Search

Trifluoroacetic acid (TFA) is released in the atmosphere through its use in the chemical industry and as degradation product of chlorofluorocarbon (CFC) alternatives like hydrofluorocarbons and hydrochlorofluorocarbons. In the present study, we have investigated the OH formation dynamics in the photodissociation of TFA at 193 nm by Laser Photolysis-Laser Induced Fluorescence (LP-LIF) method, as well as stable product formation by GC MS and FTIR. It was found that, ∼26% of the available energy is partitioned into the relative translation of the photoproducts (f(T) = 0.26), which could be explained by presence of an exit barrier of ∼13 kcal/mol in OH formation channel. This result is very similar to OH formation from acetic acid (AA) and difluoroacetic acid (DFA), indicating fluorination at the side chain of aliphatic carboxylic acids does not significantly change the mechanism of C OH bond scission. Our experimental results tallied with the theoretical studies, which suggested that the major OH formation channel in acetic acid and fluoroacetic acid is direct dissociation from the optically excited S1 state through an exit barrier, with some competition from the T1 state. However, quantum yield of OH formation from TFA (0.4) was found to be much smaller than AA (0.8), which is probably caused by higher reaction barrier in T1 state of TFA, compared to AA. CHF3, C2F4, C2F6, CO2, CO, CF3CFO, CF2O and hexafluoropropylene oxide (HFPO) were detected as the stable products of the photolysis of TFA. The theoretically optimized ground state dissociation channels showed significant difference between TFA and AA.

Photodissociation of 2-chloro-6-nitrotoluene (ClNT) at 193, 248 and 266 nm and nitrocyclopentane (NCP) at 193 nm leads to the formation of OH, as detected by laser-induced fluorescence (LIF). The nascent OH produced from the photolysis of ClNT at all the wavelengths is vibrationally cold, with the Boltzmann type rotational state distributions. However, the nascent OH product from NCP is in the ground and vibrationally excited states with the measured average relative population in ν ″ = 1 to that in ν ″ = 0 of 0.12 ± 0.03, and these levels are characterized by rotational temperatures of 650 ± 180 K and 1570 ± 90 K, respectively. The translational energy partitioned in the OH fragment has been measured for photodissociation of both ClNT and NCP. On the basis of both the experimental results and the ground state molecular orbital (MO) calculations, a plausible mechanism for the OH formation has been proposed.

The photodissociation dynamics of benzoyl chloride at 235 nm has been investigated and compared with that of 2-furoyl chloride. Atomic Cl and molecular HCl channels have been detected in benzoyl chloride by employing resonance-enhanced multiphoton ionization technique and time-of-flight mass spectrometry. Both the Cl fragments, Cl((2)PJ=3/2, relative quantum yield 0.70 ± 0.15) and Cl*((2)PJ=1/2), show isotropic angular distribution and bimodal translational energy distributions. The predominant high kinetic energy channel contributes 72% to the C-Cl bond scission and arises from the S1 state having nπ* character of benzoyl chloride. However, the low-energy Cl and HCl channels originate from the ground electronic state. The most plausible mechanism of HCl formation is proposed based on molecular orbital calculations. In contrast to benzoyl chloride, the HCl channel is not observed in 2-furoyl chloride on excitation at 235 nm, and this is attributed to an energy constraint.

