Search

With the gradual expansion of mining scale in open-pit coal mines, slope safety problems are increasingly diversified and complicated. In order to reduce the potential loss caused by slope sliding and reduce the major threat to the safety of life and property of residents in the mining area, this study selected two mining areas in Xinjiang as cases and focused on the relationship between phase noise and deformation. The study predicts the specific time point of slope sliding by analyzing the dynamic history correlation tangent angle between the two. Firstly, the time series data of the micro-variation monitoring radar are used to obtain the small deformation of the study area by differential InSAR (D-InSAR), and the phase noise is extracted from the radar echo in the sequence data. Then, the volume of the deformation body is calculated by analyzing the small deformation at each time point, and the standard deviation of the phase noise is calculated accordingly. Finally, the sliding time of the deformation body is predicted by combining the tangent angle of the ratio of the volume of the deformation body to the standard deviation of the phase noise. The results show that the maximum deformation rates of the deformation bodies in the studied mining areas reach 10.1 mm/h and 6.65 mm/h, respectively, and the maximum deformation volumes are 2,619,521.74 mm3 and 2,503,794.206 mm3, respectively. The predicted landslide time is earlier than the actual landslide time, which verifies the effectiveness of the proposed method. This prediction method can effectively identify the upcoming sliding events and the characteristics of the slope, provide more accurate and reliable prediction results for the slope monitoring staff, and significantly improve the efficiency of slope monitoring and early warning. [ABSTRACT FROM AUTHOR]

The study of the polarimetric target decomposition algorithm with physical scattering models has contributed to the development of the field of remote sensing because of its simple and clear physical meaning with a small computational effort. However, most of the volume scattering models in these algorithms are for forests or crops, and there is a lack of volume scattering models for grasslands. In order to improve the accuracy of the polarimetric target decomposition algorithm adapted to grassland data, in this paper, a novel volume scattering model is derived considering the characteristics of real grassland plant structure and combined with the backward scattering coefficients of grass, which is abstracted as a rotatable ellipsoid of variable shape. In the process of rotation, the possibility of rotation is considered in two dimensions, the tilt angle and canting angle; for particle shape, the anisotropy degree A is directly introduced as a parameter to describe and expand the applicability of the model at the same time. After obtaining the analytical solution of the parameters and using the principle of least negative power to determine the optimal solution of the model, the algorithm is validated by applying it to the C-band AirBorne dataset of Hunshandak grassland in Inner Mongolia and the X-band Cosmos-Skymed dataset of Xiwuqi grassland in Inner Mongolia. The performance of the algorithm with five polarimetric target decomposition algorithms is studied comparatively. The experimental results show that the algorithm proposed in this paper outperforms the other algorithms in terms of grassland decomposition accuracy on different bands of data. [ABSTRACT FROM AUTHOR]

Azimuth multi-channel synthetic aperture radar (SAR) has always been an important technical means to achieve high-resolution wide-swath (HRWS) SAR imaging. However, in the space-borne azimuth multi-channel SAR system, random phase noise will be produced during the operation of each channel receiver. The phase noise of each channel is superimposed on the SAR echo signal of the corresponding channel, which will cause the phase imbalance between the channels and lead to the generation of false targets. In view of the above problems, this paper proposes a random phase noise compensation method for space-borne azimuth multi-channel SAR. This method performs feature decomposition by calculating the covariance matrix of the echo signal and converts the random phase noise estimation into the optimal solution of the cost function. Considering that the phase noise in the receiver has frequency-dependent and time-varying characteristics, this method calculates the phase noise estimation value corresponding to each range-frequency point in the range direction and obtains the phase noise estimation value by expectation in the azimuth direction. The proposed random phase noise compensation method can suppress false targets well and make the radar present a well-focused SAR image. Finally, the usefulness of the suggested method is verified by simulation experiments. [ABSTRACT FROM AUTHOR]

With the acceleration of urbanisation, urban areas are subject to the combined effects of the accumulation of various natural factors, such as changes in temperature leading to the thermal expansion or contraction of surface materials (rock, soil, etc.) and changes in precipitation and humidity leading to an increase in the self-weight of soil due to the infiltration of water along the cracks or pores in the ground. Therefore, the subsidence of urban areas has now become a serious geological disaster phenomenon. However, the use of traditional neural network prediction models has limitations when examining the causal relationships between time series surface deformation data and multiple influencing factors and when applying multiple influencing factors for predictive analyses. To this end, Sentinel-1A data from March 2017 to February 2023 were used as the data source in this paper, based on time series deformation data acquired using the small baseline subset interferometric synthetic aperture radar (SBAS-InSAR) technique. A sparrow search algorithm–convolutional neural network–long short-term memory (SSA-CNN-LSTM) neural network prediction model was built. The six factors of temperature, humidity, precipitation, and ground temperature at three different depths below the surface (5 cm, 10 cm, and 15 cm) were taken as the input of the model, and the surface deformation data were taken as the output of the neural network model. The correlation between the spatial and temporal evolution characteristics of the ground subsidence in urban areas and various influencing factors was analysed using grey correlation analysis, which proved that these six factors contribute to some extent to the deformation of the urban surface. The main urban area of Hohhot City, Inner Mongolia Autonomous Region, was used as the study area. In order to verify the efficacy of this neural network prediction model, the prediction effects of the multilayer perceptron (MLP), backpropagation (BP), and SSA-CNN-LSTM models were compared and analysed, with the values of the correlation coefficients of the feature points of A1, B1, and C1 being in the range of 0.92, 0.83, and 0.93, respectively. The results show that compared with the traditional MLP and BP neural network models, the SSA-CNN-LSTM model achieves a higher performance in predicting time series surface deformation data in urban areas, which provides new ideas and methods for this area of research. [ABSTRACT FROM AUTHOR]

