Search

p-Cu 2 O/n-TiO 2 photoanodes were produced by electrodeposition of octahedral p-type Cu 2 O nanoparticles over n-type TiO 2 nanotubes. The photoresponse of the composite p-n photoanodes was evaluated in photoelectrochemical cells operating at "zero-bias" conditions under either visible or UV-vis irradiation. In both operating conditions, the produced electrodes invariably followed the p-n-based photoanode operations but exhibited lower photoelectrochemical performance as compared to the bare n-TiO 2 photoanode under UV-vis light. The reported experimental analysis evidenced that such decreased photoactivity is mainly induced by the scarce efficiency of the nanosized p-n interfaces upon irradiation. To overcome such limitation, a restructuring of the originally electrodeposited p-Cu 2 O was promoted, following a photoelectrochemical post-treatment strategy. p-Cu 2 O, restructured in a 2D leaf-like morphology, allowed reaching an improved photoelectrochemical performance for the p-n-based photoanode under UV-vis light. As compared to the bare n-TiO 2 behavior, such improvement consisted of photoanodic currents up to three times larger. An analysis of the mechanisms driving the transition from compact (∼100 nm) octahedral p-Cu 2 O to wider (∼1 μm) 2D leaf-like structures was performed, which highlighted the pivotal role played by the irradiated n-TiO 2 NTs.

The direct synthesis of high-value products from end-of-life Li-ion batteries (LIBs), avoiding the complex and costly separation of the different elements, can be reached through a competitive recycling strategy. Here, we propose the simultaneous synthesis of reduced graphene oxide (rGO) and lithium-manganese-rich (Li 1.2 Mn 0.55 Ni 0.15 Co 0.1 O 2 - LMR) cathode material from end-of-life LIBs. The electrode powder recovered after LIBs mechanical pretreatment was directly subjected to the Hummers' method. This way, quantitative extraction of the target metals (Co, Ni, Mn) and oxidation of graphite to graphene oxide (GO) were simultaneously achieved, and a Mn-rich metal solution resulted after GO filtration, owing to the use of KMnO 4 as an oxidizing agent. This solution, which would routinely constitute a heavy-metal liquid waste, was directly employed for the synthesis of Li 1.2 Mn 0.55 Ni 0.15 Co 0.1 O 2 cathode material. XPS measurements demonstrate the presence in the synthesized LMR of Cu 2+ , SO 4 2- , and SiO 4 4- impurities, which were previously proposed as effective doping species and can thus explain the improved electrochemical performance of recovered LMR. The GO recovered by filtration was reduced to rGO by using ascorbic acid. To evaluate the role of graphite lithiation/delithiation during battery cycling on rGO production, the implemented synthesis procedure was replicated starting from commercial graphite and from the graphite recovered by a consolidated acidic-reductive leaching procedure for metals extraction. Raman and XPS analysis disclosed that cyclic lithiation/delithiation of graphite during battery life cycle facilitates the graphite exfoliation and thus significantly increases conversion to rGO., Competing Interests: The authors declare no competing financial interest., (© 2021 The Authors. Published by American Chemical Society.)

