Search

The effect of process scale-up from 4 to 400-L high-shear granulator on the release kinetics of the active ingredient from pharmaceutical granules has been investigated. The dissolution and disintegration rates of the granules were measured simultaneously by the combination of UV/vis spectroscopy and static light scattering. The granule batches were found to consist of sub-populations with qualitatively different dissolution behavior: "weaker" granules that disintegrated during dissolution, and "stronger" granules that retained their size and from which the active ingredient was gradually leached. The existence of these sub-populations was attributed to non-uniform distribution of normal and shear forces that prevail in granulators of different size. This hypothesis was confirmed by preparing granules at increasing values of the Froude number at the 4-L scale, and observing a transition from the break-up dissolution mode to the leaching dissolution mode with increasing granule densification. The simultaneous observation of solute concentration and particle size distribution during granules dissolution proved to be a useful tool for the understanding of dissolution mechanisms and for identifying non-uniformities of process conditions that can occur during scale-up., (Copyright © 2016 Elsevier B.V. All rights reserved.)

Alaptide is the active substance of the veterinary dermatological ointment ALAPTID and a potential drug in human medicine. Electronic circular dichroism spectroscopy (ECD), transparent spectral region optical rotation (OR), and ab initio calculations were employed to determine the absolute configuration of alaptide. No X-ray structural data determining the absolute configuration were available. It was not possible to employ vibrational circular dichroism spectroscopy (VCD), because alaptide was not sufficiently soluble in common solvents used in VCD spectroscopy to generate reliable spectra. Both ECD spectra and OR values of alaptide solution were in good agreement with predicted data and determined unambiguously the absolute configuration of alaptide synthesized from (S)-alanine as being (S)., (Copyright (c) 2010 Elsevier B.V. All rights reserved.)

Two series of amides based on quinoline scaffold were designed and synthesized in search of photosynthesis inhibitors. The compounds were tested for their photosynthesis-inhibiting activity against Spinacia oleracea L. and Chlorella vulgaris Beij. The compounds lipophilicity was determined by the RP-HPLC method. Several compounds showed biological activity similar or even higher than that of the standard (DCMU). The structure-activity relationships are discussed.

The method for the determination of biotin by high performance liquid chromatography (HPLC) coupled with coulometric detector is presented here. Chromatographic and detection conditions were tested. A LiChrospher 60RP-select B column (250 mm x 4 mm; 5 microm) and the mobile phase containing 0.24 mol/L aqueous solution of acetic acid and acetonitrile in the ratio 85:15 (v/v) were found as the most suitable. The flow rate was 1 mL/min and the injected volume of the sample was 20 microL. The hydrodynamic voltammogram of biotin was measured and according to obtained data the detection parameters were set--channel I 600 mV, channel II 900 mV, sensitivity 1 microA. The developed method has been validated. The calibration curve is linear in the range 15-3600 ng/mL, correlation coefficient is 0.9998, limits of detection and quantification are 5 and 15 ng/mL, respectively. Recovery of the spiked samples was 98.67% with R.S.D. 0.255% on average. The developed method has been successfully applied for determination of biotin in pharmaceutical preparations.

A new reversed-phase liquid chromatographic method using zirconia-based stationary phase was developed for determination of ibuprofen, its related compounds and its main degradation products. The chromatographic separation was successfully achieved on the Discovery Zr-PS column (150 mm x 4.6 mm i.d., 5 microm), using a mobile phase methanol-phosphate buffer (pH 4.5; 0.05 M)-tetrahydrofurane (21:74:5, v/v/v) and the flow rate 0.5 ml min(-1). The UV detection was performed in dual wavelength mode (219 and 258 nm) to detect all compounds of interest. The column temperature was set on 60 degrees C to shorten the analysis time and improve the peak symmetry. The method is simple, rapid and cuts down the amount of hazardous waste produced in the analysis. The assay is completed within 22 minutes.

The stability of ramipril in the buffer solution with different pH and the influence of acid, alkaline and oxidative medium on ramipril stability were studied. The ramipril degradation products were determined by high-performance liquid chromatography (HPLC) method. Acetonitrile:sodium perchlorate was used as the mobile phase, at a flow rate of 1.0 ml/min (linear gradient elution). A Nucleosil 100-S 5 microm C18, 250 mm x 4.6 mm i.d. was utilized as stationary phase. Detection was affected spectrophotometrically at 210 nm. The drug substance was dissolved in the ammonium phosphate buffer (pH 3, 5 and 8) and these solutions were stored at 90 degrees C for 1 h. The other series of test solutions were prepared from stock solution (drug substance dissolved in solvent A of the mobile phase) by dilution in acid (0.1M HCl), alkaline (0.1M NaOH) and oxidative (hydrogen peroxide solution) medium. More then 0.2% of impurity D (ramipril-diketopiperazine) was detected in the buffer of pH 3 and pH 5. In the buffer of pH 8 there was detected more then 1% of impurity E (ramipril-diacid). No peaks for degradation products appeared in the chromatograms above limit of quantification. The alkaline medium has the greatest effect on degradation of ramipril into impurity E (more than 50%).

Glimepiride is a modern hypoglycaemic agent, which belongs to the group of sulfonylurea derivates. In this paper, simple, specific and accurate RP-HPLC method was developed in order to study decomposition of glimepiride under the hydrolytic stress conditions (acid, neutral, alkaline and oxidative). The best separation of glimepiride and its degradation products was achieved on reverse phase C18 column. The mobile phase was composed of acetonitrile-phosphate buffer (pH 3.5, 0.03 M) (48:52, v/v). Employing RP-HPLC method, five main degradation products were detected in the exposed samples. It was found that the susceptibility of glimepiride to hydrolytic decomposition increased in following manner: neutral condition < alkaline condition < acid condition < oxidative condition.

A method for the determination of sulphated glycosaminoglycans is based on their precipitation with (1-ethoxycarbonyl)pentadecyltrimethylammonium bromide (Septonex), the excess of which is back-titrated with sodium tetraphenylborate. The titration is monitored by a simple coated-wire ion-selective electrode with a plasticized poly(vinyl chloride) membrane on aluminium wire. Under certain conditions the results are almost independent of the relative molecular mass of glycosaminoglycans. The method has been applied to the determination of the active ingredient in the pharmaceutical preparation, heparon injection.