Laboratory Tests to Optimize the Milking Machine Settings with Air Inlet Teat Cups for Sheep and Goats

Milking machine design and performance are directly related to the milkability of sheep and goats, with the aim of milking quickly, completely and gently. This leads to an increase in the milk yield with improved quality, and the maintenance of healthy udders. The aim of this study was to carry out laboratory tests to determine the optimal level of vacuum, pulsation rate and pulsation ratio of new milking machines in high and low milk lines for sheep and goats. This study was conducted at the Department of Research and Development, Siliconform, Germany. For this purpose, different levels of vacuum (32, 34, 36, 38 and 40 kPa), milk jet (2, 2.5, 3 and 4 mm), milk line (high line and low line) and pulsation ratio (50:50 and 60:40) were used. First minute water flow (1st WF/kg) was used as an indicator for assessing the best combination in the milking machine. In addition, the cyclic vacuum fluctuation was measured in the inner chamber of the teat cup during the 1st WF/kg with the aid of a Vacuscope device. Statistical analysis was conducted using the mixed procedure in SAS. Our results show that the vacuum level, the milk jet and the pulsation ratio had a significant influence (p < 0.05) on the 1st WF/kg in the two milking machines for goats and sheep. In conclusion, the ideal conditions for milking goats with air inlet teat cups in the milking machine are a vacuum level of 36–38 kPa (low line) and 38–40 kPa (high line), a pulsation rate of 90 cycles/min and a pulsation ratio of 60:40, while the ideal conditions in the sheep milking machines are a vacuum level of 35–36 kPa (low line) and 36–38 kPa (high line), a pulsation rate of 120 cycles/min and a pulsation ratio of 60:40 or 50:50.