Search

Plastic pollution is becoming increasingly severe and is attracting global attention. One of its consequences is the recent discovery of micropollutant discharge into water, with Bisphenol A (BA-MP) being a typical example. This study utilizes an advanced oxidation process based on Pt-doped ZnO photocatalyst to remove BA-MP. Health concerns related to the release of BA-MP from plastic waste are discussed. Besides, the results of the photodegradation experiment show that the Pt-ZnO photocatalyst can remove 94.1% of BA-MP within 60 min when exposed to solar light. Moreover, after five reuse cycles, Pt-ZnO retains a high BA-MP removal efficiency of 71.2%, and its structure remains largely unchanged compared to the original material. The removal efficiency of BA-MP leaching from plastic waste was measured at 98.8%, confirming the suitability of Pt-ZnO for the treatment of micropollutants. Furthermore, this study also highlights the prospects and challenges of using Pt-ZnO for the treatment of micropollutants discharged from plastic waste., (© 2024. The Author(s), under exclusive licence to Springer Nature B.V.)

In this work, alginate-modified biochar derived from rice husk waste was synthesized using a simple process. The modified biochar (MBC) and rice husk biochar (RhBC) were investigated for removing Pb (II) ions in wastewater. The BET result displayed significantly improved specific surface area of MBC up to 120 m 2 /g along with a total pore volume of 0.653 cm 3 /g. FTIR spectrums presented the higher oxygen-contained functional groups of MBC as compared to RhBC, resulting in increasing adsorption capacity of Pb (II). MBC had higher adsorption capacity (112.3 mg/g) and faster removal rate (0.0081 g mg -1 min -1 ) than those of RhBC (41.2 mg/g and 0.00025 g mg -1 min -1 ). Modified RhBC can remove more than 99% of Pb (II) from wastewater and it could be utilized for three cycles with a removal performance of over 90%. In addition, the Pb adsorption mechanism by using MBC was proposed and the practical application of MBC for the treatment of wastewater in Vietnam was discussed., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

In this study, activated carbon from corncobs was successfully synthesized by hydrothermal carbonization and hydrochemical activation at low temperatures, followed by pyrolysis. A developed method of hydrochemical activation of hydrochar that uses only small amounts of chemicals is a promising approach. After activation, the activator residues in the hydrothermal product can constantly act as a chemical activator during pyrolysis to form corncob-activated carbon (AHC-KOH), which had specific surface area of 965.028 m 2 /g and oxygenated functional groups of 0.3780 mmol/g, 31.67 and 4 times, respectively, of those of the inactivated sample. AHC-KOH was used to study the adsorption characteristics of methylene blue (MB). The MB adsorption efficiency of AHC-KOH was the highest at 489.560 mg/g, which was considerably higher than that of activated carbons produced from other biomasses. The isotherm equilibrium and adsorbent kinetics parameters of MB adsorption on AHC-KOH were also determined using the Langmuir isotherm model (R 2  = 0.99) and pseudo-second-order kinetic model (R 2  > 0.99). Thus, the results indicate that an inexpensive adsorbent produced from corncobs using the above method is a promising material for wastewater treatment., (Copyright © 2022 Elsevier Inc. All rights reserved.)

The number of antibiotic compounds in wastewaters has been growing globally due to the covid-19 problem. Using antibiotics to treat the patients would produce larger amounts of these compounds into the environment with negative impacts. Hence, finding out the method for the elimination of toxic organic pollutants as well as antibiotics in water is urgent (In this study, the treatment of antibiotic pollutants including cefalexin (CF) and tetracycline (TC) was investigated by applying the advanced oxidation process based on Ni-doped TiO 2 (Ni-TiO 2 ). The characterizations technologies such as XRD, XPS, UV-vis, PL, and PC indicated that Ni doping would improve the photocatalytic performance of TiO 2 . In the photodegradation experiments, the Ni-TiO 2 possessed high photocatalytic degradation efficiencies with 93.6% for CF and 82.5% for TC. Besides, the removal rates of antibiotics after five cycles are higher than 75%, implying excellent stability of Ni-TiO 2 photocatalyst. The result from the treatment of wastewater samples revealed that the Ni-TiO 2 photocatalytic had good performance for removal of CF and TC at a high level of 88.6 and 80.2%, respectively., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

