Search

This study examined the influence of consumer behavior on furan, 2-methylfuran, 3-methylfuran, 2,5-dimethylfuran and 2,3-dimethylfuran exposure in coffee. Coffees brewed using a filter, fully automatic, capsule machine or reconstituted instant coffee were found to have a significant different cup concentrations of furan derivatives. Coffee brewed with the fully automatic machine contained the highest furan and furan derivative concentrations (99.05 µg/L furan, 263.91 µg/L 2-methylfuran, 13.15 µg/L 3-methylfuran and 8.44 µg/L 2,5-dimethylfuran) whereas soluble coffee did not contain detectable levels, thereby contributing least to a consumer’s dietary exposure. Furan and furan derivative concentrations were found to decrease significantly upon cooling, reducing consumer exposure by 8.0–17.2 % on average once the coffee reached drinking temperature 55–60 °C, in ceramic cups. Serving coffee in a ceramic or disposable cup were found to influence the cooling dynamics of the coffee but did not statistically influence the consumers exposure at a given temperature.

Chemical analyses and sensory evaluation are the most applied methods for quality control of roasted and ground coffee (RG). However, faster alternatives would be highly valuable. Here, we applied infrared-photoacoustic spectroscopy (FTIR-PAS) on RG powder. Mixtures of specific defective beans were blended with healthy (defect-free) Coffea arabica and Coffea canephora bases in specific ratios, forming different classes of blends. Principal Component Analysis allowed predicting the amount/fraction and nature of the defects in blends while partial Least Squares Discriminant Analysis revealed similarities between blends (=samples). A successful predictive model was obtained using six classes of blends. The model could classify 100% of the samples into four classes. The specificities were higher than 0.9. Application of FTIR-PAS on RG coffee to characterize and classify blends has shown to be an accurate, easy, quick and “green” alternative to current methods.

On-line analysis of coffee roasting was performed using ion mobility spectrometry–mass spectrometry (IMS–MS) with corona discharge ionization. This is the first time that formation of volatile organic compounds (VOCs) during coffee roasting was monitored not only in positive but also in negative ion mode, and not only with mass spectrometry, but also with ion mobility spectrometry. The temporal evolution of more than 150 VOCs was monitored during the roasting of Brazilian Coffea arabica. Mass-selective ion mobility spectrometry allowed a separation of isobaric and isomeric compounds. In positive ion mode, isomers of alkyl pyrazines were found to exhibit distinct time-intensity profiles during roasting, providing a unique insight into the complex chemistry of this important class of aroma active compounds. Negative ion mode gave access to species poorly detectable by other on-line methods, such as acids. In this study, the release of fatty acids during coffee roasting was investigated in detail. These increase early on in the roasting process followed by a decrease at the same time as other VOCs start to be formed.

The hot-water extraction process used to make an espresso coffee is affected by a large number of factors. A proper understanding of how these factors impact the profile of the final cup is important to the quality of an espresso coffee. This work examines the effect of water temperature and pressure on the extraction kinetics of volatile organic compounds (VOCs) in coffee. This was achieved by on-line monitoring of the volatiles directly from the coffee flow, using proton-transfer-reaction time-of-flight mass-spectrometry (PTR-ToF-MS). Using hierarchical cluster analysis (HCA), tentatively identified compounds were grouped into 5 families according to their time–intensity profiles. VOCs grouped into each family had similar physicochemical properties while polarity was found to be one of the main forces driving VOC extraction kinetics. The effect of pressure was studied by extracting espresso coffees at 7, 9 and 11 bar. A pressure of 11 bar resulted in an increased extraction of volatiles over the entire extraction time (25 s). To study the effect of temperature, espresso coffees were extracted at 82, 92 and 96 °C. An increase in temperature produced a significant increase in the extraction of VOCs, especially during the last part of the extraction. The effect of temperature on extractability was more pronounced for the less polar compounds.

Oxygen scavenging film based on a catalytic system with palladium (CSP) was used to prevent lipid oxidation in linseed oil. Linseed oil was packaged under normal (NA) or modified atmosphere with 2 vol% oxygen (MA) with or without the CSP and stored at 45 °C for 6 months in darkness. To evaluate the evolution of primary and secondary oxidation products, conjugated dienes/trienes, peroxide and para-anisidine values were measured. Additionally, volatile oxidation products in the headspace were analyzed. While a significantly higher level of oxidation products was measured in linseed oil stored under NA compared to MA without CSP, thresholds indicating good quality oil based on the peroxide value (15 milliequivalents O2/g oil) and the para-anisidine value (2 absorbance units/g oil) were exceeded under both packaging conditions. In packages with the CSP, however, removal of headspace oxygen kept oxidation parameters below these thresholds, indicating good quality oil over the whole storage period.

Liquid–air partition coefficients (Henry's law constants, HLCs) of eight flavour compounds (volatile organic compounds, VOCs) were determined in water, over a temperature range of 4 °C to 85 °C. The HLCs were derived by using nitrogen to strip a dilute solution of a VOC and then determining the decrease in concentration of the VOC in real-time in the stripped gas using proton-transfer-reaction time-of-flight mass-spectrometry (PTR-ToF-MS). This approach provided HLCs of improved accuracy (small 95% standard deviation) over a large temperature range, especially for low volatility VOCs (HLC > 2 mol/(m 3 Pa)). The outstanding features of this approach are: (i) it is applicable for VOCs over a large range of volatility; (ii) it can be used over a wide temperature range (4 °C to 85 °C); (iii) it is automated (high-throughput); (iv) it does not require calibration or knowledge of the initial concentration of the analyte; and (v) the experimental temperature can be controlled very precisely (Δ T better than ±0.1 °C). The eight flavour compounds analysed in water were: (E)-β-damascenone, 2,3-butanedione, 2-ethyl-3,5-dimethylpyrazine, 2-methylfuran, 3-methylbutanal, acetaldehyde, ethyl-3-methyl butanoate and guaiacol. Based on the measured HLCs at five fixed temperatures (4 °C, 25 °C, 45 °C, 65 °C and 85 °C), accurate non-linear analytical expressions for the temperature dependence of HLCs were derived, which were then used to calculate thermodynamic constants.

