Search

Calcium manganite-based perovskite-type oxides hold promise for application in chemical looping combustion processes and oxygen transport membranes. In this study, we have investigated the structure, electrical conductivity and oxygen transport properties of perovskite-type oxides CaMn1-x-yTixFeyO3-δ. Distinct from previous work, data of high-temperature X-ray diffraction (HT-XRD) in the temperature range 600-1000 °C (with intervals of 25 °C) demonstrates that CaMnO3-δ (CM) transforms from orthorhombic to a mixture of orthorhombic and tetragonal phases between 875 °C and 900 °C. Rietveld refinements show the formation of a pure tetragonal phase at 975 °C and of a pure cubic phase at 1000 °C. Partial substitution of manganese by iron and/or titanium to yield CaMn0.875Ti0.125O3-δ (CMT), CaMn0.85Fe0.15O3-δ (CMF) or CaMn0.725Ti0.125Fe0.15O3-δ (CMTF) leads to different phase behaviours. While CMT remains orthorhombic up to the highest temperature covered by the HT-XRD experiments, CMF and CMTF undergo an orthorhombic → tetragonal → cubic sequence of phase transitions. Electrical conductivity relaxation measurements are conducted to determine the chemical diffusion coefficient (Dchem) and the surface exchange coefficient (kchem) of the materials. The results demonstrate that oxygen transport is hindered in the tetragonal phase, when occurring, which is attributed to a possible ordering of oxygen vacancies. The small polaron electrical conductivity of CM in the cited temperature range is lowered upon partial manganese substitution, by about 10% for CMF and up to half an order of magnitude for CMT and CMTF.

Diffusivity on the A- and B-site of polycrystalline perovskite CaMnO 3-δ with Ca deficiency and spinel CaMn 2 O 4 (marokite) as a secondary phase was studied using chemical tracers and secondary ion mass spectrometry (SIMS) complemented by electron probe microanalysis (EPMA). Thin films containing Sr and Co chemical tracers were deposited on the polished surface of the polycrystalline composite sample followed by annealing at 800-1200 °C for 96 h. Diffusion profiles for each tracer were determined with SIMS, followed by calculation of diffusion coefficients by fitting to appropriate models. The Sr tracer showed mainly lattice diffusion, with an activation energy of 210 ± 30 kJ mol -1 , whereas the Co tracer showed a combination of lattice and enhanced grain-boundary diffusion, with activation energies of 270 ± 30 kJ mol -1 and 380 ± 40 kJ mol -1 , respectively. The diffusivities may be used to predict interdiffusion and lifetime of junctions between n-type CaMnO 3-δ or CaMnO 3-δ /CaMn 2 O 4 composites and metallization interlayers or p-type leg materials in oxide thermoelectrics. In particular, the relatively high effective diffusivity of Co in polycrystalline CaMnO 3-δ may play a role in the reported fast formation of the secondary phase (Ca 3 Co 2-y Mn y O 6 ) between p-type Ca 3 Co 3.92 O 9+δ and n-type CaMnO 3-δ in a direct p-n thermoelectric junction.

The impurity diffusion of Pr(3+) in dense polycrystalline LaMnO(3), LaCoO(3) and LaFeO(3) was studied at 1373-1673 K in air in order to investigate cation diffusion in these materials. Cation distribution profiles were measured by secondary-ion mass spectrometry and it was found that penetration profiles of Pr(3+) had two distinct regions with different slopes. The first, shallow region was used to evaluate the bulk diffusion coefficients. The activation energies for bulk diffusion of Pr(3+) in LaMnO(3), LaCoO(3) and LaFeO(3) were 126 +/- 6, 334 +/- 68 and 258 +/- 75 kJ mol(-1), respectively, which are significantly lower than previously predicted by atomistic simulations. The bulk diffusion of Pr(3+) in LaMnO(3) was enhanced compared to LaCoO(3) and LaFeO(3) due to higher concentrations of intrinsic point defects in LaMnO(3), especially La site vacancies. Grain-boundary diffusion coefficients of Pr(3+) in LaCoO(3) and LaFeO(3) materials were evaluated according to the Whipple-Le Claire equation. Activation energies for grain-boundary diffusion of Pr(3+) in LaCoO(3) and LaFeO(3) materials were 264 +/- 41 kJ mol(-1) and 290 +/- 36 kJ mol(-1) respectively. Finally, a correlation between activation energies for cation diffusion in bulk and along grain boundaries in pure and substituted LaBO(3) materials (B = Cr, Fe, Co) is discussed.