Search

The knowledge on potential harmful effects of metallic nanomaterials lags behind their increased use in consumer products and therefore, the safety data on various nanomaterials applicable for risk assessment are urgently needed. In this study, 11 metal oxide nanoparticles (MeOx NPs) prepared using flame pyrolysis method were analyzed for their toxicity against human alveolar epithelial cells A549, human epithelial colorectal cells Caco2 and murine fibroblast cell line Balb/c 3T3. The cell lines were exposed for 24 h to suspensions of 3-100 μg/mL MeOx NPs and cellular viability was evaluated using. Neutral Red Uptake (NRU) assay. In parallel to NPs, toxicity of soluble salts of respective metals was analyzed, to reveal the possible cellular effects of metal ions shedding from the NPs. The potency of MeOx to produce reactive oxygen species was evaluated in the cell-free assay. The used three cell lines showed comparable toxicity responses to NPs and their metal ion counterparts in the current test setting. Six MeOx NPs (Al2O3, Fe3O4, MgO, SiO2, TiO2, WO3) did not show toxic effects below 100 µg/mL. For five MeOx NPs, the averaged 24 h IC50 values for the three mammalian cell lines were 16.4 µg/mL for CuO, 22.4 µg/mL for ZnO, 57.3 µg/mL for Sb2O3, 132.3 µg/mL for Mn3O4 and 129 µg/mL for Co3O4. Comparison of the dissolution level of MeOx and the toxicity of soluble salts allowed to conclude that the toxicity of CuO, ZnO and Sb2O3 NPs was driven by release of metal ions. The toxic effects of Mn3O4 and Co3O4 could be attributed to the ROS-inducing ability of these NPs. All the NPs were internalized by the cells according to light microscopy studies but also proven by TEM, and internalization of Co3O4 NPs seemed to be most prominent in this aspect. In conclusion, this work provides valuable toxicological data for a library of 11 MeOx NPs. Combining the knowledge on toxic or non-toxic nature of nanomaterials may be used for safe-by-design approach.

This paper reports data on the relative ability of CaO, CaCl2, MgO, MgCl2, TiO2, and hectorite (SHCa-1) to induce oxidative stress (as determined by lipid peroxidation, LP) in biological matrices. The effectiveness of structural (oxide form) versus soluble Ca and Mg to induce LP is compared. An assessment on cytotoxicity as affected by soluble and structural Ca, Mg, TiO2 and SHCa-1 is also addressed. LP was screened and monitored using the Thiobarbituric Acid Reactive Substances (TBARS). The extent of TBARS production was found to vary with the type and initial concentration of the soluble or structural cation, Ca or Mg respectively. Obtained results showed higher magnitude values for the latter set of experiments. In the presence of TiO2 no significant TBARS production was detected pointing out a negligible effect of TiO2 on LP. At solid concentrations ca. 100 ppm, CaO appears to be more effective than SHCa-1 to induce LP. By contrast at ca. 25 ppm, MgO appears to be more effective than the clay mineral. The SHCa-1 LP-inducing activity has been proven to closely relate to structural Ca. The prevalence of mechanisms that may induce LP but not cytotoxicity (as determined by cell growth inhibition) was also addressed. Results on cell growth inhibition as affected by soluble and structural Ca, Mg, TiO2 and hectorite provide evidence to support that structural Ca or Mg brings about significantly higher variations than soluble Ca., (Copyright © 2010 Elsevier Ltd. All rights reserved.)

The dermal absorption potential of a nanocrystalline magnesium oxide (MgO) and titanium dioxide (TiO(2)) mixture in dermatomed human skin was assessed in vitro using Bronaugh-type flow-through diffusion cells. Nanocrystalline material was applied to the skin surface at a dose rate of 50 mg/cm(2) as a dry powder, as a water suspension, and as a water/surfactant (sodium lauryl sulfate) suspension, for 8 hours. Dermal absorption of nanocrystalline MgO and TiO(2) through human skin with intact, functional stratum corneum was not detectable under the conditions of this experiment.

Background: The current hard tissue implants research aims to accelerate bone healing by designing surfaces that are bioactive. However, the role of the inflammatory response to these surfaces is so far incompletely described., Purpose: The aim of the study was to evaluate early inflammatory response in vitro to a potentially bioactive surface--an anodized surface with Mg ions incorporated (anodized/Mg)--and to compare it to a turned, a blasted, and an anodized surface., Materials and Methods: An interferometer was used for topographical characterizations. The disks were incubated with human mononuclear cells. Adherent cells were investigated with respect to number of cells, viability, differentiation, and cytokine production with and without lipopolysaccharide stimulation after 24 and 72 hours., Results: The number of adhered mononuclear cells differed significantly between the different modified surfaces, with the highest number on the anodized surface. However, there were no significant differences in cytokine production and differentiation between the different modified surfaces. The amount of anti-inflammatory mediator interleukin-10 remained over time, while the number of cells and pro-inflammatory cytokine tumor necrosis factor-alpha decreased. The cells were viable on all surfaces, respectively., Conclusion: The anodized surfaces with and without Mg ions showed an increased cell adherence, however, otherwise an inflammatory response similar to the turned and blasted surfaces. Furthermore, the potentially bioactive anodized/Mg surface showed a similar response to the TiUnite-like anodized surface despite the former having a surface roughness of a smoother character.