Search

Soil is a heterogeneous material, and its properties are vital from an agricultural perspective and for groundwater management. However, limited studies have been performed on the soil characteristics (soil texture, water-holding capacity, and soil compositions) of a single pumping well, especially in Malaysia. This article focuses on the soil characteristics and elemental analysis of a single borehole with 11 samples collected around Labu Kubong, Perak. The soil properties were analyzed in the context of particle size distribution (PSD) using the laser diffraction method (LDM), as well as soil composition for elemental analysis using a scanning electron microscope coupled with an energy dispersive X-ray (SEM-EDX). The LDM results revealed the average percentage of clay, silt, and sand to be 0%, 6%, and 94%, respectively, indicating most particles comprised sand particles which in percentages demonstrated a sandy texture with less silt content. Additionally, the water holding capacity is low because of major coarse sand particles in alluvial formations. Moreover, SEM-EDX outcomes displayed an average percentage of elemental composition reported as follows: C (40.77%), O (34.33%), Si (10.66%), Al (5.82%), Fe (1.10%), K (1.10%), As (0.05%), Na (0.04%), and Be (5.62%). Consequently, SEM-EDX outcomes showed these elements were derived from silicified quartz, feldspar, and iron-bearing minerals that originated from shale formations, and the presence of carbon indicates peat formation. Therefore, this study provides information on a single pumping well from an irrigation practice, and this study also recommends regional to global scale studies for supporting sustainable groundwater development worldwide. [ABSTRACT FROM AUTHOR]

Pandanus amaryllifolius is a member of Pandanaceae family and is abundant in south-east Asian countries including Malaysia, Thailand, Indonesia and India. In this study, Pandanus amaryllifolius fibres were extracted via a water retting extraction process and were investigated as potential fibre reinforcement in polymer composite. Several tests were carried out to investigate the characterization of Pandanus amaryllifolius fibre such as chemical composition analysis which revealed Pandanus amaryllifolius fibre's cellulose, hemicellulose and lignin content of 48.79%, 19.95% and 18.64% respectively. Material functional groups were analysed by using Fourier transform infrared (FTIR) spectroscopy and X-ray diffraction analysis confirming the presence of cellulose and amorphous substances in the fibre. The morphology of extracted Pandanus amaryllifolius fibre was studied using a scanning electron microscope (SEM). Further mechanical behaviour of fibre was investigated using a single fibre test with 5 kN cell load and tensile strength was found to be 45.61 ± 16.09 MPa for an average fibre diameter of 368.57 ± 50.47 μm. Meanwhile, moisture content analysis indicated a 6.00% moisture absorption rate of Pandanus amaryllifolius fibre. The thermogravimetric analysis justified the thermal stability of Pandanus amaryllifolius fibre up to 210 °C, which is within polymerization process temperature conditions. Overall, the finding shows that Pandanus amaryllifolius fibre may be used as alternative reinforcement particularly for a bio-based polymer matrix. [ABSTRACT FROM AUTHOR]