In this study, we investigated the feasibility on the utilization of coffee husk as biosorbents for the removal of heavy metal ions such as Pb 2+ and Cd 2+ from wastewater. Biochar was produced from coffee wastes and modified with sodium hydroxide to create functional groups on the surface and increase the specificic surface area. The resultant products were characterized by using various analytical methods such as scanning electron microscopy, specific area, surface functional group and zeta potential analysis. The as-prepared materials were employed as adsorbent to remove Pb 2+ and Cd 2+ ions from wastewater. The maximum sorption capacities of biosorbents were measured to be 116.3 and 139.5 mg g -1 for Cd 2+ and Pb 2+ , respectively, which is comparable to the conventional adsorbents. Kinetic studies showed that the sorption of Pb 2+ and Cd 2+ on biosorbents can be described by the Freundlich isotherm and second-order kinetic model. The coffee husk-derived biosorbent was capable of removing 89.6% of Pb 2+ and 81.5% Cd 2+ ions from wastewater, and therefore can be considered as low-cost and efficient adsorbent to remove heavy metal ions from wastewater., (Copyright © 2021 Elsevier Ltd. All rights reserved.)

The aim of this study is to present the potential of activated carbon fiber (CF) impregnated with lanthanum (La) as a novel adsorbent (La-CF) of phosphate-phosphorus (P) and to assess the value-added due to P-recovery from wastewater using La-CF. The CF were loaded with La and the loaded CF was then calcined at 500 °C. The La-CF adsorbent was used in a series of batch experiments to characterize the adsorption of P at pH of 6-10 and P concentrations of 1-200 mg/L. Physical-chemical properties such as surface morphology, surface charge, surface area, and surface chemistry were determined for the La-CF. The La-CF exhibited adsorption capacity of 196.5 mg/g, fast sorption kinetics and high selectivity for P removal from aqueous solution. La-CF removed 97.3% of P from wastewater and achieved P-level to below 2 mg/L. It was repetitively reused over 10 times in successive cycles to remove P from wastewater. The value-added by recovery of P from wastewater was calculated at around 0.12 US$/L, demonstrating economic benefits of La-CF. In conclusion, the successful removal, recycling, and recovery value-added of P using La-CF adsorbent displayed good potential for developing the technology for treatment of wastewaters to recover valuable compounds such as phosphorus., (Copyright © 2021 Elsevier Ltd. All rights reserved.)

In this study, carbon-based aerogels derived from waste paper (CWP) were explored as an efficent adsorbent to remove organic pollutants including phenol (Ph) and 2-chlorophenol (2CP) from wastewater. CWP exhibited a highly porous structure and large specific surface area of 892 m 2  g -1 , which facilitated the adsorption of Ph and 2CP in wastewater. The adsorption behavior of Ph and 2CP on CWP could be well described by the pseudo-second-order kinetics and Langmuir isotherm models. Based on the Langmuir isotherm, the maximum adsorption capacities of CWP for Ph and 2CP were 238 and 278 mg g -1 , respectively, and these values were much higher than those of other adsorbents. The removal of the organic pollutants mainly occurred through electrostatic attraction, pore-filling, hydrogen bonding, and π-π interactions. The CWP can be directly applied for the removal of Ph and 2CP at low concentration (<200 mg L -1 ) in the wastewater, while they can be used with additional pre-treatment for wastewater containing high concentration of organic pollutants. The adsorptive recovery of organic compounds and potential reuse of treated wastewater were also discussed. This work provides an efficient approach to produce effective adsorbent for the removal and recovery of chemicals from wastewater., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 Elsevier Ltd. All rights reserved.)

