Search

We detail results of an experiment performed at the Ligne d'Intégration Laser facility aimed at studying supersonic and diffusive radiation front propagation in low-density SiO2 aerogel (20 and 40 mg/cm3) enclosed in a gold tube, driven by thermal emission from a laser-heated spherical gold cavity. The evolution of the front is studied continuously by measuring its self-emission with a 1D (one-dimensional) time-resolved soft x-ray imager. Measurement is performed along (through a 200- μm-wide observation slit) and at the exit of the tube giving access to the dynamics and the curvature of the front. Experimental results are then compared successfully to results from the 3D (three-dimensional) radiation hydrodynamics code TROLL, which shows that if continuous tracking of the front position is accessible with this experimental scheme, measurement of its maximum radiation temperature is on the contrary affected by radiation closure of the observation slit. 3D simulations also indicate that this effect can even be worsened if one includes pointing errors of the x-ray imager. Radiation temperature along the tube was then inferred by combining results from the imager to a wall shock breakout time measurement using a velocity interferometer system for any reflector and results from a broadband x-ray spectrometer used to determine the temperature at the exit of the tube. A decrease in the radiation temperature along the tube is observed, the decrease being more important for the higher SiO2 aerogel density.

Implosion experiments of an inertial confinement fusion (ICF) target on the laser megajoule (LMJ) and the National Ignition Facility require, for certain designs, a precise timing coalescence of fo...

The advent of high-power lasers facilities such as the National Ignition Facility (NIF), and Laser Megajoule (LMJ) in the near future opens a new era in the field of High Energy Density Laboratory Astrophysics. The LMJ, keystone of the French Simulation Program, is under construction at CEA/CESTA and will deliver 1.5 MJ with 176 beamlines. The first physics experiments on LMJ will be performed at the end of 2014 with 2 quadruplets (8 beams). The operational capabilities (number of beams and plasma diagnostics) will increase gradually during the following years. We describe the current status of the LMJ facility and the first set of diagnostics to be used during the commissioning phase and the first experiments. The PETAL project (PETawatt Aquitaine Laser), part of the CEA opening policy, consists in the addition of one short-pulse (500 fs to 10 ps) ultra-high-power, high-energy beam (a few kJ compressed energy) to the LMJ facility. PETAL is focalized into the LMJ target chamber and could be used alone or in combination with LMJ beams. In the later case, PETAL will offer a combination of a very high intensity multi-petawatt beam, synchronized with the nanosecond beams of the LMJ. PETAL, which is devoted to the academic research, will also extend the LMJ diagnostic capabilities. Specific diagnostics adapted to PETAL capacities are being fabricated in order to characterize particles and radiation yields that can be created by PETAL. A first set of diagnostics will measure the particles (protons/ions/electrons) spectrum (0.1–200 MeV range) and will also provide point projection proton-radiography capability. LMJ/PETAL, like previously the LIL laser [X. Julien et al., Proc. SPIE 7916 (2011) 791610], will be open to the academic community. Laboratory astrophysics experiments have already been performed on the LIL facility, as for example radiative shock experiments and planetary interiors equation of state measurements.

Since the first experimental campaign conducted in 2014 with mid field Gated X-ray Imager (GXI) and two quadruplets (20 kJ at 351 nm) focused on target, the Laser MegaJoule (LMJ) operational capability is still growing up. New plasma diagnostics have been implemented: a large field 2D GXI, two broadband x-ray spectrometers (called DMX and miniDMX), a specific soft x-ray spectrometer and a Laser Entrance Hole (LEH) imaging diagnostic. A series of experiments have been performed leading to more than 60 shots on target. We will present the plasma diagnostics development status conducted at CEA for experimental purpose. Several diagnostics are now under manufacturing or development which include a Streaked Soft X-ray Imager (SSXI), an Equation Of State (EOS) diagnostic suite (“EOS pack”), a Full Aperture BackScattering (FABS) diagnostic, a Near Backscattered Imager (NBI), a high resolution 2D GXI, a high resolution x-ray spectrometer, a specific set of two polar hard x-ray imagers for LEH characterization and a set of Neutron Time of Flight (NTOF) detectors. We describe here the diagnostics design and performances in terms of spatial, temporal and spectral resolutions. Their designs have taken into account the harsh environment (neutron yields, gamma rays, electromagnetic perturbations, debris and shrapnel) and the safety requirements.