Search

This study is devoted on Allura Red as food colorant preconcentration and determination in beverage, fruit juice and drink water samples is based on usage of Mn- and Cu- @ ZnS-NPs-AC as new sorbent for ultrasound-assisted-dispersive solid-phase microextraction (UA-DSPME) combined with ultraviolet–visible spectrophotometric based method (UV–Vis). Contribution of volume of eluent, pH, sorbent mass and sonication time on response following conduction of 28 experiments were optimized and investigated while their significantly justified according to p-value. Values of “Prob > F” less than 0.0500 is proportional with their significant influence on recovery of analyte. Under the optimum conditions 0.14 mL of THF; pH of 2.5; 8 mg of sorbent and 3 min sonication time guide and help achievement of limit of quantification (LOQ) and limit of detection (LOD) of 6.08 and 20.26 ng mL−1, respectively. The accuracy of method was validated according to calculation of recovery following spiking 400 and 600 ng mL−1 to blank solution and recovery as more reliable indication of accuracy 93.41 and 102.17% recoveries with RSD

Separation and detection of residual drug in biological fluids has directly related to human health in term of their beneficial or side effects. In biological fluid samples (complex matrix which containing drug at very low level) conduction of preliminary efficient technique as good choice for pre-concentration and clean-up of real sample before their instrumental analysis is highly recommended. In this result technique, based on nano-structure material which poses higher available surface area and larger member of reactive sites led to significant improvement in characteristic performance of analytical method. This paper focused on the synthesis and application of novel nano-sorbent for pre-concentration and extraction of atorvastatin (AT) from different biological fluids. Influence of various variables including sorbent dosage, eluent volume and sonication time on present method response was studied and optimized by central composite design under response surface methodology and accordingly an acceptable calibration curves over wide linear ranges (0.3–2000 μg L−1) with high coefficient of determination higher than 0.999 strongly confirm high applicability of present method for quantification of analyte while limit of detection and quantification in plasma sample were 0.0608 and 0.2033 μg L−1, respectively.

In this work molecular imprinted nanoparticles (MINPs) was synthesized and applied for ultrasonic assisted solid phase extraction of celecoxib (CEL) from human plasma sample following its combination by HPLC-UV. The MINPs were prepared in a non-covalent approach using methacrylic acid as monomer, CEL as template, ethylene glycol dimethacrylate as cross-linker, and 2,2-azobisisobutyronitrile (AIBN) as the initiator of polymerization. pH, volume of rinsing and eluent solvent and amount of sorbent influence on response were investigated using factorial experimental design, while optimum point was achieved and set as 250mg sorbent, pH 7.0, 1.5mL washing solvent and 2mL eluent by analysis of results according to design expert (DX) software. At above specified conditions, CEL in human plasma with complicated matrices with acceptable high recoveries (96%) and RSD% lower than 10% was quantified and estimated. The proposed MISPE-HPLC-UV method has linear responses among peak area and concentrations of CEL in the range of 0.2-2000μgL(-1), with regression coefficient of 0.98. The limit of detection (LOD) and quantification (LOQ) based on three and ten times of the noise of HPLC peaks correspond to blank solution were 0.08 and 0.18μgL(-1), respectively.

Separation and detection of residual drug in biological fluids has directly related to human health in term of their beneficial or side effects. In biological fluid samples (complex matrix which containing drug at very low level) conduction of preliminary efficient technique as good choice for pre-concentration and clean-up of real sample before their instrumental analysis is highly recommended. In this result technique, based on nano-structure material which poses higher available surface area and larger member of reactive sites led to significant improvement in characteristic performance of analytical method. This paper focused on the synthesis and application of novel nano-sorbent for pre-concentration and extraction of atorvastatin (AT) from different biological fluids. Influence of various variables including sorbent dosage, eluent volume and sonication time on present method response was studied and optimized by central composite design under response surface methodology and accordingly an acceptable calibration curves over wide linear ranges (0.3-2000μgL