Preparation and properties of bacterial cellulose/ graphene oxide composite films using dyeing method

In this study, bacterial cellulose (BC) hydrogels were cultured from a kombucha SCOBY starter. The scanning electron microscopy (SEM) results indicated that the dried BC exhibited an interpenetrating fibrous mat. The BC films harvested for 5, 10, and 15 days were 15-19, 14.4-24, and 30-31 pm thick, respectively. Then, BC/graphene oxide (GO) composite films were prepared via the exhaust dyeing method. GO sheets penetrated the BC matrix, resulting in the formation of a BC/GO composite, as revealed by the SEM analysis results. The mechanical properties of the composite films were investigated. Compared with virgin BC, the tensile strength of the composite films was higher, while the %E at break was lower, resulting in a significant increase in the Young's modulus. The X-ray diffraction results indicated that an increase in the dyeing time (0.5-2 h) gradually induced cellulose crystalline conformation, which in turn affected the swelling ability, mechanical properties, and electrical properties of the BC/GO composite films. After the reduction of GO to reduced GO (rGO), flexible conductive BC/rGO films were obtained, as confirmed by their resistivity values. Thus, flexible conductive composite films with excellent mechanical properties were successfully fabricated. KEYWORDS bacterial cellulose/graphene oxide composites, dyeing method, mechanical and electrical properties
1 | INTRODUCTION Polymer nanocomposites such as synthetic polymer/ graphene nanocomposites and biopolymer-based nanocomposites such as natural rubber/graphene, synthetic rubber/ bacterial cellulose (BC), nanocellulose aerogel/graphene, BC/Ti[O.sub.2,] and BC/nanoclay composites have [...]