Search

Lighter doping, pretreatment (exposure to hydrogen in a steam bath), and lower dose rate are each found to exacerbate 10-keV X-ray-induced negative frequency shifts and increase in resistivity measured in T-shaped, asymmetric, piezoresistive, micromachined, and resonating cantilevers. All devices recover to levels close to preirradiation after several hours of postirradiation annealing. The effects are attributed to dose-rate-dependent efficiencies of the depassivation of dopants by hydrogen and surface charging effects, which alter the effective Young’s modulus and shear elastic constants. Increases in resistivity are attributed to increases in scattering causing decreases in mobility. Results indicate the need to consider dopant type and concentration when choosing microelectromechanical systems for use in radiation environments in addition to accounting for low-dose-rate effects. [ABSTRACT FROM AUTHOR]

Total-ionizing-dose-induced resonance frequency shifts in piezoresistive micromachined cantilevers are experimentally shown to be dose-rate dependent. Devices were irradiated to 1 Mrad(SiO2) at rates from 5.4 to 30.3 krad(SiO2)/min, with lower rate exposures producing up to four-times more negative frequency shifts than higher rate exposures. Devices that were hydrogenated in a steam bath for 1 h showed shifts similar to those of control (not hydrogenated) devices at higher dose rates, and larger shifts than control devices at lower rates. All devices recovered to levels close to preirradiation after several hours of post-irradiation annealing. The dose-rate dependence is attributed to differences in carrier concentration caused by varying efficiencies of the depassivation of boron by hydrogen at higher and lower dose rates and/or surface charging effects, and the subsequent differences in Young’s modulus that occur as a result. Many of these processes are similar to effects that lead to ELDRS in linear bipolar transistors, emphasizing the need to include low-dose-rate testing of microelectromechanical systems devices when considering them for use in space systems. [ABSTRACT FROM PUBLISHER]

The response of silicon-based microelectromechanical systems resonators to proton irradiation is determined by the combined effects of displacement damage and total ionizing dose (TID). Displacement damage (DD) can lead to carrier removal, which tends to decrease the carrier concentration, and TID leads to dopant activation and/or surface charging effects, which tend to increase the carrier concentration. These competing effects lead to changes in carrier concentration that alter Young’s modulus, and consequently the resonance frequency. For higher flux 2-MeV proton irradiation to 1014/cm2, TID effects dominate at low fluence, leading to a decrease in resonance frequency, which is offset by displacement damage effects at higher fluence. Fast recovery is observed as TID effects anneal out and DD effects remain. For lower-flux 0.8-MeV proton irradiation to 7 \times 10^12 /cm2, DD effects are relatively more significant than for 2-MeV proton irradiation, and an increase in resonance frequency is observed at all fluences. Stopping and range of ions in matter calculations reinforce these conclusions. [ABSTRACT FROM PUBLISHER]