incidence. Although for these growth conditions uniaxial magnetic anisotropy could be expected, in-plane anisotropy is only present when the sample thickness is above 100 nm. By means of differential X-ray absorption spectroscopy, we have determined the influence of both Ga pairs and tetragonal cell distortion on the evolution of the magnetic anisotropy with the increase of FeGa thickness. On the other hand, we have used the cantilever beam technique with capacitive detection to also determine the evolution of the magnetoelastic parameters with the thickness increase. In this case, experimental results can be understood considering the grain distribution. Therefore, the different physical origins for anisotropy and magnetoelasticity open up the possibility to independently tune these two characteristics in Ga-rich FeGa films., This work has been financially supported through the projects MAT2015-66888-C3-3-R and MAT2015-66726-R (MINECO/FEDER) of the Spanish Ministry of Economy and Competitiveness, RTI2018-097895-B-C43 of the Spanish Ministry of Science, Innovation, and Universities, and Gobierno de Aragón (Grant E10-17D) and Fondo Social Europeo. A.M.-N. is thankful for the contract from Universidad Complutense and Comunidad de Madrid “Atracción de Talento” program 2018-T1/IND-10360, and A.B. thanks MINECO for the Ph.D. grant BES-2016-076482.

We present an extended X-ray absorption fine structure study at the Mo K-edge of A2(Mo1yMny)2O7 (A Gd, Ho; y 0.05 and 0.10) pyrochlores, as a function of temperature and composition, coupled to diffractometric and magnetic characterizations. Extending the study reported in our previous paper on the pristine A2Mo2O7 compounds to these Mo/Mn partially substituted samples, where we hypothesize a competition between double-exchange and superexchange couplings, we aim to check which structure parameters are related to the nature of the nearest-neighbor magnetic interactions, looking for the presence and evolution of order and structure anomalies. Two Ho samples Ho2(Mo1yMny)2O7 (y 0.05 and 0.10) keep the spin-glass nature of the parent compositions with a strong distortion of the MoO(1)6 octahedron and of the MoHo and MoMo second shell. On the other hand, two Gd2(Mo1yMny)2O7 samples, ferromagnetic at low temperature in the undoped case, show the appearance on a local scale of a spin-glass transition mirrored by a quite high structure disorder and by a distortion coherent with a lattice frustration after Mn-doping. Therefore, the Gd and Ho Mn-doped samples display a similar frustrated behavior, differently from the corresponding undoped ones. We gratefully acknowledge the Spanish CRG at the ESRF for providing beamtime under experiment HC-3343. MS thanks Prof. Monica Dapiaggi for useful discussions. GL thanks Prof. Fabio M. Canepa for illuminating discussions. F.R.-M. gratefully acknowledge the support of the AEI (Spanish Government) Project (No. MAT2017-86450-C4-1-R). F.R.-M. is indebted to MINECO for the Ramon y Cajal contract (Ref: RyC-2015-18626), which is co-financed by the European Social Fund.

The in situ study of the discharge process in a zinc-based half-cell employing a porous electrode as a structural scaffold is reported. The in situ characterization has been performed by synchrotron X-ray absorption fine-structure spectroscopy and, for this purpose, an inexpensive, simple and versatile electrochemical cell compatible with X-ray experiments has been designed and described. The experimental results reported here have been employed to semi-quantify the dissolved and undissolved zinc species during the discharge, allowing the cell feasibility to be tested and to better understand the functioning of the zinc half-cell based on porous electrodes.

[EN] The purpose of this work is to fabricate self-assembled microstructures by the sol–gel method and study the morphological, structural and compositional dependence of 3-Fe2O3 nanoparticles embedded in silica when glycerol (GLY) and cetyl-trimethylammonium bromide (CTAB) are added as steric agents simultaneously. The combined action of a polyalcohol and a surfactant significantly modifies the morphology of the sample giving rise to a different microstructure in each of the studied cases (1, 3 and 7 days of magnetic stirring time). This is due to the fact that the addition of these two compounds leads to a considerable increase in gelation time as GLY can interact with the alkoxide group on the surface of the iron oxide precursor micelle and/or be incorporated into the hydrophilic chains of CTAB. This last effect causes the iron oxide precursor micelles to be interconnected forming aggregates whose size and structure depend on the magnetic stirring time of the sol–gel synthetic route. In this paper, crystalline structure, composition, purity and morphology of the sol–gel coatings densified at 960 ºC are examined. Emphasis is placed on the nominal percentage of the different iron oxides found in the samples and on the morphological and structural differences. This work implies the possibility of patterning 3-Fe2O3 nanoparticles in coatings and controlling their purity by an easy one-pot sol–gel method., Spanish Ministry of Industry, Economy and Competitiveness for financing the project MAT2015-65445-C2-1-R, MAT2017-86450-C4-1-R, MAT2015-67557-C2-1-P, by the Comunidad de Madrid S2013/MIT-2850 NANOFRONTMAG and H2020 AMPHIBIAN Project ID: 720853. The authors are also grateful to the BM25-SpLine staff for their valuable technical support beyond their duties and for the financial support from the Spanish Ministry of Science, Innovation and Universities (MICIU) and The Spanish National Research Council (CSIC) under Grant No. PIE 2010- 6OE-013, The ESRF – The European Synchrotron, MICIU and CSIC are acknowledged for provision of synchrotron radiation facilities. A. S. acknowledges the Financial support from the Comunidad de Madrid for an “Atracción de Talento Investigador” contract (No. 2017-t2/IND5395).