Thermodynamic and kinetic analyses and experimental verification of tellurium and bismuth recovery from bismuth telluride waste by selective sulfidation-vacuum volatilization

The recovery of tellurium and bismuth from bismuth telluride waste is of great significance in improving the utilization levels of renewable resources, protecting the ecological environment and alleviating the problem of resource shortages. In this paper, tellurium and bismuth were recovered from bismuth telluride waste by selective sulfidation–vacuum volatilization. The Gibbs free energy, phase diagram and thermodynamic equilibrium diagram for the core reaction were calculated and analyzed to determine the possible reactions and the conditions required for the stability of bismuth telluride during the sulfidation process. After calculating the saturated vapor pressures, it was concluded that tellurium and bismuth sulfide could be separated by vacuum volatilization. The thermogravimetric analyses and differential scanning calorimetry were then used to analyze the reaction between bismuth telluride and sulfur. The results indicated that the temperature range for the sulfidation reaction should be 491–620 K. The volatilization temperature of tellurium should be greater than 695 K. The evaporation kinetics for tellurium and bismuth sulfide showed that the evaporation rate of tellurium was much higher than that of bismuth sulfide. Furthermore, experiments were conducted to verify the reliability of the theoretical analysis, and these were in good agreement with the thermodynamic and kinetic results. The direct yields of tellurium and bismuth were 99.65% and 99.49%, respectively. These results confirmed that the selective sulfidation-vacuum volatilization method is a feasible alternative for recovery of tellurium and bismuth from bismuth telluride waste.