Search

This study addresses the comparative pull-out strengths of cortical (4.5 mm) and fully threaded cancellous (6.5 mm) bone screws from sites about the pelvis commonly used in the fixation of posterior column acetabular fractures and sacroiliac (SI) disruptions. These sites include one from lateral to medial through the posterior column, two from posterolateral to anteromedial across the SI joint, one vertically through the sacral ala, and one vertically through the iliopubic column. Statistical analysis showed no significant difference in the force required for pull-out failure of the cortical versus the cancellous screws at any of the sites tested.

Femoral metaphyseal/diaphyseal blood flow was studied by 85Sr clearance in unfractured segments of dog femurs following compression plating and various control procedures (drilling with and without application of screws). The animals were tested as early as seven days and as late as two months after surgery. The only statistically significant change in strontium clearance (SrC) was an increase produced by the application of stainless-steel bone screws, with or without plates. The presence or absence of compression had no consistent effect on changes in the rate of SrC. During the period of study, no changes in bone mineralization, haversian porosity, or cortical bone thickness accompanied the SrC alterations.

The pull-out strength of both cortical and cancellous screws from bone at various sites about cadaveric pelves was examined. No significant differences were seen between cortical or cancellous screws at similar sites with the possible exception of the sacroiliac joint. Pull-out strengths were best correlated to the depth of bone at a particular screw hole. For practical purposes, the strongest sites are in the thick buttress of bone along the iliopubic column.

Changes in radiostrontium clearance (SrC) and bone formation (tetracycline labeling) were observed in the femurs of skeletally mature dogs following the various operative steps involved in bone screw fixation. Drilling, but not periosteal stripping, produced a small but statistically significant increase in SrC and endosteal bone formation in the distal third of the bone. Strontium clearance values equivalent to those produced by drilling alone were recorded after screw fixation at low or high torque (5 versus 20 inch pounds), as well as by the insertion of loosely fitting stainless steel implants. Bone formation (equals the percentage tetracycline-labeled trabecular bone surfaces) was increased by 30% when SrC values exceeded 3.5 ml/100 g bone/min, and the relationship was linear when SrC values ranged between 1.0 and 7.0 ml/100 g bone/min. The changes in SrC and bone formation one-week after bone screw application are primarily those associated with a response to local trauma caused by drilling.