Aeroelastic investigation of conventional fixed wings and bio-inspired flapping wings by analysis and experiment

In this thesis, the structure and aeroelastic design, analysis and optimization of conventional fixed wing is firstly addressed. Based on the study results of conventional fixed wing, the study then focuses on the more complicated aerodynamics and aeroelasticity of flapping wing Micro Air Vehicles (MAV). A Finite Element (FE) model of a composite aircraft wing is firstly used as case study for the aeroelasticity of conventional fixed wing. A MATLAB-NASTRAN interfaced optimization platform is created to explore the optimal design of the wing. Optimizations using the developed platform show that 13% of weight reduction can be achieved when the optimization objective is set to minimize wing weight; and 18.5% of flutter speed increase can be achieved when aeroelastic tailoring of composite laminate layups is carried out. The study results further showed that the most sensitive part of the wing for aeroelastic tailoring is near the engine location, which contributes to the majority of flutter speed increment for optimization. In order to facilitate the structural design of non-circular cross section fuselage of Blended-Wing-Body (BWB) aircraft, an analytical model of 2D non-circular cross section is developed, which provides efficient design and optimization of the fuselage structure without referring to FE models. A case study based on a typical BWB fuselage using the developed model shows that by optimizing the fuselage structure, significant weight saving (17%) can be achieved. In comparison with the conventional fixed wing, insect flapping wings demonstrate more complicated aerodynamic and aeroelastic phenomena. A semi-empirical quasi-steady aerodynamic model is firstly developed to model the unsteady aerodynamic force of flapping wing. Based on this model, the aerodynamic efficiency of a Flapping Wing Rotor (FWR) MAV is investigated. The results show that the optimal wing kinematics of the FWR falls into a narrow range of design parameters governed by the dimensionless Strouhal number (St). Furthermore, the results show that the passive rotational of the FWR converges to an equilibrium state of high aerodynamic efficiency, which is a desirable feature for MAV applications. Next, the aerodynamic lift coefficient and efficiency of the FWR are calculated and compared with typical insect-like flapping wings and rotary wing. The results show that the aerodynamic efficiency of FWR in typical wing kinematics is higher than insect-like flapping wings, but slightly lower than the conventional rotary wing; the FWR aerodynamic lift coefficient (CL) surpassed the other wings significantly. Based on the numerical results, the study then continued to experimental investigations of the FWR. A prototype FWR model of weight 2.6g is mounted on a load cell to measure the instantaneous lift production. The kinematics of the wing is captured using high speed camera. Aeroelastic twist of the wing is measured using the resulting wing motion. Analyses by CFD and the quasi-steady aerodynamic model is then carried out and compared with experimental results. The study revealed that passive twist of the FWR wing due to aeroelastic effects forms desirable variations of wing Angle of Attack (AoA), which improves the aerodynamic performance of FWR. The results of the thesis provide guidance for structural, aerodynamic and aeroelastic design, analysis and optimization of conventional fixed wing, as well as bio-inspired flapping wing MAVs.