Investigation on the effect of Sn grain number and orientation on the low cycle fatigue deformation behavior of SnAgCu/Cu solder joints

Generally, lead-free solder joints in electronic device are near single or multi crystalline rather than poly crystalline, and the fatigue failure behavior of solder joints is greatly influenced by the solder joint thickness. In this study, the grain number and orientation of solder joints with four solder thicknesses (0.1, 0.2, 0.3, 0.6 mm) were analyzed and the effect of that on the low cycle fatigue deformation behavior of solder joint was also investigated. The orientation analysis was conducted by means of electron backscatter diffraction and the fatigue test was performed under room temperature with a fixed frequency of 1 Hz. Moreover, the deformation evolution on side surface of solder joint was observed by utilizing scanning electron microscope. It is shown that there is no preferred solidification orientation for lead-free solder joints. However, grains in one joint seem to have a similar orientation when the solder thickness is