Search

In highly doped semiconductor quantum wells (QWs), electrons populate various energy states from different subbands and, therefore, several optical intersubband transitions (ISBTs) can occur simultaneously. Coulomb coupling between these ISBTs gathers the strength of all the individual transitions and concentrates all the oscillator strength in a single collective excitation: the multisubband plasmon (MSP). MSPs are an excellent platform for the study of collective and exotic effects in semiconductors and for the demonstration of novel device concepts. Indeed, the high electronic densities involved in the collective excitation greatly enhance the coupling strength and enable the ultra-strong coupling regime between MSPs and either optical modes in a cavity or phonons in the semiconductor. In this Perspectives paper, after addressing the basic physics of MSPs and the state of the art, we outline the most promising paths for the research community in this topic from the point of view of basic physics, material platforms, and applications of MSPs. [ABSTRACT FROM AUTHOR]

The length of the transit region of a Gunn diode determines the natural frequency at which it operates in fundamental mode-the shorter the device, the higher the frequency of operation. The long-held view on Gunn diode design is that for a functioning device the minimum length of the transit region is about 1.5 μm, limiting the devices to fundamental mode operation at frequencies of roughly 60 GHz. Study of these devices by more advanced Monte Carlo techniques that simulate the ballistic transport and electron-phonon interactions that govern device behaviour, offers a new lower bound of 0.5 μm, which is already being approached by the experimental evidence that has shown planar and vertical devices exhibiting Gunn operation at 600 nm and 700 nm, respectively. The paper presents results of the first ever THz submicron planar Gunn diode fabricated in In0.53Ga0.47As on an InP substrate, operating at a fundamental frequency above 300 GHz. Experimentally measured rf power of 28 μW was obtained from a 600 nm long × 120 μm wide device. At this new length, operation in fundamental mode at much higher frequencies becomes possible-the Monte Carlo model used predicts power output at frequencies over 300 GHz. [ABSTRACT FROM AUTHOR]

When biased in the negative differential resistance regime, electroluminescence (EL) is emitted from planar GaAs heterostructure Gunn diodes. This EL is due to the recombination of electrons in the device channel with holes that are generated by impact ionisation when the Gunn domains reach the anode edge. The EL forms non-uniform patterns whose intensity shows short-range intensity variations in the direction parallel to the contacts and decreases along the device channel towards the cathode. This paper employs Monte Carlo models, in conjunction with the experimental data, to analyse these non-uniform EL patterns and to study the carrier dynamics responsible for them. It is found that the short-range lateral (i.e., parallel to the device contacts) EL patterns are probably due to non-uniformities in the doping of the anode contact, illustrating the usefulness of EL analysis on the detection of such inhomogeneities. The overall decreasing EL intensity towards the anode is also discussed in terms of the interaction of holes with the time-dependent electric field due to the transit of the Gunn domains. Due to their lower relative mobility and the low electric field outside of the Gunn domain, freshly generated holes remain close to the anode until the arrival of a new domain accelerates them towards the cathode. When the average over the transit of several Gunn domains is considered, this results in a higher hole density, and hence a higher EL intensity, next to the anode. [ABSTRACT FROM AUTHOR]

This paper reports on the demonstration of quantum cascade detectors (QCDs) based on ZnO/ZnMgO quantum wells (QWs) grown by molecular beam epitaxy on an m-plane ZnO substrate. The TM-polarized intersubband absorption is peaked at a 3 μm wavelength. The sample has been processed in the form of square mesas with sizes ranging from 10 × 10 μm2 up to 100 × 100 μm2. The I-V characteristics reveal that 86% of the 260 devices are operational and that the surface leakage current is negligible at room temperature, which is not the case at 77 K. The photocurrent spectroscopy of 100 × 100 μm2 QCDs reveals a photocurrent resonance at a 2.8 μm wavelength, i.e., slightly blue-shifted with respect to the intersubband absorption peak. The photocurrent persists up to room temperature. The calibrated peak responsivity amounts to 0.15 mA/W under irradiation at Brewster's angle of incidence. This value allows us to estimate the transfer efficiency (1.15%) of the photoexcited electrons into the active QW of the next period. [ABSTRACT FROM AUTHOR]

