Rapid Prediction of Soil Water Retention using Mid Infrared Spectroscopy

Soil‐water properties vary widely with soil composition and texture, but measurements are often time consuming and expensive to determine using traditional laboratory methods. Mid‐infrared (MIR) spectroscopy is sensitive to soil composition, allowing multivariate calibrations to be derived between volumetric soil water retention and MIR spectra. Mid‐infrared partial least squares (PLS) models can be derived from the spectra of soils and reference data, and can be used to predict the water retention solely from the MIR spectra of unknown samples. Regressions between laboratory‐determined volumetric water retentions, θv, at matric suctions from 1 to 1500 kPa and values predicted by MIR PLS analysis are presented for a broad variety of surface soils from southern Australia. Cross‐validation produced coefficient of determination values ranging from 0.67 to 0.87 and standard error of cross‐validation in the range 4.1 to 3.2. Prediction robustness was tested using an independent set of samples for values of θvat field capacity (10‐kPa suction) and permanent wilting point (1500‐kPa suction). The prediction standard error for the test set was higher than for cross‐validation. This was attributed to a mismatch between spectra for the test set and those of the calibration samples, resulting in a reduced ability of the calibration samples to model the test set spectra. The MIR PLS prediction method performed at least as well as some pedotransfer functions and was shown to be a rapid and inexpensive method for the prediction of volumetric soil moisture content for a range of soil types at a range of matric suctions.