Oxidative destruction and mineralization of emerging organic pollutants by hydroxyl radicals (˙OH) is a well established area of research. The possibility of generating hazardous by-products in the case of ˙OH reaction demands extensive investigations on the degradation mechanism. A combination of pulse radiolysis and steady state photolysis (H2O2/UV photolysis) followed by high resolution mass spectrometric (HRMS) analysis have been employed to explicate the kinetic and mechanistic features of the destruction of theophylline, a model pharmaceutical compound and an identified pollutant, by ˙OH in the present study. The oxidative destruction of this molecule, for intermediate product studies, was initially achieved by H2O2/UV photolysis. The transient absorption spectrum corresponding to the reaction of ˙OH with theophylline at pH 6, primarily caused by the generation of (T8-OH)˙, was characterised by an absorption band at 330 nm (k2 = (8.22 ± 0.03) × 10(9) dm(3) mol(-1) s(-1)). A significantly different spectrum (λmax: 340 nm) was observed at highly alkaline pH (10.2) due to the deprotonation of this radical (pKa∼ 10.0). Specific one electron oxidants such as sulphate radical anions (SO4˙(-)) and azide radicals (N3˙) produce the deprotonated form (T(-H)˙) of the radical cation (T˙(+)) of theophylline (pKa 3.1) with k2 values of (7.51 ± 0.04) × 10(9) dm(3) mol(-1) s(-1) and (7.61 ± 0.02) × 10(9) dm(3) mol(-1) s(-1) respectively. Conversely, oxide radicals (O˙(-)) react with theophylline via a hydrogen abstraction protocol with a rather slow k2 value of (1.95 ± 0.02) × 10(9) dm(3) mol(-1) s(-1). The transient spectral studies were complemented by the end product profile acquired by HRMS analysis. Various transformation products of theophylline induced by ˙OH were identified by this technique which include derivatives of uric acids (i, ivv) and xanthines (ii, iiivi). Further breakdown of the early formed product due to ˙OH attack leads to ring opened compounds (ix-xiv). The kinetic and mechanistic data furnished in the present study serve as a basic frame work for the construction of ˙OH induced water treatment systems as well as to understand the biological implications of compounds of this kind.

The photodissociation dynamics of 2-bromo-2-chloro-1,1,1-trifluoroethane (halothane) have been studied near 234 nm, in a molecular beam environment, employing resonance-enhanced multiphoton ionization with time-of-flight mass spectrometer (REMPI-TOF-MS). Both bromine and chlorine atoms are detected in both the ground and spin–orbit excited states. The C–Br bond scission is observed predominantly due to direct σ∗(C–Br) ← n(Br) transition, with translational energy distribution described with a soft impulsive model. The recoil anisotropy parameter (β) of 0.6 ± 0.2 for this channel vindicates the impulsive nature of dissociation. The diabatic crossing from the nσ∗(C–Br) surface to nσ∗(C–Cl) diabatic surface is responsible for chlorine formation via the C–Cl bond fission, which is supported by the excited state molecular orbital calculations. The velocity distribution of bromine atom has one component, however, that of chlorine atom is bimodal. Both fast and slow chlorine atom channels, with the β value of 0.3 ± 0.1, are produced impulsively from the nσ∗(C–Cl) repulsive surface.

The photodissociation dynamics of 2-furoyl chloride at 235 nm has been investigated, employing resonance-enhanced multiphoton ionization technique and time-of-flight mass spectrometry. Both the Cl fragments, Cl( 2 P J= 3/2 , relative quantum yield 0.85 ± 0.11) and Cl ∗ ( 2 P J =1/2 ), have the recoil anisotropy parameter ( β ) value close to zero, and show bimodal translational energy distributions. The branching ratio of the high kinetic energy C Cl bond scission to the low energy C Cl scission is 0.78/0.22. The dominant high kinetic energy channel arises mainly because of electronic pre-dissociation. But, the low energy channel results from the ground electronic state of 2-furoyl chloride, formed subsequent to non-radiative relaxation of the initially prepared excited state.

The photodissociation dynamics of halogen-substituted thiophenes, namely, 2-chlorothiophene and 2-bromo-5-chlorothiophene, has been studied in a supersonic molecular beam around 235 nm, using resonance enhanced multiphoton ionization (REMPI) time-of-flight (TOF) technique, by detecting the nascent state of the primary halogen atoms. A single laser has been used for excitation of halothiophenes, as well as for the REMPI detection of photoproducts, namely, chlorine and bromine atoms, in their spin-orbit states X((2)P(3/2)) and X*((2)P(1/2)). We have determined the translational energy distribution, the recoil anisotropy parameter, β, and the spin-orbit branching ratio, for chlorine and bromine atom elimination channels. State-specific TOF profiles are converted into kinetic energy distributions, using a least-squares fitting method, taking into account the fragment anisotropies, β(ι). The TOF profiles for Cl, Cl*, Br, and Br* are found to be independent of laser polarization; i.e., the β is well characterized by a value of ~0.0, within the experimental uncertainties. For 2-chlorothiophene, we have observed two components for the Cl and only one component for the Cl* atom elimination channel in the translational energy distributions. The average translational energies for the fast and the slow components of the Cl channel are 3.0 ± 1.0 and 1.0 ± 0.5 kcal/mol, respectively. For Cl*, the average translational energy is 3.5 ± 1.0 kcal/mol. For 2-bromo-5-chlorothiophene, we have observed only one component for Cl, Cl*, Br, and Br* in the translational energy distributions. The average translational energies for the Cl and Cl* channels are 3.5 ± 1.0 and 5.0 ± 1.0 kcal/mol, respectively, whereas the average translational energies for the Br and Br* channels are 2.0 ± 1.0 and 3.5 ± 1.0 kcal/mol, respectively. The energy partitioning into the translational modes is interpreted with the help of various models, such as impulsive and statistical models. The ΔH(f)(298) value for 2-chlorothiophene has been estimated theoretically to be 23.5 kcal/mol.

