Search

The flexural buckling behaviour and resistances of press-braked stainless steel Z-section columns are investigated in this paper, based on experiments and numerical modelling. An experimental investigation was conducted on two press-braked stainless steel Z-sections and included material testing, initial geometric imperfection measurements and twelve fixed-ended column tests. Minor-axis flexural buckling was observed for all press-braked stainless steel Z-section column specimens upon testing. The key obtained fixed-ended column test results, including failure loads, load–deformation histories and failure modes, were fully reported. Following the experimental investigation, a numerical investigation was performed, with finite element models developed to validate against the fixed-ended column test results and then used to conduct parametric studies to generate additional numerical data. On the basis of the test and numerical data, the relevant buckling curves, as specified in the European code, American specification and Australian/New Zealand standard, were evaluated and shown to provide accurate and consistent flexural buckling resistance predictions for press-braked stainless steel Z-section columns. • The flexural buckling behaviour of press-braked stainless steel Z-section columns was studied. • Twelve fixed-ended column tests were conducted. • FE models were developed to validate against the test results and then used to perform parametric studies. • The codified buckling curves were assessed, showing good design accuracy and consistency. [ABSTRACT FROM AUTHOR]

• The flexural-torsional buckling behaviour of fixed-ended press-braked S690 high strength steel angle columns was studied. • Twelve compression tests of fixed-ended press-braked S690 high strength steel angle columns were carried out. • FE models were developed and validated against the test results, and then adopted for parametric studies. • The accuracy of the codified design rules and a new DSM-based design approach was evaluated. The flexural-torsional buckling behaviour and resistances of fixed-ended press-braked S690 high strength steel angle section columns have been studied based on testing and numerical modelling, and reported in this paper. A testing programme, employing four different equal-leg angle section sizes, was firstly conducted, and comprised material tensile coupon tests, initial global and torsional geometric imperfection measurements and twelve fixed-ended column tests. The column test setup and procedures were thoroughly presented, and the key obtained test results, including the failure loads and deformations at the failure loads, load–end shortening curves, load–mid-height torsional rotation curves and failure modes, were fully reported and discussed. This was followed by a numerical modelling programme, where finite element models were initially developed to simulate the experimental responses and then adopted to perform parametric studies to generate further numerical data over a wide range of cross-section dimensions and member lengths. The obtained test and numerical data were then used to evaluate the accuracy of the relevant codified design rules, given in the European code, North American specification and Australian/New Zealand standard, and a recently proposed DSM-based design approach. The results of the evaluation revealed that all the codified design rules yield excessively conservative and scattered flexural-torsional buckling resistance predictions for fixed-ended press-braked S690 high strength steel angle section columns, while the DSM-based design approach leads to substantially improved resistance predictions, owing to the rational consideration of the length-dependent characteristic of flexural-torsional buckling and the interaction of flexural-torsional buckling with minor-axis flexural buckling. [ABSTRACT FROM AUTHOR]