Search

Lighter doping, pretreatment (exposure to hydrogen in a steam bath), and lower dose rate are each found to exacerbate 10-keV X-ray-induced negative frequency shifts and increase in resistivity measured in T-shaped, asymmetric, piezoresistive, micromachined, and resonating cantilevers. All devices recover to levels close to preirradiation after several hours of postirradiation annealing. The effects are attributed to dose-rate-dependent efficiencies of the depassivation of dopants by hydrogen and surface charging effects, which alter the effective Young’s modulus and shear elastic constants. Increases in resistivity are attributed to increases in scattering causing decreases in mobility. Results indicate the need to consider dopant type and concentration when choosing microelectromechanical systems for use in radiation environments in addition to accounting for low-dose-rate effects. [ABSTRACT FROM AUTHOR]

Total-ionizing-dose-induced resonance frequency shifts in piezoresistive micromachined cantilevers are experimentally shown to be dose-rate dependent. Devices were irradiated to 1 Mrad(SiO2) at rates from 5.4 to 30.3 krad(SiO2)/min, with lower rate exposures producing up to four-times more negative frequency shifts than higher rate exposures. Devices that were hydrogenated in a steam bath for 1 h showed shifts similar to those of control (not hydrogenated) devices at higher dose rates, and larger shifts than control devices at lower rates. All devices recovered to levels close to preirradiation after several hours of post-irradiation annealing. The dose-rate dependence is attributed to differences in carrier concentration caused by varying efficiencies of the depassivation of boron by hydrogen at higher and lower dose rates and/or surface charging effects, and the subsequent differences in Young’s modulus that occur as a result. Many of these processes are similar to effects that lead to ELDRS in linear bipolar transistors, emphasizing the need to include low-dose-rate testing of microelectromechanical systems devices when considering them for use in space systems. [ABSTRACT FROM PUBLISHER]

We evaluate the response of T-shaped, asymmetric, piezoresistive, micromachined cantilevers fabricated on p-type Si to 10-keV X-ray irradiation. The resonant frequency decreases by 25 ppm at 2.1 Mrad(SiO2), and partially recovers during post-irradiation annealing. An explanation of the results is proposed that is based on radiation-induced acceptor depassivation. This occurs because radiation-generated holes release hydrogen from previously passivated acceptors, causing the carrier concentration to increase, especially near the surface. Increased carrier concentration decreases Young’s modulus, resulting in a decrease in the cantilever resonant frequency. Finite element simulations show that the effect of a decreasing Young’s modulus in the surface region is consistent with the measured decrease in resonant frequency in the irradiated devices. [ABSTRACT FROM PUBLISHER]