Search

The essential structural features of lithium-metal phosphates (LMP) have been studied using FTIR spectroscopy which is a sensitive tool to probe the local environment in the solid materials. Various LMP materials where M is iron have been investigated including phospho-olivine LiFePO(4), diphosphate LiFeP(2)O(7), Nasicon-type phosphate Li(3)Fe(2)(PO(4))(3) and dihydrate FePO(4).2H(2)O. Vitreous and amorphous materials are also considered. Analysis of internal and external modes of vibration allows to distinguish between the different phases and the type of cationic environment in the framework. Results corroborate the contribution of the main factors which are responsible for the complexity of the spectra, i.e. departure from ideal symmetry, interactions between polyhedra, bridging atoms and lattice distortion.

We measured susceptibility, electron-spin resonance, magnetization and electrical conductivity of LiCo1−yNiyO2 powders synthesized by wet-chemistry method using succinic acid as chelating agent. We found unusual properties in the nickel-rich LiCo0.2Ni0.8O2, which shows several resonance lines as a function of the temperature in the range 3.5–300 K. The signal at low magnetic field is attributed to the magnetic domains in the nanostructured sample. The two other lines correspond to the typical ferromagnetic signal observed in powdered compounds. In the temperature range 120–300 K, the unique ESR line centered at 315 mT is the paramagnetic signal with a gyromagnetic factor g=2.12, which is in good agreement with the presence of a high concentration of Ni3+ (3d7) ions. In the nickel-rich oxide, LiNi0.8Co0.2O2, the magnetic data are qualitatively well-described by the model proposed by Drillon and Panissod for a 3D ferromagnetic order. [Copyright &y& Elsevier]

Abstract: The structural properties of LiFePO4 prepared by the hydrothermal route and chemically delithiated have been studied using analytical electron microscopy and Raman spectroscopy. High-resolution transmission electron microscopy and selected area electron diffraction measurements indicate that the partially delithiated particles include LiFePO4 regions with cross-sections of finite size along the ac-plane, as a result of tilt grain boundary in the bc-plane, and dislocations in other directions. Only the boundary along the bc-plane is accompanied by a disorder over about 2nm on each side of the boundary. The Raman spectrum shows the existence of both LiFePO4 and FePO4 phases in the shell of the particles at a delithiation degree of 50%, which invalidates the core–shell model. This result also invalidates the recent model according to which each particle would be single-domain, i.e. either a LiFePO4 particle or a FePO4 particle. On the other hand, our results, like prior ones, can be understood within the framework of a model similar to the spinodal decomposition of a two-phase system, which is discussed within the framework of morphogenesis of patterns in systems at equilibrium. Both end-members, however, are well crystallized, suggesting a recovery similar to that observed in superplastic alloys, with dynamics that are due to the motion of nucleation fronts and dislocations, and not due to a diffusion phenomenon associated with a concentration gradient. [Copyright &y& Elsevier]

Abstract: A series of LiNi1/3Mn1/3Co1/3O2 samples with α-NaFeO2 structure belonging to the D3d 5 space group were synthesized using tartaric acid as a chelating agent by wet-chemical method. Different acid to metal-ion ratios R have been used to investigate the effect of this parameter on the physical and electrochemical properties. We have characterized the reaction mechanism, the structure, and morphology of the powders by TGA, XRD, SEM and TEM imaging, completed by magnetic measurements, Raman scattering spectroscopy, and complex impedance experiments. We find that the LiNi1/3Mn1/3Co1/3O2 sintered at 900°C for 15h with an acid to metal-ion ratio R =2 was the optimum condition for this synthesis. For this optimized sample, only 1.3% of nickel-ions occupied the 3b Wyckoff site of the lithium-ions sublattice. The electrochemical performance has been investigated using a coin-type cell containing Li metal as the anode. The electronic performance is correlated to the concentration of the Ni(3b) defects that increase the charge transfer resistance and reduce the lithium diffusion coefficient. The optimized cell delivered an initial discharge capacity of 172mAhg−1 in the cut-off voltage of 2.8–4.4V, with a coulombic efficiency of 93.4%. [ABSTRACT FROM AUTHOR]