We probed a series of multicomponent electron donor 2 -donor 1 -acceptor 1 conjugates both experimentally and computationally. The conjugates are based on the light harvester and primary electron-donor zinc-porphyrin (ZnP, donor 1 ) to whose β positions a secondary electron-donor ferrocene (Fc, donor 2 ) and the primary electron-acceptor C 60 -fullerene (C 60 , acceptor 1 ) are attached. Linking all of them via p -phenylene-acetylene/acetylene bridges of different lengths to gain full control over shuttling electrons and holes between C 60 , ZnP, and Fc is novel. Different charge-separation, charge-transfer, and charge-recombination routes have been demonstrated, both by transient absorption spectroscopy measurements on the femto, pico-, nano-, and microsecond time scales and by multiwavelength and target analyses. The molecular wire-like nature of the p -phenylene-acetylene bridges as a function of C 60 -ZnP and ZnP-Fc distances is decisive in the context of generating distant and long-lived C 60 •- -ZnP-Fc •+ charge-separated states. For the first time, we confirm the presence of two adjacent charge-transfer states, a C 60 -ZnP •- -Fc •+ intermediate in addition to C 60 •- -ZnP •+ -Fc, en route to the distant C 60 •- -ZnP-Fc •+ charge-separated state. Our studies demonstrate how the interplay of changes in the reorganization energy and the damping factor of the molecular bridges, in addition to variation in the solvent polarity, affect the outcome of the charge-transfer and corresponding rate constants. The different regions of the Marcus parabola are highly relevant in this matter: The charge recombination of, for example, the adjacent C 60 •- -ZnP •+ -Fc charge-separated state is located in the inverted region, while that of the distant C 60 •- -ZnP-Fc •+ charge-separated state lies in the normal region. Here, the larger reorganization energy of Fc relative to ZnP makes the difference.

We report a combined X-ray photoelectron spectroscopy and theoretical modeling analysis of hybrid functional coatings constituted by fluorinated alkylsilane monolayers covalently grafted on a nanostructured ceramic oxide (Al2O3) thin film deposited on aluminum alloy substrates. Such engineered surfaces, bearing hybrid coatings obtained via a classic sol-gel route, have been previously shown to possess amphiphobic behavior (superhydrophobicity plus oleophobicity) and excellent durability, even under simulated severe working environments. Starting from XPS, SEM, and contact angle results and analysis, and combining it with DFT results, the present investigation offers a first mechanistic explanation at a molecular level of the peculiar properties of the hybrid organic-inorganic coating in terms of composition and surface structural arrangements. Theoretical modeling shows that the active fluorinated moiety is strongly anchored on the alumina sites with single Si-O-Al bridges and that the residual valence of Si is saturated by Si-O-Si bonds which form a reticulation with two vicinal fluoroalkylsilanes. The resulting hybrid coating consists of stable rows of fluorinated alkyl chains in reciprocal contact, which form well-ordered and packed monolayers.

Redox properties of H(2)TFcP [TFcP(2-) = 5,10,15,20-tetraferrocenylporphyrin(2-)] were investigated using cyclic voltammetry, differential pulse voltammetry, and square-wave voltammetry methods in a large variety of solvents and electrolytes. When DMF, THF, and MeCN were used with TBAP as the supporting electrolyte, the first oxidation wave was assigned to a single four-electron oxidation process reflecting simultaneous oxidation of all iron(II) centers into iron(III) centers in H(2)TFcP. When an o-DCB (1,2-dichlorobenzene)/TBAP combination was used in electrochemical experiments, four ferrocene substituents underwent two very diffuse, "two-electron" stepwise oxidations. The use of a weakly coordinating TFAB ([NBu(4)][B(C(6)F(5))(4)]) electrolyte in o-DCB or DCM results in four single-electron oxidation processes for ferrocene substituents in which the first and second single-electron waves have a relatively large separation, while the second, third, and fourth oxidation processes are more closely spaced; similar results were observed when a DCM/TBAP system and an imidazolium cation-based ionic liquid ((bmim)Tf(2)N = N-butyl-N'-methylimidazolium bis(trifluoromethanesulfonyl)imide) were used. Spectroelectrochemical oxidation of H(2)TFcP in o-DCB or DCM with TFAB as the supporting electrolyte allowed for characterization of the mixed-valence [H(2)TFcP](+), [H(2)TFcP](2+), and [H(2)TFcP](3+) compounds by UV-vis spectroscopy in addition to the "all-Fe(III)" [H(2)TFcP](4+). The chemical oxidation of H(2)TFcP was tested using a variety of oxidants which resulted in formation of mixed-valence [H(2)TFcP](+) and [H(2)TFcP](2+) as well as [H(2)TFcP](4+), which were characterized by UV-vis-NIR, MCD, IR, Mossbauer, and XPS spectroscopy. The intervalence-charge-transfer bands observed in the near-IR region in [H(2)TFcP](+) and [H(2)TFcP](2+) complexes were analyzed using Hush formalism and found to be of class II (in Robin-Day classification) character with localized ferrous and ferric centers. Class II behavior of [H(2)TFcP](+) and [H(2)TFcP](2+) complexes was further confirmed by Mossbauer, IR, and XPS data.

