Search

A model is proposed to determine the sediment transport rate generated by the combined action of sea waves and tidal currents, the latter being modelled as a sequence of steady currents because of the large values of the Keulegan-Carpenter number of the tidal flows, which allow to neglect inertial effects in their modelling. The hydrodynamic module solves Reynolds-averaged momentum equations by introducing a two-equation turbulence model, which considers also the flow in the region closest to the sea bottom and enforces the no-slip condition and the vanishing of the turbulent kinetic energy at the bottom without the need to assume the existence of a logarithmic velocity profile and to fix the normal derivative of the turbulent kinetic energy close to the sea bed. Hence, the evaluation of the velocity profile in the near-bed region turns out to be accurate. The sediment transport module determines the sediment concentration and sediment transport for a mixture of non-cohesive and cohesive sediments. To validate the model, its predictions are compared with laboratory measurements and field data collected over rippled beds at two different tidal estuaries. Then, results are obtained for values of the parameters chosen to mimic a site close to Punta Umbría (Huelva, Spain) and considering different hydrodynamic conditions and different sediment mixtures. The influence of the waves on the suspended sediment concentration is lower for the cohesive fraction than for the non-cohesive fraction. For all the sediment mixtures, it turns out that the cohesive fraction is well mixed over the whole water depth, meanwhile the concentration of the non-cohesive fraction has significant values only near the bottom, thus showing that an accurate description of turbulence dynamics in the buffer layer and viscous sublayer (if it exists) is important to quantify the sediment transport rate. • Sediment transport module that reproduces the concentration of cohesive fraction is presented. • Tidal current is modelled as a sequence of steady-currents due to the large values of the Keulegan-Carpenter number. • Menter's turbulence model to predict the turbulence structure both in the wave bottom boundary layer and in the core region. • Turbulence dynamics description in the buffer layer and viscous sublayer is important to quantify the sediment transport. • Applicable to any type of sediment mixture. [ABSTRACT FROM AUTHOR]

River gauging stations are often located upriver of tidal propagation where sediment transport processes and storage are impacted by widely varying ratios of marine to freshwater influence. These impacts are not yet thoroughly understood. Therefore, sediment fluxes measured at these stations may not be suitable for predicting changes to coastal morphology. To characterize sediment transport dynamics in this understudied zone, flow velocity, salinity, and suspended-sediment properties (concentration, size, and settling velocity) were measured within the tidal Sông Hậu distributary of the lower Mekong River, Vietnam. Fine-sediment aggregation, settling, and trapping rates were promoted by seasonal and tidal fluctuations in near-bed shear stress as well as the intermittent presence of a salt wedge and estuary turbidity maximum. Beginning in the tidal river, fine-grained particles were aggregated in freshwater. Then, in the interface zone between the tidal river and estuary, impeded near-bed shear stress and particle flux convergence promoted settling and trapping. Finally, in the estuary, sediment retention was further encouraged by stratification and estuarine circulation which protected the bed against particle resuspension and enhanced particle aggregation. These patterns promote mud export (~1.7 t s −1 ) from the entire study area in the high-discharge season when fluvial processes dominate and mud import (~0.25 t s −1 ) into the estuary and interface zone in the low-discharge season when estuarine processes dominate. Within the lower region of the distributaries, morphological change in the form of channel abandonment was found to be promoted within minor distributaries by feedbacks between channel depth, vertical mixing, and aggregate trapping. In effect, this field study sheds light on the sediment trapping capabilities of the tidal river – estuary interface zone, a relatively understudied region upstream of where traditional concepts place sites of deposition, and predicts how fine-sediment dynamics and morphology of large tropical deltas such as the Mekong will respond to changing fluvial and marine influences in the future. [ABSTRACT FROM AUTHOR]

Fifteen monthly field surveys were conducted from September 2012 to November 2013 at ten representative stations along a cross-shore profile, covering the entire tidal flat. Results indicate that tidal currents significantly affect bed level variations over bare flats, while subsurface processes (e.g., soil subsidence and expansion) are likely to play an important role in changing the bed level of the upper intertidal flat where salt marshes are present. The cross-shore profile shows a clear double-convex shape, and different geomorphic zones display distinctive variation. Above the mean high water level (MHWL), the bed level is generally stable. The region around the MHWL, where the upper convex point is present, is a location of high sedimentation due to the weaker hydrodynamic conditions and the settling and scour lag effects, it keeps growing with the increase of inundation frequency. A concave point occurs in the middle part of the intertidal flat, showing considerable erosion. Near the mean low water level (MLWL), the lower convex point is elevated due to the long-shore tidal current and associated sediment transport (the flood dominated transport during summer exceeds the ebb dominated transport during winter, hence the net effect favors sedimentation). Further seawards, the area below the MLWL is strongly eroded. The cross-shore profile follows a “stable-accretional-erosional-accretional-erosional” sequence. Overall, the measurements indicate that the interplay among vegetation, hydrodynamics and sediment transport is critical in shaping the cross-shore morphology of the intertidal flats along the Jiangsu coast of China. [ABSTRACT FROM AUTHOR]