Coffees from different origins were roasted to different roast degrees and along varying time temperature roasting profiles. The formation of volatile organic compounds (VOCs) during roasting was analyzed on-line by proton-transfer-reaction time-of-flight mass-spectrometry (PTR-ToF-MS). Coffee samples were Coffea arabica from Colombia, Guatemala (Antigua La Ceiba), Ethiopia (Yirga Cheffe, Djimmah) and Coffea canephora var. robusta from Indonesia (Malangsari). The roasting profiles ranged from high temperature short time (HTST) to low temperature long time (LTLT) roasting, and from medium to dark roast degree. The release dynamics of the on-line monitored VOCs differed for the different coffees and showed a strong modulation with the time–temperature roasting profile. While for Guatemalan coffee the formation of VOCs started relatively early in the roasting process, the VOC formation started much later in the case of Yirga Cheffe and Malangsari. Off-line analysis of the coffee brew augmented the measurements. These included headspace solid phase micro extraction gas chromatography mass spectrometry (HS SPME GC/MS), content of total solids, chlorogenic acids, caffeine, total polyphenols (Folin Ciocalteu), organic acids (ion chromatography), titratable acidity and pH. Some general trends, irrespective of the coffee origin, were observed, such as an increase in pH when going from an HTST to an LTLT profile or from a medium to dark roast degree. Furthermore, a decrease of total headspace intensity was observed from an HTST to an LTLT roasting profile. In general, the changes of the time temperature roasting profiles and/or the roast degree influenced the intensity of the respective coffee constituents as well as their relative composition differently for different coffee origins.

In the past decade, we have witnessed rapid development of direct-injection mass spectrometric (DIMS) technologies that combine ever-improving mass and time resolution with high sensitivity and robustness. Here, we review some of the most significant DIMS technologies, which have been applied to rapid monitoring and quantification of volatile organic compounds (VOCs) and biogenic VOCS (BVOCs). They include MS-e-noses, atmospheric-pressure chemical ionization (APCI), proton-transfer-reaction mass spectrometry (PTR-MS), and selected ion-flow-tube mass spectrometry (SIFT-MS). DIMS-based MS-e-noses provide the possibility to screen large sample sets and may yield rich analytical information. APCI is a widespread ionization method and pioneered DIMS in environmental and flavor-release applications. SIFT-MS and PTR-MS allow better control of precursor-ion generation and hence of the ionization process. SIFT-MS puts the focus on control of the ionization process, while PTR-MS does so on sensitivity. Most (B)VOCs of interest can be efficiently detected and often identified by DIMS, thanks also to the possibility of switching between different precursor ions and the recent realization of time-of-flight-based equipments. Finally, we give selected examples of applications for each of the key technologies, including research in food-quality control (MS-e-nose), flavor release (APCI), environmental sciences (PTR-MS) and health sciences (SIFT-MS).

We report on the in vivo breath-by-breath analysis of volatiles released in the mouth during eating of ripe and unripe banana. The air exhaled through the nose, nosespace (NS), is directly introduced into a proton transfer reaction mass spectrometer and the time-intensity profiles of a series of volatiles are monitored on-line. These include isopentyl and isobutyl acetate, two characteristic odour compounds of ripe banana, and 2E-hexenal and hexanal, compounds typical of unripe banana. Comparing the NS with the headspace (HS) profile, two differences are outlined. First, NS concentrations of some compounds are increased, compared to the HS, while others are decreased. This indicates that the in-mouth situation has characteristics of its own—mastication, mixing/dilution with saliva, temperature and pH—which modify the aroma relative to an HS aroma. Second, we discuss the temporal evolution of the NS. While 2E-hexenal and hexanal steadily increase in the NS during mastication of unripe banana, no such evolution is observed in volatile organic compounds (VOCs) while eating ripe banana. Furthermore, ripe banana shows high VOC concentrations in the swallow breath in contrast to unripe banana.

The preferred fragmentation patterns of negatively charged carbon clusters, C−N have been investigated by cluster—beam impact methods using various surfaces and impact energies (Ei = 0-150 eV). Transitions from one type of cluster structure to another are inferred from the observed change in fragmentation patterns. The results are made possible by the high intact-scattering yield of C−N clusters, and by the competitiveness of fragmentation with electron emission for clusters N < 40. The main inferred structures and diagnostic fragmentation patterns are (i) chain structures (4 < N < 18), which fragment by C(0)3 loss; (ii) ring structures, N ≈ 17-32, reflected by preferential cleavage to give large neutral clusters C(0)14, and C(0)22, (iii) polycyclic or cage structures, which shatter to yield an array of small fragments; and (iv) fullerene-type structures, N > 33, for which electron emission dominates over fragmentation. These results are compared and contrasted with results obtained from other fragmentation and collisional methods.