The electron transfer to self-assembled molecular monolayers carrying a ferrocene (Fc) center, grafted on a flat Si(100) surface, is a recent subject of experimental investigation. We report here the density functional theory (DFT) ab initio calculation of Fc-silicon hybrid redox potentials. The systems were modeled with a slab of H-terminated Si(100) 1 x 1 and 2 x 1 surfaces: geometries were optimized using the ONIOM method, and solute-solvent interactions were included through the polarizable continuum model (PCM) method. Two new routes for Si functionalization with ethyl- (EtFC) and ethynyl-Fc (EFC) differing only in the unsaturation degree of the anchoring arm have been successfully explored, and the redox potential of the resulting hybrids has been measured by cyclic voltammetry: 0.675 and 0.851 V versus NHE for the EtFC and EFC derivatives, respectively. These values, along with the previously measured potential (0.700 V) for the mono-unsaturated derivative, vinyl-Fc, allow the relation between the unsaturation degree and the adduct redox potential to be studied. The comparison among the measured and computed potentials allows one to discriminate between different adduct isomers for the saturated species and more importantly provides strong indications that the carbon-carbon unsaturation initially present in the molecular arm used for anchoring to the surface is preserved upon addition, in contrast with the commonly accepted reaction mechanism.

A reversible electrochemical behavior is demonstrated on a specially prepared redox-functionalized H-Si(100) surface, obtained via an extra-mild grafting procedure from vinylferrocene. The results of a detailed XPS and electrochemical characterization of the resulting hybrid are reported and discussed to propose it as a reference system for high-quality electroactive monolayers on Si. The investigated ferrocene derivative bears a functional group suitable for a mild route to covalent anchoring on Si, which is based on a photoinduced reaction with visible light under an inert atmosphere. Electrochemical reversibility is shown by sharp symmetric voltammograms on freshly prepared p-Si electrodes. Anodic oxide growth is responsible for the progressive degradation of the electrochemical response. Still, fast electron transfer to the surface redox species is maintained during several thousands cycles.

This paper reports the results of an in vitro evaluation of the phototoxic potential of stable photoproducts formed by UVA photolysis of three phenothiazines, perphenazine, fluphenazine, and thioridazine, in a water environment. Perphenazine gave a single product due to dechlorination. From thioridazine, the two major products formed; the endocyclic sulfoxide and the endocyclic N-oxide in which the 2-SCH3 substituent was replaced by a hydroxy group were tested. From fluphenazine, two products have been examined as follows: an exocyclic N-piperazine oxide and a carboxylic acid arising from hydrolysis of the 2-CF3 group. The phototoxicity of the isolated photoproducts has been studied in order to determine their possible involvement in the photosensitizing effects exhibited by the parent drugs, using hemolysis and 3T3 fibroblasts viability as in vitro assays. As fluphenazine, perphenazine, and thioridazine did, some photoproducts proved phototoxic. In particular, the perphenazine dechlorinated photoproduct and the thioridazine N-oxide were found to exert phototoxic properties similar to the parent compounds. Therefore, our data suggest that some phenothiazine photoproducts may play a role in the mechanism of photosensitivity of these drugs. Because some of these photoproducts correspond to metabolic products of phenothiazines found in humans, it cannot be ruled out that metabolites of phenothiazines can be phototoxic in vivo.