Back to Search
Start Over
Research on Bursting Behavior in Hydroforming of Double-Cone Tube
- Source :
- Advanced Materials Research. :678-685
- Publication Year :
- 2010
- Publisher :
- Trans Tech Publications, Ltd., 2010.
-
Abstract
- Firstly, the geometry condition of useful wrinkles during the hydroforming of double-cone tube was given. Then the stress condition of useful wrinkles was given by formula between the parameters of wrinkles shape at the end of axial feeding and internal pressure, hoop stress and axial stress. The analytical results were compared with the FEM analysis and experiments results. The results show that the useful wrinkles must meet both the geometry condition and the stress condition. The geometry condition of useful wrinkles is that the area of arbitrary length of wrinkles is a little smaller than the area of corresponding die cavity. The stress condition of useful wrinkles is that shape parameter G is not smaller than the radius R at the top of middle wrinkle. That means the increment of thickness strain dεt is positive and no thickness thinning will occur during the calibration. When the wrinkles didn’t match geometry condition, the dead wrinkles or bursting will take place. And when the wrinkles didn’t match stress condition, the bursting at top of middle wrinkle will occur during the calibration.
Details
- ISSN :
- 16628985
- Database :
- OpenAIRE
- Journal :
- Advanced Materials Research
- Accession number :
- edsair.doi...........69a4e15270d55f2e240551ae3d4c8ebb