Morphological evolution of large river deltas is highly vulnerable to extreme storm events due to insufficient sediment supply. As an abandoned delta lobe, the coasts along the northern Yellow River Delta (YRD) and Gudong Oil Field have recently suffered serious erosion due to extreme storm events and become increasingly vulnerable. In this study, a well validated and tested Delft 3D module by the observing hydrodynamic and sediment data to simulate the hydrodynamics and seabed erosion during a storm event in the littoral area of YRD. Observed wave, current and sediment data under both fair-weather and storm conditions were collected in the study area and used to validate the model. The results indicated that the model can reproduce well the hydrodynamic and sediment transport processes. A series of numerical experiments were carried out to examine the hydrodynamic changes and sediment transports. In the numerical experiment of normal condition, there is hardly any sediment transport off the YRD. The numerical experiment of storm condition showed that storms enhanced tidal residual currents, weakened tidal shear front, and significant wave heights up to 2 m, considerably intensified the sediment resuspension and dispersal. The local sediment resuspension due to the increased wave-induced bottom stress promoted the sediment plume to expand to the central area of Laizhou Bay, which seemed to provide sediment source for offshore and southward transport. During the storm, the active nearshore sediment resuspension provided sediment source for offshore and southward transport. The intensive dynamics and sediment transport under storm conditions caused significant changes in seabed erosion and siltation. The main erosion occurred off the Gudong and northern YRD, while the main siltation appeared in the central area of Laizhou Bay. No significant recovery after a storm and frequent strong winds have an accumulative effect on the erosion, which is very likely to dominate the erosive states of the YRD coast in the future. • Storm-induced energetic hydrodynamic forces intensify sediment resuspension and dispersal significantly. • Wave-induced bottom stress promotes sediment plume and enhances local resuspension. • Storms increase suspended sediment concentration and offshore sediment transport. • Storm-induced accumulative effect on seabed scour tends to cause long-term erosion. [ABSTRACT FROM AUTHOR]

Past major changes in sea level have had a significant influence on global- and shelf sea tidal dynamics. Some of these changes are preserved in sedimentary records from the shelf seas, and so appropriate proxy data have the potential to constrain tidal model outputs over the recent geological past. Tidal models which simulate the evolution of tide-dependent parameters over geological timescales are fundamental to understanding the response of the tides to sea-level rise and climate change. This study explores a potential new sedimentary proxy for validating past shelf sea tidal dynamics, interrogating the relationship between tidally-modulated bed shear stress and seabed sediment grain size at discrete sediment core locations over the northwest European shelf seas. Radiocarbon-dated sediment grain size profiles were generated for four British Geological Survey UK shelf sediment vibrocores, spanning a range of physical environments. Changes in observed sediment grain size through time were compared with simulated changes in tidal-induced bed shear through time, using temporal and spatial outputs from the most recently developed palaeotidal model of the Northwest European shelf seas. Although a positive correlation between observed grain size and simulated bed shear stress was observed at three of the four sediment cores sites, no robust relationship could be quantified. The palaeotidal model output failed to resolve the details of the actual sediment dynamics, since only tidal-induced bed shear stresses were considered. Wave processes were neglected, and the model was not sensitive enough to constrain simulated past tidal conditions at point locations; rather it is suitable for examining general trends. There remains a need to develop new proxies for past shelf sea hydrodynamic conditions which can be used to constrain numerical model output of tidal currents at regional scales. • We explore a new proxy for validating models of past shelf sea tidal dynamics. • Age-constrained seabed sediment data for 5 marine cores for NW Europe presented. • Evolutions of median grain size compared with simulated tidal-induced bed stress. • General trends in sediment grain size and simulated bed shear stress were observed. • The tidal model did not fully resolve the intricacies of observed sediment dynamics. [ABSTRACT FROM AUTHOR]