Back to Search
Start Over
Wall-impinging laminar premixed n-dodecane flames under autoignitive conditions
- Publication Year :
- 2018
-
Abstract
- © 2018 The Combustion Institute. Laminar one-dimensional (1D) flames in a stagnation flow stabilised at a wall are used to study flame-wall interaction under diesel engine conditions. The thermochemical conditions correspond to that of the Engine Combustion Network (ECN) Spray A reference case. A range of inflow velocities is considered, where the lowest inflow velocity is chosen such that the flame is detached from the inlet. The presence of a wall is shown to have a significant impact on the flame structure and emission formation. The 1D flame and homogeneous reactor results exhibit two distinct reaction zones due to low- and high-temperature chemistry (LTC and HTC, respectively). The burner-stabilised flames are overall dominated by autoignition for all inflow velocities. For the impinging jet flames, the response of the LTC reaction zone follows closely that of the burner-stabilised flames up to relatively high inflow velocities. The HTC reaction zone, however, deviates strongly from the burner-stabilised flames, already at low inflow velocities and quenches at high inflow velocities. A budget analysis revealed a strong contribution from diffusion in the HTC reaction zone, resulting in an increasing importance of deflagrative combustion as opposed to autoignition. This trend was attributed to enhanced strain rates at higher inlet velocity leading to higher gradients. Wall heat transfer was also investigated. The highest wall heat transfer rates were observed for mixtures between . Φ=1.0 and Φ=1.5 and for inlet velocities just below the quenching limit. This was attributed jointly to the higher peak product temperatures for these mixtures and to their enhanced resilience to quenching under strain which leads to higher temperature gradients at the wall just before quenching. NO formation was studied. The highest NO formation was observed near . Φ=1.0, though the response to strain rate was different for stoichiometric and rich mixtures, which was attributed to dif
Details
- Database :
- OAIster
- Publication Type :
- Electronic Resource
- Accession number :
- edsoai.on1089650317
- Document Type :
- Electronic Resource