A novel silicon heterojunction IBC process flow using partial etching of doped a-Si:H to switch from hole contact to electron contact in situ with efficiencies close to 23%

We present a novel process sequence to simplify the rear-side patterning of the silicon heterojunction interdigitated back contact (HJ IBC) cells. In this approach, interdigitated strips of a-Si:H (i/p(+)) hole contact and a-Si:H (i/n(+)) electron contact are achieved by partially etching a blanket a-Si:H (i/p(+)) stack through an SiOx hard mask to remove only the p(+) a-Si:H layer and replace it with an n(+) a-Si:H layer, thereby switching from a hole contact to an electron contact in situ, without having to remove the entire passivation. This eliminates the ex situ wet clean after dry etching and also prevents re-exposure of the crystalline silicon surface during rear-side processing. Using a well-controlled process, high-quality passivation is maintained throughout the rear-side process sequence leading to high open-circuit voltages (V-OC). A slightly higher contact resistance at the electron contact leads to a slightly higher fill factor (FF) loss due to series resistance for cells from the partial etch route, but the FF loss due to J(02)-type recombination is lower, compared with reference cells. As a result, the best cell from the partial etch route has an efficiency of 22.9% and a V-OC of 729 mV, nearly identical to the best reference cell, demonstrating that the developed partial etch process can be successfully implemented to achieve cell performance comparable with reference, but with a simpler, cheaper, and faster process sequence. European Commission's Horizon 2020Framework Programme, Grant/Award Num-ber: 727523; IIAP‐SiPV; Kuwait Foundationfor the Advancement of Sciences, Grant/Award Number: P115‐15EE‐01