EUV source power and lifetime: the most critical issues for EUV lithography

Semiconductor chip manufacturers are expecting to use extreme ultraviolet (EUV) lithography for high volume manufacturing of DRAMs and ICs starting by the end of this decade. Among all the technologies and modules which have to be developed EUV sources at 13.5 nm are considered to be the most critical issue. Specifically the required output power of 115 W at the entrance of the illuminator system in combination with the required lifetimes of source components and collector optics make the source technology critical for EUV lithography. The present paper gives an update of the development status of EUV light sources at XTREME technologies, a joint venture of Lambda Physik AG, Goettingen, and Jenoptik LOS GmbH, Jena, Germany. Results on both laser produced plasma (LPP) and gas discharge produced plasma (GDPP), the two major technologies in EUV sources, are given. The LPP EUV sources use xenon-jet target systems and pulsed lasers with 500 W average power at up to 10 kHz developed at XTREME technologies. The maximum conversion efficiency from laser power into EUV in-band power is 1.0 % into 2p solid angle. 2.0 W EUV radiation is generated at 13.5 nm in 2p sr solid angle. The small source volume of < 0.3 mm diameter will allow large collection angles of 5 sr. The intermediate focus power is estimated to 1 W. Collector mirror lifetime tests showed 5 million pulses lifetime without debris mitigation. With debris mitigation in place lifetimes of more than 1 billion pulses are estimated. For the next generation of higher power EUV LPP sources a laser driver has been tested at 1.3 kW average laser power. This will lead to 5 W EUV power in intermediate focus. The GDPP EUV sources use the Z-pinch principle with efficient sliding discharge pre-ionization. Prototype commercial gas discharge sources with an EUV power of 35W in 2p sr were already delivered for integration into EUV microsteppers. These sources are equipped with a debris-filter which results in an optics lifetime exceeding 100 million discharges at 1 kHz repetition frequency. The same lifetime was achieved for the components of the discharge system itself. The progress in the development of high-power discharge sources resulted in an EUV power of 150 W in continuous operation at 4.5 kHz repetition rate by implementation of porous metal cooling technology. The EUV plasma has a FWHM-diameter of 0.5 mm and a FWHM-length of 1.5 mm. The intermediate focus power is calculated to be in the range of 15 W - 20 W, depending somewhat on the transmission of the optical path to the intermediate focus and on the etendue specification. The typical fluctuations of the EUV energy are standard deviation s