Search

Theoretical analysis of heat transfer plays a vital role in updating the quality of heat exchanger products. Experiments cost more compared to computational costs. In this direction, this work is concerned with the unsteady and incompressible fluid flow with a rod inside a square cavity. The disturbance in the flow is induced by the motion of the top and bottom walls of the cavity. The maximum fluid flow will arise, which will help in reducing the temperature of the heated wall or rod in any physical situation. A single wall is considered to be heated, which produces heat in the neighboring fluid layers. A rod is placed to reduce the motion of the heated fluid coming from the heated wall at a high-temperature. The transmission of thermal energy along with fluid flow is carried out using the energy equation and the Navier–Stokes equation of motion, respectively. These equations are transformed to dimensionless form by appropriate parametrization and solved using the finite element method for different parameters such as Rayleigh number and Prandtl number, temperature and velocity fields and are presented graphically [ABSTRACT FROM AUTHOR]

The present study was conducted to compare the stability of four commercially available implants by investigating the focal stress distributions and relative micromotion using finite element analysis. Variations in the numbers of pegs between the implant designs were tested. A load of 750 N was applied at three different glenoid positions (SA: superior-anterior; SP: superior-posterior; C: central) to mimic off-center and central loadings during activities of daily living. Focal stress distributions and relative micromotion were measured using Marc Mentat software. The results demonstrated that by increasing the number of pegs from two to five, the total focal stress volumes exceeding 5 MPa, reflecting the stress critical volume (SCV) as the threshold for occurrence of cement microfractures, decreased from 8.41 to 5.21 % in the SA position and from 9.59 to 6.69 % in the SP position. However, in the C position, this change in peg number increased the SCV from 1.37 to 5.86 %. Meanwhile, micromotion appeared to remain within 19-25 µm irrespective of the number of pegs used. In conclusion, four-peg glenoid implants provide the best configuration because they had lower SCV values compared with lesser-peg implants, preserved more bone stock, and reduced PMMA cement usage compared with five-peg implants. [ABSTRACT FROM AUTHOR]

The remaining useful life (RUL) of electronic modules under the influence of rugged random-vibration and operational conditions is investigated in this paper. The effects of storage conditions and soft failures, caused by the vibrations to solder joints of a printed circuit board (PCB) are analyzed. The RUL is estimated with the help of vibration testing and finite element analysis techniques. Keeping in view the standard and working environmental conditions, the PCB of a power distribution module is subjected to random and sine vibrations. Besides the significance of fatigue damage and RUL estimation of solder joints, caused by storage or operation for a period of five years has not been addressed in existing literature so far. The current study performs the modal analysis to find the natural frequencies, mode shapes, and participation factor ratios of a PCB and its components. These natural frequencies are subsequently verified via comparison with experimental sine sweep results. A random vibration test over the frequency range from 10 Hz to 2000 Hz is also applied for recording the time-to-failure ratio of the PCB. Moreover, the spectrum analysis is performed using the commercial ANSYS software, to assess the acceleration response and the stress power spectral density (PSD) of the critical solder joints. The stress PSD is then used to estimate the random vibration fatigue damage of the solder joint. The calculated fatigue life, based on the modified Miner's rule and the Basquin power-law conform to the actual random vibration testing results. [ABSTRACT FROM AUTHOR]