Performance improvement of diamondlike carbon membrane masks for electron projection lithography

This article describes the fabrication of eight-inch continuous membrane masks with a 15‐nm-thick support membrane for electron projection lithography (EPL). In order to develop an extremely thin support membrane with a tensional stress, two techniques were applied; one is a low pressure deposition process to improve the membrane bulk density, and the other is Si addition during the conventional carbon membrane deposition for improving the atomic distance mismatch between substrate and deposited film, and also to address the membrane volume strain cause by the rise in the tensional stress under the low pressure deposition condition. By using Si-additional techniques, an extremely thin membrane with a tensional stress was formed under the conditions of less than 0.5Pa chamber pressure. Long-term membrane stress stability of Si-added extremely thin membranes were particularly improved. It was less than 3MPa in elapsed times of 400h. The zero-loss electron transmittance for the fabricated 15‐nm-thick membran...