Search

• Pioneer Spain: first country to include in grid code the synthetic inertia capability. • Synthetic inertial response of a PV inverter studied based on the Spanish grid code. • Analyzed the role of power plant controller in the dynamic response of the facility. • PV system able to contribute to frequency control providing an inertial response. As the large-scale integration of renewable energy grows, inertia in power systems is reduced, which causes the rate of change of frequency to increase and worsens the frequency nadir during disturbances. There is, therefore, an urgent need to accelerate the development of international standards and regulations that require solar PV systems and other renewable installations to also contribute to stability in the network by emulating inertia. Spain is a pioneer in this field: it is currently the only country that includes the synthetic inertia technical requirement in its grid code. In this context, the present paper analyzes the synthetic inertial response of a PV system model that forms part of an actual PV power plant in Spain under two scenarios, according to its grid code: i) when measurements are conducted at the power conversion PV system level and hence only its control algorithms are executed; and ii) when measurements are conducted at the power plant level and the power plant controller also influences the response of the entire installation. Among its aims, this paper seeks to thoroughly assess the response of an actual PV power conversion system that has the capability of actively contributing to frequency regulation in a network and to critically analyze the suitability of having a power plant controller when the PV facility contributes to power-frequency control by means of an inertial response. The results reveal, at the power conversion PV system level, that the inertia emulation module significantly reduces the response times of the installation to changes in frequency -by more than 68% in the worst case under frequency increases, and by 73% under frequency decreases, thus contributing to more rapid power-frequency regulation in the network. However, at the power plant level, the power plant controller disturbs the PV power conversion system's behavior and causes the opposite effect: response times increase -up to more than 7% in the most unfavorable case when the inertia module is enabled. [ABSTRACT FROM AUTHOR]

The operation of solar photovoltaic installations for many years may lead to problems such as reduced energy efficiency and aging of components. Under this framework, replacing certain components in the facility to extend the service life of the power plant is viewed, in some cases, as a feasible strategy. However, despite its enormous strategic interest for the solar PV industry, we find that revamping PV installations has been the focus of very few scientific publications, and even less so when it comes to analyzing real facilities. Thus, this paper performs a techno-economic analysis of three revamping strategies at a real PV power plant located in the south-east of Spain. The strategies consist of substituting, in each case, the PV modules, the inverter, and both components. The simulated results show that the highest production value by installed power is obtained when both the modules and the inverter are replaced. In the same vein, the economic analysis reveals this scenario as the most favorable in terms of profitability. Based on the results obtained, an interesting future line of research would be focused on the extension of the analysis at country level to study the joint impact of numerous revamping actions. • Techno-economic analysis of revamping projects of a real solar PV power plant. • Replacing modules and inverter emerges as the most feasible strategy. • Study's applicability extends to other revamping initiatives and geographical regions. • Economic outcomes allow the most cost-effective alternatives to be determined. • This research can contribute to efficient and sustainable energy planning. [ABSTRACT FROM AUTHOR]