Experimental Study on the Influence of Tool Wear on the Cutting Process of Ti6Al4V

The tool wear is a big problem when machining titanium alloy. If the tool wear law is not mastered well, the machining quality will not be guaranteed. In this paper, the theoretical model of the tool is established, which can understand the spatial dimension model of the tool. At the same time, the tool wear experiment of the most commonly used tool for titanium alloy machining in the manufacturing industry is carried out, and the influence of the tool cutting wear on the cutting process is studied. The experimental analysis shows that the tool produces the chip extrusion stripe when it is worn in the initial stage and normal stage, which is perpendicular to the chip in the outflow direction, the fringe protrusions are parallel, and the contact surface of the chips is relatively flat. When the tool reaches the stage of severe wear, the protrusion stripes perpendicular to the outflow direction of the chips are fluffy, and the stripes are twisted. With the continuous cutting wear time of the tool becoming longer, the cutting force, the residual stress of the machined surface layer and the cutting temperature obtained in each stage gradually increase; with the tool reaching the stage of severe wear, the protrusion stripes are fluffy, and the stripes are twisted The tool wear time gradually increases, and the cutting surface roughness obtained by continuous tool wear decreases first and then increases; the surface quality of the tool in the initial wear stage is relatively obvious and the edge burr is large, while in the normal wear stage, the surface quality of the tool is gradually gentle, but when the tool reaches the severe wear stage, the surface quality of the tool begins to be processed Sharp drop and thick edge burr.