Photoexcitation of 2-bromo-2-nitropropane (BNP) at 248 and 193 nm generates OH, Br, and NO(2) among other products. The OH fragment is detected by laser-induced fluorescence spectroscopy, and its translational and internal state distributions (vibration, rotation, spin-orbit, and Λ-doubling components) are probed. At both 248 and 193 nm, the OH fragment is produced translationally hot with the energy of 10.8 and 17.2 kcal∕mol, respectively. It is produced vibrationally cold (v" = 0) at 248 nm, and excited (v" = 1) at 193 nm with a vibrational temperature of 1870 ± 150 K. It is also generated with rotational excitation, rotational populations of OH(v" = 0) being characterized by a temperature of 550 ± 50 and 925 ± 100 K at 248 and 193 nm excitation of BNP, respectively. The spin-orbit components of OH(X(2)Π) are not in equilibrium on excitation at 193 nm, but the Λ-doublets are almost in equilibrium, implying no preference for its π lobe with respect to the plane of rotation. The NO(2) product is produced electronically excited, as detected by measuring UV-visible fluorescence, at 193 nm and mostly in the ground electronic state at 248 nm. The Br product is detected employing resonance-enhanced multiphoton ionization with time-of-flight mass spectrometer for better understanding of the dynamics of dissociation. The forward convolution analysis of the experimental data has provided translational energy distributions and anisotropy parameters for both Br((2)P(3∕2)) and Br∗((2)P(1∕2)). The average translational energies for the Br and Br∗ channels are 5.0 ± 1.0 and 6.0 ± 1.5 kcal∕mol. No recoil anisotropies were observed for these products. Most plausible mechanisms of OH and Br formation are discussed based on both the experimental and the theoretical results. Results suggest that the electronically excited BNP molecules at 248 and 234 nm relax to the ground state, and subsequently dissociate to produce OH and Br through different channels. The mechanism of OH formation from BNP on excitation at 193 nm is also discussed.

Cyclohexanone oxime (CHO) and cyclopentanone oxime (CPO) in the vapor phase undergo N-OH bond scission upon excitation at 193 nm to produce OH, which was detected state selectively employing laser-induced fluorescence. The measured energy distribution between fragments for both oximes suggests that in CHO the OH produced is mostly vibrationally cold, with moderate rotational excitation, whereas in CPO the OH fragment is also formed in v'' = 1 (~2%). The rotational population of OH (v'' = 0, J'') from CHO is characterized by a rotational temperature of 1440 ± 80 K, whereas the rotational populations of OH (v'' = 0, J'') and OH (v'' = 1, J'') from CPO are characterized by temperatures of 1360 ± 90 K and 930 ± 170 K, respectively. A high fraction of the available energy is partitioned to the relative translation of the fragments with f(T) values of 0.25 and 0.22 for CHO and CPO, respectively. In the case of CHO, the Λ-doublet states of the nascent OH radical are populated almost equally in lower rotational quantum levels N'', with a preference for Π(+) (A') states for higher N''. However, there is no preference for either of the two spin orbit states Π(3/2) and Π(1/2) of OH. The nascent OH product in CPO is equally distributed in both Λ-doublet states of Π(+) (A') and Π(-) (A'') for all N'', but has a preference for the Π(3/2) spin orbit state. Experimental work in combination with theoretical calculations suggests that both CHO and CPO molecules at 193 nm are excited to the S(2) state, which undergoes nonradiative relaxation to the T(2) state. Subsequently, molecules undergo the N-OH bond dissociation from the T(2) state with an exit barrier to produce OH (v'', J'').