Transparent conducting oxides (TCOs) are widely used in applications from solar cells to light emitting diodes. Here, we show that the metal organic chemical vapor deposition (MOCVD)-grown, rock-salt CdZnO ternary, has excellent potential as a TCO. To assess this compound, we use a combination of infrared reflectance and ultraviolet-visible absorption spectroscopies, together with Hall effect, to determine its optical and electrical transport characteristics. It is found that the incorporation of Zn produces an increment of the electron concentration and mobility, yielding lower resistivities than those of CdO, with a minimum of 1.96 × 10 − 4 Ω · cm for a Zn content of 10%. Moreover, due to a combination of increasing bandgap energy and band filling, the absorption band-edge energy increases from 2.58 eV in CdO up to 2.89 eV for 15% Zn, yielding a largely enhanced transparency in the visible. The low required growth temperatures, together with the scalability of CVD deposition, provide an excellent ground for the integration of this TCO ternary alloy on foreign devices. [ABSTRACT FROM AUTHOR]

To enable gaining insight into degradation mechanisms of AlGaN/GaN high electron mobility transistors, devices grown on a low-dislocation-density bulk-GaN substrate were studied. Gate leakage current and electroluminescence (EL) monitoring revealed a progressive appearance of EL spots during off-state stress which signify the generation of gate current leakage paths. Atomic force microscopy evidenced the formation of semiconductor surface pits at the failure location, which corresponds to the interaction region of the gate contact edge and the edges of surface steps. [ABSTRACT FROM AUTHOR]

We present the first results of a planar Gunn diode made in \In0.53\Ga0.47\As on an InP substrate, operating at a fundamental frequency up to 164 GHz. For a 120-\mu\m-wide device with a 1.3- \mu\m active channel length, the highest power achieved was approximately -10 dBm at 164 GHz. [ABSTRACT FROM AUTHOR]

A self-consistent Ensemble Monte Carlo (EMC) model was developed to simulate the thermionic effect in heterostructure barrier coolers. The model was validated on an InGaAs-InGaAsP heterostructure device of variable barrier height and width, producing good quantitative agreement with previous literature results. The operation of the cooler was found to be a complex and intricate process depending on the field, conduction band and details of barrier structure. When applied to a GaAs-AlGaAs micro-cooler there was good agreement with the experimental results. Importantly, very small alterations in the barrier structure were found to lead to considerable changes in device performance. [ABSTRACT FROM AUTHOR]

The degradation of AlGaN/GaN high electron mobility transistors after off-state stress is studied by means of electroluminescence (EL) analysis, gate leakage current (Ig) monitoring, and atomic force microscopy (AFM) mapping of the semiconductor surface. It is found that the degradation of Ig upon stress is due to the combined effect of the individual defects underlying each of the EL spots, which contribute a few μA each to the total Ig. After removal of contacts and passivation, a direct one-to-one correspondence between EL spots and pits on the semiconductor surface is found. Reverse bias, conducting-tip AFM imaging showed that these surface pits do indeed act as leakage paths. Thus, the direct relationship between EL hot spots, surface pits, and gate current leakage is demonstrated. Discussion on the morphology of the surface pits and their possible origin is also provided. [ABSTRACT FROM AUTHOR]

Unexpected light propagation effects, such as negative refraction, have been reported in artificial media. Leveraging on the intersubband resonances in heterostructured semiconductors, we show that all possible optical regimes, ranging from classical dieletric and metal to hyperbolic metamaterial types 1 and 2, can be achieved. As a demonstration, we prove that the negative refraction effect can occur at a designed frequency by controlling the electronic quantum confinement.

Solution-processed ZnO sol-gel or nanoparticles are widely used as the electron-transporting layer (ETL) in optoelectronic devices. However, chemisorbed oxygen on the ZnO layer surface has been shown to be detrimental for the device performance as well as stability. Herein, we demonstrate that chemisorbed oxygen removal based on UV illumination of the ZnO surface layer under a nitrogen atmosphere can, simultaneously, improve the power conversion efficiency and photostability of PTB7-Th:PC 71 BM-based inverted polymer solar cells. By a systematic study of such a UV illumination procedure, we obtained optimal conditions where both the cell efficiency and stability were improved. We fabricated cells with a power conversion efficiency higher than 9.8% and with a T 80 lifetime longer than 500 h, corresponding to about a 2.5-fold enhancement relative to non-UV-treated ZnO reference devices.