Salivary fluoride concentrations following toothbrushing with experimental toothpaste containing S-PRG filler

Background: Single-blind, nine case comparative studies were conducted to evaluate salivary fluoride concentrations following toothbrushing using experimental toothpastes containing Surface Pre-Reacted Glass-ionomer (S-PRG) fillers. Preliminary tests were conducted in order to determine the volume of usage as well as the concentrations (wt%) of S-PRG filler. Based on the results given these experiments, we compared the salivary fluoride concentrations following toothbrushing with 0.5 g of 4 different types of toothpastes: 5 wt % S-PRG filler, 1400 ppm F AmF (amine fluoride), 1500 ppm F NaF (sodium fluoride), and MFP (monofluorophosphate) containing toothpaste. Methods: Of the 12 participants, 7 participated in the preliminary study and 8 participated in the main study. All participants brushed their teeth using the scrubbing method for 2 minutes. At first 1.0 and 0.5 g of 20 wt % S-PRG filler toothpastes were used to compare, then followed by 0.5 g of 0 (control), 1, and 5 wt % S-PRG toothpastes, respectively. ThepParticipants spat out once and rinsed with 15 mL of distilled water for 5 seconds. Saliva was collected for 3 minutes each at different time intervals of 0 (baseline), 5, 10, 15, 30, 60, 120, and 180 minutes (min) after the rinsing. Fluoride concentrations were determined using a fluoride-electrode, and the area under the curve (AUC: ppm‧min) of each toothpaste was calculated as the salivary fluoride retention. The main study was then conducted to evaluate the salivary fluoride concentrations as well as the AUC value using 0.5 g of 5 wt % S-PRG filler toothpaste, followed by NaF, MFP, and AmF toothpaste. Results: Since there were no statistical differences between using 1.0 g and 0.5 g of 20 wt % S-PRG toothpastes in salivary fluoride concentrations as well as the AUC value throughout the 180 min measurement, the volume was set as 0.5 g for the following studies. Concentrations of 5 and 20 wt % S-PRG toothpastes retained 0.09 ppm F or more in saliva even after 180 min. No statistical differences were seen in the salivary fluoride concentrations at any time intervals as well as the AUC value between 5 and 20 wt % S-PRG toothpastes. Based on these results, the concentration of 5 wt % S-PRG toothpaste was used for the main comparative study. MFP toothpaste resulted in by far the lowest salivary fluoride concentrations (0.06 ppm F at 180 min) and the AUC value (24.6 ppm‧min), whereas 5 wt % S-PRG toothpaste (0.15 ppm F at 180 min, 92.3 ppm‧min) displayed retention on par with AmF toothpaste which appeared to result in higher values (0.17 ppm F at 180 min, 103 ppm‧min), compared to NaF toothpaste (0.12 ppm F at 180 min, 49.3 ppm‧min). Conclusions: The salivary fluoride concentrations following toothbrushing with 0.5 g of 5 wt % S-PRG filler containing toothpaste showed retention similar to the best performing 1400 ppm F AmF toothpaste even 180 min after toothbrushing.