Search

A fan-out circuit is a basic block for scaling up digital circuits for overcoming the limited driving capability of a single logic gate. It is particularly important for superconducting digital circuits as the driving power is typically weak for having high energy efficiency. Here, we design and fabricate a fan-out circuit for a superconducting nanowire cryotron (nTron) digital circuit. A classic splitter tree architecture is adopted. To transmit switching signal and avoid crosstalk among nTrons, we introduced an “R–L–R” interface circuit. Experimentally, a two-stage splitter tree of a fan-out number of four was demonstrated. Correct operation was observed with a minimum bit error rate (BER) of 10−6. The bias margin was 10% at BER of 10−4. The average time jitter was 82 ps. Moreover, crosstalk was not observed. Based on these results, we envision that the fan-out circuit can be used in future development of superconducting-nanowire-based circuits.

Multilayer superconducting nanowire single-photon detectors (SNSPDs) have exhibited several advantages, such as increased detection efficiency, reduced polarization sensitivity, and scaling up to large arrays. However, monolithic fabrication of such multilayer devices is challenging. In this work, a hybrid integration method has been introduced by etching SNSPDs into the membrane microchips, followed by the pick and place transferring process. This method has been verified by stacking two SNSPDs orthogonally. Both detectors show near saturated detection efficiencies and low timing jitters. Furthermore, thermal coupling effects have been observed between the two SNSPDs. The photon detection pulses from either detector can trigger the other one almost deterministically with a latency of several nanoseconds. This method offers a flexible way to fabricate multilayer SNSPDs or integrate them with other heterogeneous devices.

Photon number resolving (PNR) is an important capacity for detectors working in quantum and classical applications. Although a conventional superconducting nanowire single-photon detector (SNSPD) is not a PNR detector, by arranging nanowires in a series array and multiplexing photons over space, such series PNR-SNSPD can gain quasi-PNR capacity. However, the accuracy and maximum resolved photon number are both limited by the signal-to-noise (SNR) ratio of the output pulses. Here, we introduce a matched filter, which is an optimal filter in terms of SNR for SNSPD pulses. Experimentally, compared to conventional readout using a room-temperature amplifier, the normalized spacing between pulse amplitudes from adjacent photon number detections increased by a maximum factor of 2.1 after the matched filter. Combining with a cryogenic amplifier to increase SNR further, such spacing increased by a maximum factor of 5.3. In contrast to a low pass filter, the matched filter gave better SNRs while maintaining good timing jitters. Minimum timing jitter of 55 ps was obtained experimentally. Our results suggest that the matched filter is a useful tool for improving the performance of the series PNR-SNSPD and the maximum resolved photon number can be expected to reach 65 or even large.