Search

The luminescence properties of InGaN/GaN multiple-quantum-well light-emitting diodes (LEDs) with different quantum-well (QW) thicknesses were investigated. It is found that with decreasing the QW thicknesses, the integrated intensities of the photoluminescence (PL) and electroluminescence (EL) peaks demonstrate a contrary changing trend. The PL results show that the luminescence efficiency is improved by using thinner QWs. However, in the EL process, such a positive effect is counteracted by the low carrier injection efficiency in the thin QW LEDs, and consequently leads to a lower light output. Based on our experimental results, it is inferred that the tunneling leakage current associated with dislocations should be responsible for the low carrier-injection efficiency and the observed weaker EL integrated intensity of the LEDs with thin QWs. [ABSTRACT FROM AUTHOR]

An advanced three-dimensional electrothermal-coupled simulation model basing on finite-element method numerical simulation is developed to study the electrical and thermal properties of chip-level high-power GaN-based light-emitting diodes (LEDs). The current spreading, heat generation, and transfer in the device are comprehensively considered in this model. The current-spreading effect of the transparent current-spreading layer and the thermal performance of LEDs with interdigitated-electrodes are investigated. The simulation results prove that the temperature distribution in the active layer is strongly affected by the electrode pattern. The obvious heat accumulation in LEDs with conventional interdigitated-electrode patterns can be seen both in the simulated results and the infrared measured results. The heat transfer efficiency can be improved by using a symmetry electrode pattern design. The thermal management of the bump configurations in flip-chip LEDs is also studied. A more reasonable and thermal effective bump configuration is presented, and the simulated results show that a lower average temperature and more uniform heat distribution in the chips can be obtained. [ABSTRACT FROM AUTHOR]

Hole transport control and carrier injection improvement have been demonstrated in the InGaN/GaN light-emitting diodes (LEDs) with step-stage multiple-quantum-well (MQW) structure and Si-doped hole-blocking barriers. Single-wavelength emission was obtained under electrical pumping in these LEDs by utilizing hole-blocking effect. The light emission around 450 nm showed a substantial increase compared with the reference sample with single or step-stage indium-content MQWs. The droop behavior and wavelength stability were also improved significantly. These improvements were attributed to the enhanced carrier injection to the active region due to the alleviation of the quantum-confined Stark effect and the effective hole-blocking effect of the Si-doped barriers. [ABSTRACT FROM AUTHOR]

We report significantly improved electrostatic discharge (ESD) properties of InGaN/GaN-based light-emitting diodes (LEDs) with inserting Si-delta-doped layers between multiple quantum wells and n-cladding layer. The ESD endurance voltage increased from -1200 V to -4000 V with the insertion of delta-doped layers. The mechanism of the enhanced ESD properties was then investigated. According to capacitance-voltage results, the factor of capacitance modulation was ruled out. However, infrared microscopy image proved better current spreading in the LEDs with delta-doped layers. In addition, current-voltage, photoluminescence, and atomic force microscope measurements demonstrated substantial quality improvements. These two reasons were considered as the dominant mechanisms of the enhanced ESD properties. [ABSTRACT FROM AUTHOR]

GaN-based light emitting diodes (LEDs) with shallow triangular quantum wells (TQW) structure were proposed and investigated. LEDs with shallow TQW demonstrated a lower turn-on voltage and 80% higher lighting efficiency at 20 mA than devices without the shallow QW structure. A more stable emission wavelength and a lower ideality factor were achieved with the proposed structure. X-ray reciprocal space mapping revealed a partial strain relaxation in active region due to the insertion of the TQW structure. The improved performance is ascribed to the weakening of the polarization field in the MQW active region induced by the TQW structure. [ABSTRACT FROM AUTHOR]

We report the anomalous mobility properties of Si-delta-doped GaN with periodically doping profile. Samples with different delta-doping periods or with varied Si source flow were investigated. It is found that for the short delta-doping-period (<26.5 nm) samples, the Hall mobility increases with decreasing electron concentration; while for the longer-doping-period samples, the situation is just the opposite. To interpret this observation, a two-layer model has been built up for long-period samples based on secondary ion mass spectroscopy measurements. The fitting results using this model are well consistent with the experimental data. [ABSTRACT FROM AUTHOR]