Abstract: A novel lithium iron phosphate has been synthesized by a solution route at moderate temperature. The structure was determined from powder by XRD, HRTEM and SAED experiments. LiFe2P3O10 tripolyphosphate crystallizes in the monoclinic system, space group P21 /m, with lattice constants a =4.597(7)Å, b =8.566(4)Å, c =9.051(4)Å, β =97.47° and Z =2. Internal and external vibrational modes (Raman and FTIR) show that the dominant spectral features come from the (P3O10)5− oxo-anions displaying internal and external modes along with the P–O–P bridging modes. Magnetic measurements are consistent with the high-spin configuration of Fe2+ cation with an effective magnetic moment 5.51μB. A weak antiferromagnetic ordering is observed below the Néel temperature at T N =19K. Electron paramagnetic resonance spectroscopy confirms this electronic configuration and provides evidence of the presence of a carbonaceous layer onto the particle surface. Electrochemical measurements were carried out in lithium cells with LiPF6–EC–DEC electrolyte at 25°C. The material delivered a capacity 70mAh/g in the voltage range 2.7–3.9V, close to the theoretical value (72mAh/g). The resulting cyclic voltammogram indicates a stable structure with a good reversibility with the redox peaks at 3.26 and 3.13V vs. Li0/Li+. [Copyright &y& Elsevier]

Abstract: A series of LiMn y Fe1−y PO4 samples have been prepared in the whole range 0≤ y ≤1. Chemical delithiation could be achieved to obtain Mn y Fe1−y PO4 in the range 0≤ y ≤0.8, keeping the same crystal phase (olivine structure, space group Pnma). The composition y =0.8 is the limit where the delithiated phase is still crystallized, but abruptly suffers strains at the molecular scale evidenced by both optical spectroscopy and X-ray diffraction. The analysis of the magnetic properties shows that in all the samples the concentration of impurities is negligible. The concentration of polarons, either holes associated to Li vacancies in LiMn y Fe1−y PO4 or electrons associated to the existence of Li left in the matrix of Mn y Fe1−y PO4, is found to be small (≤1%) in all the samples. For y ≤0.6, all the Mn3+ ions Mn y Fe1−y PO4 are in the high-spin state (S =2). At larger manganese concentration, however, the Mn3+ ions in excess of the critical concentration y c =0.6 undergo a transition to the low-spin state (S =1). As a consequence, and in contrast with prior works, we find that Mn0.8Fe0.2PO4 has magnetic interactions that are much smaller, and no antiferromagnetic ordering in this compound is detected, at least above 20K. Antiferromagnetic ordering that had been reported so far for Mn y Fe1−y PO4 at large y-composition might come from incomplete delithiation. The spin-transition of Mn3+ in concentration (y–y c) to the low-spin state is at the origin of the strain fields at the molecular scale that increase with y for y >0.6, and ultimately prevents the full delithiation for y >0.8. This result sheds light on the reason for the degradation of cathode properties in Mn-rich compounds of the heterosite–purpurite series, while the electrochemical properties are good in the range y ≤0.6 but only at slow rates, due to the very small hopping mobility of the small polaron. [Copyright &y& Elsevier]

Abstract: The effect of H2O on carbon-coated LiFePO4 particles was investigated by chemical analysis, structural analysis (X-ray diffraction, SEM, TEM), optical spectroscopy (FTIR, Raman) and magnetic measurements. Upon immersion in water, part of the product floats while the main part sinks. Both the floating and the sinking part have been analyzed. We find that the floating and sinking part only differ by the amount of carbon that partly detaches from the particles upon immersion in water. Exposure to H2O results in rapid attack, within minutes, of the surface layer of the particles, because the particles are no longer protected by carbon. The deterioration of the carbon coat is dependent on the synthesis process, either hydrothermal or solid-state reaction. In both cases, however, the carbon coat is permeable to water and fails to protect the surface of the LiFePO4 particles. The consequence is that this immersion results in the chemical attack of LiFePO4, but is restricted to the surface layer of the particles (few nanometers-thick). In case the particles are simply exposed to humid air, the carbon coat protects the particles more efficiently. In this case, the exposure to H2O mainly results in the delithiation of the surface layer, due to the hydrophilic nature of Li, and only the surface layer is affected, at least for a reasonable time of exposure to humid air (weeks). In addition, within this timescale, the surface layer can be chemically lithiated again, and the samples can be dried to remove the moisture, restoring the reversible electrochemical properties. [Copyright &y& Elsevier]