Search

The flexural buckling behaviour and resistances of press-braked stainless steel Z-section columns are investigated in this paper, based on experiments and numerical modelling. An experimental investigation was conducted on two press-braked stainless steel Z-sections and included material testing, initial geometric imperfection measurements and twelve fixed-ended column tests. Minor-axis flexural buckling was observed for all press-braked stainless steel Z-section column specimens upon testing. The key obtained fixed-ended column test results, including failure loads, load–deformation histories and failure modes, were fully reported. Following the experimental investigation, a numerical investigation was performed, with finite element models developed to validate against the fixed-ended column test results and then used to conduct parametric studies to generate additional numerical data. On the basis of the test and numerical data, the relevant buckling curves, as specified in the European code, American specification and Australian/New Zealand standard, were evaluated and shown to provide accurate and consistent flexural buckling resistance predictions for press-braked stainless steel Z-section columns. • The flexural buckling behaviour of press-braked stainless steel Z-section columns was studied. • Twelve fixed-ended column tests were conducted. • FE models were developed to validate against the test results and then used to perform parametric studies. • The codified buckling curves were assessed, showing good design accuracy and consistency. [ABSTRACT FROM AUTHOR]

• 1. The local–flexural interactive buckling of press-braked stainless steel slender channel section columns is studied. • 2. Ten pin-ended column tests are conducted. • 3. FE models are developed and validated against the test results and then adopted to conduct parametric studies. • 4. The codified design rules are assessed and shown to yield inaccurate interactive buckling resistance predictions. • 5. A new design method is proposed, showing improved design accuracy. The present paper reports experimental and numerical studies of the local–flexural interactive buckling behaviour and resistance of press-braked stainless steel slender channel section columns. A testing programme was firstly performed, including tensile coupon tests, initial geometric imperfection measurements and ten pin-ended column tests. The pin-ended column test setup, procedures and results were fully reported and analysed. The progression of local buckling and flexural buckling was discussed in detail. Following the testing programme, a numerical modelling programme was conducted, where finite element models were developed to replicate the test responses and then employed to perform parametric studies to generate further numerical data over a wide range of cross-section dimensions and member effective lengths. The obtained test and numerical data were employed to assess the accuracy of the relevant design rules for press-braked stainless steel slender channel section columns, as set out in the European code, American specification and Australian/New Zealand standard. The assessment results revealed that the European code leads to conservative and scattered interactive buckling resistance predictions, while the American specification and Australian/New Zealand standard result in many unsafe and scattered interactive buckling resistance predictions. A new design approach was then developed, based on the Eurocode column buckling curve and the continuous strength method, and shown to lead to accurate, consistent and safe interactive buckling resistance predictions for press-braked stainless steel slender channel section columns. The reliability of the new design approach was confirmed by means of statical analyses. Besides, the relevant design rules for press-braked carbon steel slender channel section columns, as given in the North American specification, were assessed, and shown to result in unsafe though consistent interactive buckling resistance predictions, when used for their stainless steel counterparts. [ABSTRACT FROM AUTHOR]