The process of extracting seleno-protein from the selenium enriched Lyophyllum decastes mycelia cultured in a 20 L fermentor was optimized, and the effects of selenium enrichment on both types and contents of amino acids in Lyophyllum decastes mycelia were analyzed. Single factor tests and Box-Benhnken central combined response surface test were used to optimize process of extracting seleno-protein from Lyophyllum decastes mycelia. The content of protein was determined by 3,3'-diaminobenzidine spectrophotometry. The types and contents of amino acids in mycelia protein before and after selenium enrichment were compared by means of amino acid analyzer. The results showed that the optimal conditions of extracting seleno-protein from mycelia of Lyophyllum decastes were extraction temperature of 64 °C, extraction time of 60 min, liquid-solid ratio of 200:1 g/mL, and extraction times of 2. The protein extraction rate was 75.13%, and the content of selenium in mycelia was 63.87 μg/g. The amino acid composition were analyzed by means amino acid score (AAS) and chemical score (CS), and the nutritional value of the protein in the selenium-enriched Lyophyllum decastes mycelia was evaluated. The varieties of amino acids in the selenium-enriched Lyophyllum decastes mycelia were abundant and the content of essential amino acids for human body was 17.20 g/100 g, 19.75% higher than that in the non-selenium-ecriched Lyophyllum decastes mycelia. The ratio of EAA/NEAA was 0.51, close to the recommended value proposed by WHO, and the values of both AAS and CS were close to the those in the model protein. In summary, the protein extraction rate could be improved by optimizing the extraction process, and there was selenium in the protein from selenium-enriched mycelia, which promoted the increase of amino acid content. The nutritional value of protein in selenium-enriched mycelia was higher than that in non-selenium-riched mycelia, and selenium-enrichec mycelia had potential edible and application value. [ABSTRACT FROM AUTHOR]

As urban economies flourish and populations become increasingly concentrated, urban surface deformation has emerged as a critical factor in city planning that cannot be overlooked. Surface deformation in urban areas can lead to deformations in structural supports of infrastructure such as road bases and bridges, thereby posing a serious threat to public safety and creating significant safety hazards. Consequently, research focusing on the monitoring of urban surface deformation holds paramount importance. Interferometric synthetic aperture radar (InSAR), as an important means of earth observation, has all-day, wide-range, high-precision, etc., characteristics and is widely used in the field of surface deformation monitoring. However, traditional solitary InSAR techniques are limited in their application scenarios and computational characteristics. Additionally, the manual selection of ground control points (GCPs) is fraught with errors and uncertainties. Permanent scatterers (PS) can maintain high interferometric coherence in man-made building areas, and distributed scatterers (DS) usually show moderate coherence in areas with short vegetation; the combination of DS and PS solves the problem of manually selecting GCPs during track re-flattening and regrading, which affects the monitoring results. In this paper, 45 Sentinel-1B data from 16 February 2019 to 14 December 2021 are used as the data source in the urban area of Horqin District, Tongliao City, Inner Mongolia Autonomous Region, for example. A four-threshold (coherence coefficient threshold, FaSHPS adaptive threshold, amplitude divergence index threshold, and deformation velocity interval) GCPs point screening method for PS-DS, as well as a Small Baseline Subset-Permanent Scatterers-Distributed Scatterers-Interferometric Synthetic Aperture Radar (SBAS-PS-DS-InSAR) method for selecting PS and DS points as ground control points for orbit refinement and re-flattening, are proposed. The surface deformation results obtained using the Small Baseline Subset Interferometric Synthetic Aperture Radar (SBAS-InSAR) and the SBAS-PS-DS-InSAR proposed in this paper were comparatively analysed and verified. The maximum cumulative line-of-sight settlements were −90.78 mm and −83.68 mm, and the maximum cumulative uplifts are 74.94 mm and 97.56 mm, respectively; the maximum annual average line-of-sight settlements are −35.38 mm/y and −30.38 mm/y, and the maximum annual average uplifts are 25.27 mm/y and 27.92 mm/y. The results were evaluated and analysed in terms of correlation, mean absolute error (MAE), and root mean square error (RMSE). The deformation results of the two InSAR methods were evaluated and analysed in terms of correlation, MAE, and RMSE. The errors show that the Pearson correlation coefficients between the vertical settlement results obtained using the SBAS-PS-DS-InSAR method and the GPS monitoring results were closer to 1. The maximum MAE and RMSE were 13.7625 mm and 14.8004 mm, respectively, which are within the acceptable range; this confirms that the monitoring results of the SBAS-PS-DS-InSAR method were better than those of the original SBAS-InSAR method. SBAS-InSAR method, which is valid and reliable. The results show that the surface deformation results obtained using the SBAS-InSAR, SBAS-PS-DS-InSAR, and GPS methods have basically the same settlement locations, extents, distributions, and temporal and spatial settlement patterns. The deformation results obtained using these two InSAR methods correlate well with the GPS monitoring results, and the MAE and RMSE are within acceptable limits. By comparing the deformation information obtained using multiple methods, the surface deformation in urban areas can be better monitored and analysed, and it can also provide scientific references for urban municipal planning and disaster warning. [ABSTRACT FROM AUTHOR]