Currently, the global production and usage of plastics have increased rapidly with the expansion of synthetic polymers. Since plastics' degradation processes are prolonged and thus microplastics (MPs) potentially persist for very long periods in the environment. To date, there is a need for knowledge on the relevance of different potential entry pathways and the number of MPs entering the environment via different routes. Despite the vast quantity of studies that have been undertaken, many unanswered issues remain about the environmental impacts of MPs. The real impacts on a population subjected to many MPs of different structure, dimensions, and shapes over a lifetime are still hard to elucidate. Significantly, MPs can accumulate toxic substances, such as persistent organic pollutants, on their material surface. Hence, it represents a potential concentrated source of environmental pollution or acts as a vector of toxic pollutants in the food chain's interconnection with some severe health implications. Herein, we mainly discussed the global challenges in MPs, including the current production and use status of plastics and their impact on the environment. Additionally, finding the degradation of tiny fragment plastics (MPs level) is essential to remove plastics altogether. Some of the approaches to methods, including biodegradation, physical degradation, physicochemical degradation, have been successfully reviewed. More importantly, the sustainable concepts of using microorganisms and photocatalysis for MPs' degradation have been successfully proposed and demonstrated., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Published by Elsevier Ltd.)

In this study, activated carbon in the form of carbonaceous hydrochar adsorbents with highly functionalized surface-active sites were produced from coffee husk waste via hydrothermal carbonization under low-temperature conditions (180 °C) and subsequent chemical activation. Thereafter, the hydrochars were characterized using diverse analytical techniques, and batch experiments of methylene blue (MB) adsorption were performed under various operating conditions. The results indicated that the activated hydrochar (AH) had a larger specific surface area (862.2 m 2  g -1 ) compared to that of its carbonaceous precursor (33.7 m 2  g -1 ). The maximum MB sorption capacity of the hydrochar activated with potassium hydroxide was extremely high (415.8 mg g -1 at 30 °C). In addition, adsorption isotherms and kinetics were studied using experimental data fitting to further understand and describe the dynamic equilibrium, dynamic kinetics, and mechanism of MB adsorption onto the prepared hydrochars. As compared to the Freundlich isotherm model, the Langmuir isotherm model provided a better fit with the experimental data exhibiting a maximum monolayer adsorption capacity of 418.78 mg g -1 . The linear pseudo-second-order kinetic model was found to be suitable for describing the adsorptive kinetics of the hydrochar. The results demonstrated the immense potential of coffee husk waste to produce activated carbon as an alternative green hydrochar that can be applied to dye removal from wastewater as well as improvement of waste management., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 Elsevier B.V. All rights reserved.)

Microbial fuel cells (MFCs) that remove carbon as well as nitrogen compounds out of wastewater are of special interest for practice. We developed a MFC in which microorganisms in the cathode performed a complete denitrification by using electrons supplied by microorganisms oxidizing acetate in the anode. The MFC with a cation exchange membrane was designed as a tubular reactor with an internal cathode and was able to remove up to 0.146 kg NO(3-)-N m(-3) net cathodic compartment (NCC) d(-1) (0.080 kg NO(3-)-N m(-3) total cathodic compartment d(-1) (TCC)) at a current of 58 A m(-3) NCC (32 A m(-3) TCC) and a cell voltage of 0.075 V. The highest power output in the denitrification system was 8 W m(-3) NCC (4 W m(-3) TCC) with a cell voltage of 0.214 V and a current of 35 A m(-3) NCC. The denitrification rate and the power production was limited bythe cathodic microorganisms, which only denitrified significantly at a cathodic electrode potential below 0 V versus standard hydrogen electrode (SHE). This is, to our knowledge, the first study in which a MFC has both a biological anode and cathode performing simultaneous removal of an organic substrate, power production, and complete denitrification without relying on H2-formation or external added power.