Back to Search Start Over

On amplitude beam splitting of tender X-rays (2–8 keV photon energy) using conical diffraction from reflection gratings with laminar profile

Authors :
Werner Jark
Diane Eichert
Source :
Journal of Synchrotron Radiation. 23:91-97
Publication Year :
2016
Publisher :
International Union of Crystallography (IUCr), 2016.

Abstract

Conical diffraction is obtained when a radiation beam impinges onto a periodically ruled surface structure parallel or almost parallel to the ruling. In this condition the incident intensity is diffracted through an arc, away from the plane of incidence. The diffracted intensity thus lies on a cone, which leads to the name `conical diffraction'. In this configuration almost no part of the ruled structure will produce any shadowing effect for the incident or the diffracted beam. Then, compared with a grating in the classical orientation, relatively higher diffraction efficiencies will be observed for fewer diffraction orders. When the incident beam is perfectly parallel to the grooves of a rectangular grating profile, the symmetry of the setup causes diffraction of the intensity symmetrically around the plane of incidence. This situation was previously tested experimentally in the VUV spectral range for the amplitude beam splitting of a radiation beam with a photon energy of 25 eV. In this case the ideally expected beam splitting efficiency of about 80% for the diffraction into the two first orders was confirmed for the optimum combination of groove depth and angle of grazing incidence. The feasibility of the amplitude beam splitting for hard X-rays with 12 keV photon energy by use of the same concept was theoretically confirmed. However, no related experimental data are presented yet, not even for lower energy soft X-rays. The present study reports the first experimental data for the conical diffraction from a rectangular grating profile in the tender X-ray range for photon energies of 4 keV and 6 keV. The expected symmetries are observed. The maximum absolute efficiency for beam splitting was measured to be only about 30%. As the reflectivity of the grating coating at the corresponding angle of grazing incidence was found to be only of the order of 50%, the relative beam splitting efficiency was thus 60%. This is to be compared also here with an ideally expected relative efficiency of 80%. It is predicted that a beam splitting efficiency exceeding 50% should be possible by use of more appropriate materials.

Details

ISSN :
16005775
Volume :
23
Database :
OpenAIRE
Journal :
Journal of Synchrotron Radiation
Accession number :
edsair.doi.dedup.....14f30563ad7ddc562751879b25bfc439
Full Text :
https://doi.org/10.1107/s1600577515019761