MicroRNAs (miRNAs) are short noncoding RNAs, approximately 20–24 nucleotides long that negatively regulate gene expression by either inhibiting translation or cleaving complementary mRNA to participate in various biological processes. Accumulating evidence has indicated that miRNAs are widely present in hematological cancers, particularly leukemia, exhibiting either upregulation or downregulation in leukemia patients compared with healthy controls. These miRNAs have a pivotal role in the development, progression and metastasis of leukemia, as well as in the prognosis and/or relapse of patients. miR-22 is one of the abnormally expressed miRNAs in a variety of leukemia diseases, and is considered to be one of the few cancer suppressors. Recent research has demonstrated that miR-22 is involved in the regulation of leukemia cell proliferation, differentiation and apoptosis, and could be a promising biomarker and prognostic indicator for leukemia. Here, we summarize all relevant findings that carry out experimental investigation and clinical analyses, aiming to elucidate the comprehensive implications of miR-22 in various types of leukemia for the development of new therapeutic and prognostic strategies and new drug targets for the treatment of leukemia. [ABSTRACT FROM AUTHOR]

The preparation of lightweight materials with electromagnetic interference-shielding effectiveness higher than 30 dB is critical for most industrial and consumer applications. Compounding polymer resin with conductive filler can generate excellent electromagnetic interference-shielding effectiveness but usually leads to a high-sample density, while the foaming of polymer composite suffers from the significant-reduced electromagnetic interference-shielding effectiveness. In this study, polyetherimide composite foams with loading of 10–80 phr (parts per hundred of resins) nickel particles were fabricated to meet the gap. The polyetherimide/nickel composite foams possessed uniform cell structure and low-sample density such as 0.86 g/cm3 at 70 phr nickel. The coupling effects of gravity settlement and cell-structure solidification led to the formation of gradient distribution of nickel particles across the foams. The formed novel structure facilitated the enhancement of multi-reflection and multi-scattering among nickel particles and cells. As a consequence, polyetherimide/nickel foam with 70 phr nickel (PEIN70) possessed a high-electromagnetic interference shielding effectiveness of 86.7–106.5 dB over a frequency range of 50–3000 MHz. When the sample density was considered, the specific electromagnetic interference shielding effectiveness of PEIN70 foam was as high as 121.3 dB/(g/cm3) at 1 GHz, which was higher than the reported electromagnetic interference-shielding materials. The excellent electromagnetic interference-shielding properties, lightweight, well-defined resin properties ensure polyetherimide/nickel composite foams useful in many advanced applications. [ABSTRACT FROM PUBLISHER]

The micro-deformation monitoring radar is usually based on Permanent Scatterer (PS) technology to realize deformation inversion. When the region is continuously monitored for a long time, the radar image amplitude and pixel variance will change significantly with time. Therefore, it is difficult to select phase-stable scatterers by conventional amplitude deviation methods, as they can seriously affect the accuracy of deformation inversion. For different regions studied within the same scenario, using a PS selection method based on the same threshold often increases the size of the deformation error. Therefore, this paper proposes a new PS selection method based on the Gaussian Mixture Model (GMM). Firstly, PS candidates (PSCs) are selected based on the pixels' amplitude information. Then, the amplitude deviation index of each PSC is calculated, and each pixel's probability values in different Gaussian distributions are acquired through iterations. Subsequently, the cluster types of pixels with larger probability values are designated as low-amplitude deviation pixels. Finally, the coherence coefficient and phase stability of low-amplitude deviation pixels are calculated. By comparing the probability values of each of the pixels in different Gaussian distributions, the cluster type with the larger probability, such as high-coherence pixels and high-phase stability pixels, is selected and designated as the final PS. Our analysis of the measured data revealed that the proposed method not only increased the number of PSs in the group, but also improved the stability of the number of PSs between groups.