Search

Simultaneous, planar laser-induced fluorescence (PLIF) of nitric oxide (NO) and hydroxyl radical (OH) is evidenced with a single dye laser and two intensified CCD (ICCD) cameras. The technique is demonstrated on three premixed turbulent hydrogen-air flames, at atmospheric conditions, with several laser excitation wavelengths within the A 2Σ+ − X 2Π (0,0) and A 2Σ+ − X 2Π (1,0) vibrational bands of NO and OH, respectively. Via adjustments of the grating angle of the dye laser, the output wavelengths can be optimized so that both LIF signals are obtained simultaneously, or it can be tuned to reach the most common excitation wavelengths for OH-PLIF (i.e., near 283 or 284 nm) or NO-PLIF (i.e., 225 and 226 nm) alternatively. The flame visualization results, obtained with the different excitation strategies, are consistent for the three flame conditions and enable to characterize both the reaction zones and the nitric oxide formation. With appropriate selection of the wavelength pair, the technique shows its great potential to enhance the ability of existing lasers to simultaneously visualize and quantify distributions of two key species in reacting flows with only a single laser. [Display omitted] • Combined single-shot imaging of NO and OH with one dye laser in H 2 flames. • Most common excitation wavelengths also achievable alternatively. • Recommendation of optimal excitation wavelengths for future studies. • Flame structure confirmed with different excitation strategies. [ABSTRACT FROM AUTHOR]

• Detailed analysis of flame structures in cracked ammonia jet flames. • Insights into N 2 O formation in ammonia flames through NH and NO multiplication. • Impact of cracking ratio on chemical reactivity, flame stability, and NO emissions. • PLIF-derived statistics contribute to validating turbulence-chemistry interactions. The combustion of cracked ammonia is crucial for enhancing flame stability and reducing pollutant emissions in ammonia-based combustion systems. This study investigated the flame structure and pollutant formation in cracked ammonia jet flames (CAJFs) to improve our understanding of the turbulence-chemistry interactions in ammonia combustion. A simultaneous NH and NO planar laser-induced fluorescence (PLIF) technique was employed to analyze the flame structure of turbulent non-premixed CAJFs, emulated using ammonia-hydrogen–nitrogen mixtures. Experimental measurements were conducted across a range of pressures (1–5 bar) and cracking ratios (7 %-28 %). The results revealed the significant influence of the cracking ratio on the chemical reactivity and NH-layer characteristics of ammonia-hydrogen flames. NH effectively marked the heat release layer of CAJFs. Reducing the cracking ratio from 28 % to 7 % resulted in increased local extinction-induced NH-layer fragmentation and reduced reaction area. The reaction layer thickness exhibited low sensitivity to the cracking ratio and pressure, while the broadening of the NH layer displayed a slowdown pattern with increasing height, differing from premixed flames. The pollutant NO rapidly formed within the reaction zone, persisting in the outer hot products until reduced by turbulent mixing. The fragmented flame structure promoted decreased NO formation and potentially lower NO concentration. A novel approach of multiplying NH and NO was proposed to reflect the formation characteristics of another important pollutant N 2 O. The effect of turbulent disturbances on N 2 O formation needs to be considered in turbulent CAJFs because N 2 O formation is strongly suppressed when turbulent transport reduces local NO concentration. This research enhances understanding of turbulence-chemistry interactions in cracked ammonia combustion, benefiting ammonia flame stability and pollutant emission control. [ABSTRACT FROM AUTHOR]

This work provides a kinetic and experimental investigation of excited radical OH(2Σ+) (also referred to as OH*) in NH 3 H 2 -air flames. A counterflow burner is used to stabilize laminar diffusion flames over wide ranges of ammonia fraction in the fuel blend (0.2 ≤ x NH3 ≤ 0.8) and strain rate (40 ≤ a ≤ 200/s). Using an intensified camera or a spectrometer coupled to a Cassegrain optical system, spatially resolved and spatially integrated OH(A2Σ+-X2Π) chemiluminescence intensities are measured. These data are used to challenge a kinetic mechanism largely developed from existing literature schemes. Measurements and simulations show that two distinct OH* peaks exist in spatially resolved profiles for intermediate ammonia fractions in the fuel blend. Sensitivity analyses identified that reactions N 2 O+ H =N 2 +OH* and H + O + M =OH*+ M , respectively pertinent to NH 3 and H 2 oxidation routes, are responsible for the formation of OH*. The proposed kinetic mechanism gives a remarkable portrait of the empirical data recorded in diffusion flames as well as in premixed NH 3 H 2 -air flames from the literature. Nevertheless, the contribution of reaction N 2 O+ H =N 2 +OH* in the formation of OH* in the peak closest to the fuel side of diffusion flames is consistently overpredicted. Consequently, the frequency factor of the N 2 O+ H N 2 +OH* reaction is adjusted to A = 1.35 × 1014 cm3mol−1s−1, which significantly improves predictions of spatially integrated and spatially resolved OH* intensities for all the diffusion and premixed flames examined. [ABSTRACT FROM AUTHOR]