Functionally Gradient (YSZ-20%Al2O3)-SUS422 Composites

Functionally gradient materials (FGMs) were prepared by mixing 5 layers comprised of different ratios of (YSZ-20%Al2O3) and 422 stainless (SUS422) powders, followed by hot pressing for densification. Two design concepts were proposed: One as a FGM with a monotonic change of the CTE (coefficient of thermal expansion) for each layer, and is designated as the monotonic mode, and the other was a FGM with a change of CTE that is not monotonic for each layer, and is termed the non-monotonic mode. The FGM with a monotonic CTE mode cracked at the ceramic surface after it was removed from the hot pressing furnace. In contrast, the FGM with a non-monotonic CTE mode survived after hot pressing. Based on ABAQUS simulation results, a non-monotonic change in CTE resulted in a decrease of residual stress on the ceramic side but an increase inside the metal-rich layers of the FGMs. The induced change in the stress distribution inside the FGMs was compromised by the deformation of the metal-rich ingredient (SUS422) in the FGM. Thermal shock tests of FGMs were performed between 25°C and 600°C. The non-monotonic FGM endured up to 100 thermal cycles with only slight bending, and was free of delamination and cracking. The use of composition-adjusted layers to manipulate thermal expansion coefficients of each layer greatly changed the stress contour of the FGM. It is noted that a modified functional-gradient FGM can be fabricated with a hard ceramic surface on one side to resist high temperature, and a ductile metallic surface on the other side to provide toughness.